Early detection and surveillance of severe acute respiratory syndrome-coronavirus 2 (SARS-CoV-2) virus are key pre-requisites for the effective control of coronavirus disease (COVID-19). So far, sewage testing has been increasingly employed as an alternative surveillance tool for this disease. However, sample site characteristics impact the testing results and should be addressed in the early use stage of this emerging tool. In this study, we implemented the sewage testing for SARS-CoV-2 virus across sampling sites with different sewage system characteristics. We first validated a testing method using “positive” samples from a hospital treating COVID-19 patients. This method was used to test 107 sewage samples collected during the third wave of the COVID-19 outbreak in Hong Kong (from June 8 to September 29, 2020), covering sampling sites associated with a COVID-19 hospital, public housing estates, and conventional sewage treatment facilities. The highest viral titer of 1975 copy/mL in sewage was observed in a sample collected from the isolation ward of the COVID-19 hospital. Sewage sampling at individual buildings detected the virus 2 days before the first cases were identified. Sequencing of the detected viral fragment confirmed an identical nucleotide sequence to that of the SARS-CoV-2 isolated from human samples. The virus was also detected in sewage treatment facilities, which serve populations of approximately 40,000 to more than one million people.
Wastewater surveillance is a promising tool for population-level monitoring of the spread of infectious diseases, such as the coronavirus disease 2019 (COVID-19). Different from clinical specimens, viruses in community-scale wastewater samples need to be concentrated before detection because viral RNA is highly diluted. The present study evaluated eleven different virus concentration methods for the detection of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) in wastewater. First, eight concentration methods of different principles were compared using spiked wastewater at a starting volume of 30 mL. Ultracentrifugation was the most effective method with a viral recovery efficiency of 25 ± 6%. The second-best option, AlCl 3 precipitation method, yielded a lower recovery efficiency, only approximately half that of the ultracentrifugation method. Second, the potential of increasing the sensitivity of the method was explored using three concentration methods starting with a larger volume of 1000 mL. Although ultracentrifugation using a large volume outperformed the other two large-volume methods, it only yielded a comparable method sensitivity as the ultracentrifugation using a small volume (30 mL). Thus, ultracentrifugation using less volume of wastewater is more preferable considering the sampling processing throughput. Third, a comparison of two viral RNA extraction methods showed that the lysis-buffer-based extraction method resulted in higher viral recovery efficiencies, with cycle threshold (Ct) values 0.9–4.2 lower than those obtained for the acid-guanidinium-phenol-based method using spiked samples. These results were further confirmed by using positive wastewater samples concentrated by ultracentrifugation and extracted separately by the two viral RNA extraction methods. In summary, concentration using ultracentrifugation followed by the lysis buffer-based extraction method enables sensitive and robust detection of SARS-CoV-2 for wastewater surveillance.
Sewage surveillance could help develop proactive response to the Coronavirus Disease 2019 (COVID-19) pandemic, but currently there are limited reports about examples in practical exercises. Here, we report a use case of intensified sewage surveillance to initiate public health action to thwart a looming Delta variant outbreak in Hong Kong. On 21 June 2021, albeit under basically contained COVID-19 situation in Hong Kong, routine sewage surveillance identified a high viral load of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) in a sewage sample from one site covering over 33,000 population, suggesting infected cases living in the respective sewershed. The use of a newly developed method based on allele-specific real-time quantitative polymerase chain reaction (AS RT-qPCR) served to alert the first documentation of the Delta variant in local community sewage three days before the case was confirmed to be a Delta variant carrier. Intensified sewage surveillance was then triggered. Targeted upstream sampling at sub-sewershed areas pinpointed the source of positive viral signal across spatial scales from sewershed to building level, and assisted in determining the specific area for issuing a compulsory testing order for individuals on 23 June 2021. A person who lived in a building with the positive result of sewage testing was confirmed to be infected with COVID-19 on 24 June 2021. Viral genome sequences determined from the sewage sample were compared to those from the clinic specimens of the matched patient, and confirmed that the person was the source of the positive SARS-CoV-2 signal in the sewage sample. This study could help build confidences for public health agencies in using the sewage surveillance in their own communities.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.