Textural morphology is an important factor influencing dry friction, and few studies have been conducted regarding the effects of single- and multi-shape textures on dry tribological properties. In this work, six types of textures including single- and multi-shape textures were produced on 40Cr steel samples by using a nanosecond laser. Reciprocating sliding tests under dry friction were conducted using a pin-on-disc friction tester. The influences of textured surfaces with different textures on tribological properties were investigated. Results showed that tribological properties were affected by different textural morphologies. The dimple-textured surface had the highest friction coefficient, followed by the groove-textured surface. The sinusoidal-textured surface had the lowest friction coefficient. The friction coefficients of multi-shape textured surfaces were lower than those of non-textured surfaces but higher than those of sinusoidal-textured surfaces. The wear properties of the tested surfaces were consistent with the friction-coefficient results. The sinusoidal- and sinusoidal–groove-textured surfaces can be considered as the optimum choices for dry reciprocating friction.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.