No abstract

A novel CE-based noncompetitive immunoassay for prion protein (PrP) was established. Fluorescein isothiocyanate (FITC)-labeled protein A (FITC-PrA) was used as a fluorescent probe to tag monoclonal antibody through noncovalent binding of FITC-PrA to the Fc region of the antibody. The FITC-PrA-Ab was incubated with the analyte, prion protein, under optimized condition, forming the immunocomplex FITC-PrA-Ab-PrP. The complex was separated and analyzed by capillary zone electrophoresis. The addition of carboxymethyl-beta-cyclodextrin in the running buffer as dynamical coating reagent improved the reproducibility and the resolution. The complex was isolated in less than 1 min with theoretical plates of 3.8 x 10(4). Relative standard deviations of peak height and migration time for the complex were 3.46 and 1.48%, respectively. A linear relationship was established for the bovine recombinant prion protein (rPrP) concentration in the range from 0.2 to 2.0 mug/mL and the peak height. The correlation factor was r2 = 0.9969. The estimated detection limit for rPrP was approximately 6 ng/mL, which is 3 times the signal-to-noise ratio. The method was successfully applied for testing blood samples from scrapie-infected sheep.

The development of capillary electrophoresis (CE)-based competitive immunoassay for prion protein (PrP) using carboxymethyl beta-cyclodextrin (CM-beta-CD) as a buffer additive is described here. The assay was based on the competitive binding of PrP and a fluorescein-labeled peptide from the prion protein with a limiting amount of specific antibody. The amount of both free and fluorescein-labeled peptide bound to antibody (immunocomplex) were determined by CE with laser-induced fluorescence detection. In the presence of PrP, the peak height ratio of the immunocomplex and the free peptide was altered compared to the control. These changes were directly proportional to the amount of PrP present. The fluorescently labeled peptide spanning amino acid positions 140-158 of the PrP and its corresponding monoclonal antibody is reported here. The reaction times of the antibody with either the peptide or the recombinant PrP was less than 1 min and is a large improvement over the 16-18 h required to achieve equilibrium for polyclonal antibodies. CM-beta-CD was explored as a buffer additive to suppress analyte adsorption and enhance separation selectivity in the CE analysis. A fast (1.1 min), selective (resolution 4.7), and reproducible (relative standard deviations of migration time for free and bound fluorescein isothiocyanate (FITC)-peptide 0.56% and 0.64%, respectively) separation was obtained with 0.6% CM-beta-CD in 25 mM N-tris(hydroxymethyl)methyl-3-aminopropanesulfonic acid (TAPS) at pH 8.8. The concentration detection limit of the assay for recombinant PrP was determined to be 80 ng/mL (or mass detection limit 1 pg). When blood samples from scrapie-infected sheep and from normal sheep were tested, the results of the blood assay were consistent with scrapie status of the sheep as determined post mortem by Western blot analysis. Development of this assay will lead to a potentially robust, rapid, and specific preclinical diagnosis for transmissible spongiform encephalopathies (TSEs) in animals and humans.

No abstract

No abstract

No abstract

A mathematical model concerning the separation selectivity of basic analytes in chiral capillary electrophoresis (CE) modified with negatively charged cyclodextrins (CDs) has been presented to describe the dependence of chiral selectivity on the buffer pH and the chiral selector concentration. The electrophoretic method to determine the parameters of the model has also been developed. The model has been tested with racemic epinephrine and isoproterenol as target analytes and sulfonated beta-CD as chiral selector. The agreements have been found between the calculated and the measured values. Some significant conclusions to optimize chiral CE separation have been derived from the model and proven by the experiments. Electrochemical detection was used to meet the requirement of the low introduced concentration of analytes.

In this work, a new generation UV-transparent polymer, fluorinated ethylenepropylene copolymer (FEP) exhibiting a low degree of crystallinity, extruded in dimensions similar to the most commonly used CE capillaries of approximately 80 mum id and about 360 mum od was investigated for its use as a CE capillary. FEP is transparent down to the low-UV region, and as fluorinated polymers in general are good electrical insulators and exhibit reasonable heat conductivity, it has considerable potential as a material for electrodriven analysis in capillary or microchip formats. The FEP capillary has been characterised with regard to some important aspects for its use as a CE capillary, including its profile of EOF versus pH, as well as procedures for manipulating EOF by coating the inner capillary wall with various semipermanent and dynamic layers. The FEP capillaries were tested and compared with fused-silica capillary for the separation of inorganic and small organic ions using conditions involving direct and indirect detection in the low-UV region. Finally, advantages of the use of the FEP capillary for simultaneous detection of a mixture containing nine inorganic cations and anions using indirect photometric detection with a movable light-emitting diode (LED) detector and a novel electrolyte are demonstrated.