Stable mesoporous black TiO2 hollow spheres with controllable diameter, wall thickness and narrow bandgap are fabricated via a small amine molecules encircling strategy, showing high solar-driven photocatalytic hydrogen evolution.
Ti3+ self-doped black
TiO2 nanotubes (TDBTNs)
with mesoporous nanosheet architecture have been successfully synthesized
by solvothermal method combined with ethylenediamine encircling strategy
to protect mesoporous frameworks, then calcined at 600 °C under
hydrogen atmosphere. In this case, ethylenediamine molecules play
important roles on maintaining the mesoporous networks and inhibiting
the phase transformation from anatase-torutile effectively. The as-prepared
TDBTNs with mesoporous nanosheet architecture possess a relatively
high specific surface area of ∼95 m2 g–1 and an average pore size of ∼15.6 nm. The reduced bandgap
of ∼2.87 eV extends the photoresponse from ultroviolet to visible
light region due to the Ti3+ self-doping. The solar-driven
photocatalytic hydrogen evolution rate for TDBTNs is approximately
3.95 mmol h–1 g–1, which is much
better (about four times) than that of the pristine one (∼0.94
mmol h–1 g–1). This improvement
is attributed to the reduced bandgap increasing the utilization ratio
of solar energy, the formed Ti3+ enhancing separation efficiency
of photogenerated charge carriers, and the special one-dimensional
mesoporous architecture offering more surface active sites.
Ergothioneine, a natural longevity vitamin and antioxidant, is a thiol-histidine derivative. Recently, two types of biosynthetic pathways were reported. In the aerobic ergothioneine biosyntheses, non-heme iron enzymes incorporate a sulfoxide into an sp 2 C−H bond from trimethyl-histidine (hercynine) through oxidation reactions. In contrast, in the anaerobic ergothioneine biosynthetic pathway in a green-sulfur bacterium, Chlorobium limicola, a rhodanese domain containing protein (EanB), directly replaces this unreactive hercynine C−H bond with a C−S bond. Herein, we demonstrate that polysulfide (HSS n SR) is the direct sulfur source in EanB catalysis. After identifying EanB's substrates, X-ray crystallography of several intermediate states along with mass spectrometry results provide additional mechanistic details for this reaction. Further, quantum mechanics/molecular mechanics (QM/MM) calculations reveal that the protonation of N π of hercynine by Tyr353 with the assistance of Thr414 is a key activation step for the hercynine sp 2 C−H bond in this trans-sulfuration reaction.
A facile two‐step strategy was used to prepare black of hydrogenated/nitrogen‐doped TiO2 nanoplates (NHTA) with a flower‐like hierarchical architecture. In situ nitriding and self‐assembly was realized by hydrothermal synthesis using tripolycyanamide as a N source and as a structure‐directing agent. After thorough characterization, it was found that the hydrogenation treatment did not damage the flower‐like architecture but distorted the anatase crystal structure and significantly changed the band structure of NHTA owing to the increased concentration of oxygen vacancies, hydroxyl groups, and Ti3+ cations. Under AM 1.5 illumination, the photocatalytic H2 evolution rate on the black NHTA was approximately 1500 μmol g−1 h−1, which was much better than the N‐doped TiO2 nanoplates (≈690 μmol g−1 h−1). This improvement in the hydrogen evolution rate was attributed to a reduced bandgap, enhanced separation of the photogenerated charge carriers, and an increase in the surface‐active sites.
Ergothioneine is a thiohistidine derivative with potential benefits on many aging-related diseases. The central step of aerobic ergothioneine biosynthesis is the oxidative C-S bond formation reaction catalyzed by mononuclear nonheme iron sulfoxide synthases (EgtB and Egt1). Thus far, only the Mycobacterium thermoresistibile EgtB (EgtB Mth) crystal structure is available, while the structural information for the more industrially attractive Egt1 enzyme is not. Herein, we reported the crystal structure of the ergothioneine sulfoxide synthase (EgtB Cth) from Candidatus Chloracidobacterium thermophilum. EgtB Cth has both EgtB-and Egt1-type of activities. Guided by the structural information, we conducted Rosetta Enzyme Design calculations, and we biochemically demonstrated that EgtB Cth can be engineered more toward Egt1-type of activity. This study provides information regarding the factors governing the substrate selectivity in Egt1and EgtB-catalysis and lays the groundwork for future sulfoxide synthase engineering toward the development of an effective ergothioneine process through a synthetic biology approach.
BackgroundThe lignocellulose biorefinery based on the sugar platform usually focuses on polysaccharide bioconversion, while lignin is only burned for energy recovery. Pyrolysis can provide a novel route for the efficient utilization of residual lignin obtained from the enzymatic hydrolysis of lignocellulose. The pyrolysis characteristics of residual lignin are usually significantly affected by the pretreatment process because of structural alteration of lignin during pretreatment. In recent years, biological pretreatment using white-rot fungi has attracted extensive attention, but there are only few reports on thermal conversion of lignin derived from enzymatic hydrolysis residue (EHRL) of the bio-pretreated lignocellulose. Therefore, the study investigated the pyrolysis characteristics and kinetics of EHRL obtained from bamboo pretreated with Echinodontium taxodii in order to evaluate the potential of thermal conversion processes of EHRL.ResultsFourier transform infrared spectroscopy spectra showed that EHRL of bamboo treated with E. taxodii had the typical lignin structure, but aromatic skeletal carbon and side chain of lignin were partially altered by the fungus. Thermogravimetric analysis indicated that EHRL pyrolysis at different heating rates could be divided into two depolymerization stages and covered a wide temperature range from 500 to 900 K. The thermal decomposition reaction can be well described by two third-order reactions. The kinetics study indicated that the EHRL of bamboo treated with white-rot fungus had lower apparent activation energies, lower peak temperatures of pyrolysis reaction, and higher char residue than the EHRL of raw bamboo. Pyrolysis–gas chromatography–mass spectrometry (Py–GC/MS) was applied to characterize the fast pyrolysis products of EHRL at 600 ℃. The ratios of guaiacyl-type to syringyl-type derivatives yield (G/S) and guaiacyl-type to p-hydroxy-phenylpropane-type derivatives yield (G/H) for the treated sample were increased by 33.18 and 25.30 % in comparison with the raw bamboo, respectively.ConclusionsThe structural alterations of lignin during pretreatment can decrease the thermal stability of EHRL from the bio-treated bamboo and concentrate the guaiacyl-type derivatives in the fast pyrolysis products. Thus, the pyrolysis can be a promising route for effective utilization of the enzymatic hydrolysis residue from bio-pretreated lignocellulose.
Previous investigations suggested that Streptomyces jiujiangensis JXJ 0074(T) can secrete antialgal compounds. In this study, an antialgal compound was isolated from the cultured broth of S. jiujiangensis JXJ 0074(T) by using bioassay methods. Based on spectroscopic data, the active compound was identified as 2'-deoxyadenosine, which exhibited a greater antialgal activity against cyanobacteria than its analogues such as adenosine, guanosine, and 2'-deoxyguanosine. The antialgal activity of 2'-deoxyadenosine increased with the content and time. 2'-Deoxyadenosine severely damaged the vegetative cells of cyanobacteria, causing crumpling, collapse, expanding, perforation, breakage of filamentous cyanobacteria, and decrease of the chlorophyll. However, 2'-deoxyadenosine seemed to have less impact on the morphology of heterocysts of filamentous cyanobacteria. The superoxide dismutase (SOD) activity in the treated cells of M. aeruginosa FACHB-905 initially increased with 31.14 ± 2.00% higher than that of the control after 36 h and then decreased quickly. On the same time, there were rapid increases in superoxide anion radical (O2 (-)) and malondialdehyde (MDA) contents with 315.53 ± 12.81 and 84.72 ± 6.15% higher than these of the controls at 60 h, respectively. The intracellular microcystin-LR (MC-LR) content in the treated cells of M. aeruginosa FACHB-905 increased by 36.34 ± 7.35% 1 day later, followed by a rapid decrease with a rate of 90.50 ± 1.08% 8 days later, while the extracellular MC-LR content showed no significant difference with the control. Five days after adding 15 μg/ml of 2'-deoxyadenosine to the culture of M. aeruginosa FACHB-905, there was no 2'-deoxyadenosine detected by HPLC, suggesting that 2'-deoxyadenosine completely degraded. This study provides a new clue to screen natural-based antialgal compounds from nucleoside analogues.
Stable mesoporous black anatase TiO2 nanosheets (MBTNs) are synthesized via an earth-abundant low-cost biotemplate method combined with an ethanediamine encircling process, and exhibit excellent solar-driven photocatalytic hydrogen generation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.