A compact silicon-on-insulator device used for conversions between polarization division multiplexing (PDM) and mode division multiplexing (MDM) signals is proposed and experimentally demonstrated by utilizing a structure combining the improved two-dimensional grating coupler and two-mode multiplexer. The detailed design of the proposed device is presented and the results show the extinction ratio of 16 and 20 dB for X- and Y-pol input, respectively. The processing of 40  Gb/s signal is achieved within the C-band with good performance. The proposed converter is capable of handling multiple wavelengths in wavelength division multiplexing (WDM) networks, enabling the conversions between WDM-PDM and WDM-MDM, which is promising to further increase the throughput at the network interface.

We here present an orthogonal self-assembly strategy to fabricate a series of metallosupramolecular polymers by coupling planar platinum(II) complexes and starlike poly(ε-caprolactone), through Pt•••Pt/π−π interactions and host−guest recognition between secondary dialkylammonium salts and crown ether groups. The solid metallosupramolecular polymers exhibit sub-10 nm scale lamellar structures and one of them occupies an extraordinary degree of long-range order. The platinum(II) complexes can be regarded as an individual supramolecular block to microphase segregate the polymeric segment. Moreover, the metallosupramolecular polymers show intense luminescence and appreciable proton conductivity, originating from these two supramolecular connection modes, respectively. This work paves the way for fabricating metallosupramolecular polymers showing both highly ordered nanostructures and multifunctional properties.

Electrohydrodynamic (EHD) printing is a promising micro/nano fabrication technique, due to its ultra-high resolution and wide material applicability. However, it suffers from printing efficiency which urgently calls for a high...

We investigate multi-mode oscillation and ejection behavior in pulsed electrohydrodynamic (EHD) printing in this paper. The results show that multi-mode oscillation is determined by the damping ratio of the meniscus, while the phase difference between meniscus oscillation and the electric field governs whether jetting can occur. High-order-mode jetting can occur around the corresponding resonant frequency of a low damping ratio system. This enhances the frequency limit to approximately 2.62 times that of traditional pulsed EHD printing, providing an efficient approach to high-frequency EHD printing.