Two new engineering models are presented for the aerodynamic induction of a wind turbine under dynamic thrust. The models are developed using the differential form of Duhamel integrals of indicial responses of actuator disc type vortex models. The time constants of the indicial functions are obtained by the indicial responses of a linear and a nonlinear actuator disc model. The new dynamic‐inflow engineering models are verified against the results of a Computational Fluid Dynamics (CFD) model and compared against the dynamic‐inflow engineering models of Pitt‐Peters, Øye, and Energy Research Center of the Netherlands (ECN), for several load cases. Comparisons of all models show that two time constants are necessary to predict the dynamic induction. The amplitude and phase delay of the velocity distribution shows a strong radial dependency. Verifying the models against results from the CFD model shows that the model based on the linear actuator disc vortex model predicts a similar performance as the Øye model. The model based on the nonlinear actuator disc vortex model predicts the dynamic induction better than the other models concerning both phase delay and amplitude, especially at high load.

No abstract

Although the Blade Element Momentum method has been derived for the steady conditions, it is used for unsteady conditions by using corrections of engineering dynamic inflow models. Its applicability in these cases is not yet fully verified. In this paper, the validity of the assumptions of quasi-steady state and annuli independence of the blade element momentum theory for unsteady, radially varied, axi-symmetric load cases is investigated. Firstly, a free wake model that combines a vortex ring model with a semi-infinite cylindrical vortex tube was developed and applied to an actuator disc in three load cases: (i) steady uniform and radially varied, (ii) two types of unsteady uniform load and (iii) unsteady radially varied load. Results from the three cases were compared with Momentum Theory and also with two widely used engineering dynamic inflow models-the Pitt-Peters and the Øye for the unsteady load cases. For unsteady load, the free wake vortex ring model predicts different hysteresis loops of the velocity at the disc or local annuli, and different aerodynamic work from the engineering dynamic inflow models. Given that the free wake vortex ring model is more physically representative, the results indicate that the engineering dynamic inflow models should be improved for unsteady loaded rotor, especially for radially varied unsteady loads. This is an open access article under the terms of the Creative Commons Attribution-NonCommercial License, which permits use, distribution and reproduction in any medium, provided the original work is properly cited and is not used for commercial purposes.

for unsteady actuator discs and wind turbines, and are made available in an open source database (see Appendix). List of symbols

No abstract