Isogenic mutants derived from quinolone-susceptible isolate WT by introducing gyrA (S83L, D87G) and parC (S80I, E84K) mutations associated with quinolone resistance were characterized with respect to quinolone resistance, growth rate, and degree of global supercoiling. The latter was determined by use of a pair of reporter plasmids carrying supercoiling-dependent promoters pgyrA and ptopA, respectively, transcriptionally fused to the reporter gene bla coding for TEM-1 ␤-lactamase. The quotient (Qsc) of the ␤-lactamase specific activity determined for a mutant carrying either plasmid was taken as a measure of the degree of global supercoiling. These Qsc data were comparable to results obtained from the separation of topoisomers of plasmid pBR322 on chloroquine-containing agarose gels and indicate a reduced degree of negative supercoiling in resistant mutants relative to the parent, WT. The S83L mutation in gyrA had the strongest influence on quinolone resistance while leaving other parameters nearly unaffected. The gyrA double mutation (S83L plus D87G) had an effect on quinolone resistance similar to that of a single mutation. Phenotypic expression of the parC mutation (S80I) was dependent on the presence of at least one gyrA mutation. Expression of high-level fluoroquinolone resistance (ciprofloxacin MIC, >4 g/ml) required a combination of the gyrA double mutation and one parC mutation (S80I or E84K). Such mutants showed considerable alterations of growth rate, global supercoiling, or both. Introduction of a parC mutation affected neither the doubling time nor the degree of supercoiling, while the presence of the gyrA D87G mutation was associated with a significant reduction in the degree of DNA supercoiling.

Desorption electrospray ionization (DESI) mass spectrometry is an emerging technology for direct therapeutic drug monitoring in dried blood spots (DBS). Current DBS methods require manual application of small molecules as internal standards for absolute drug quantification. With industrial standardization in mind, we superseded the manual addition of standard and built a three-layer setup for robust quantification of salicylic acid directly from DBS. We combined a dioctyl sodium sulfosuccinate weave facilitating sample spreading with a cellulose layer for addition of isotope-labeled salicylic acid as internal standard and a filter paper for analysis of the standard-containing sample by DESI-MS. Using this setup, we developed a quantification method for salicylic acid from whole blood with a validated linear curve range from 10 to 2000 mg/L, a relative standard deviation (RSD%) ≤14%, and determination coefficients of 0.997. The limit of detection (LOD) was 8 mg/L and the lower limit of quantification (LLOQ) was 10 mg/L. Recovery rates in method verification by LC-MS/MS were 97 to 101% for blinded samples. Most importantly, a study in healthy volunteers after administration of a single dose of Aspirin provides evidence to suggest that the three-layer setup may enable individual pharmacokinetic and endpoint testing following blood collection by finger pricking by patients at home. Taken together, our data suggests that DBS-based quantification of drugs by DESI-MS on pre-manufactured three-layer cartridges may be a promising approach for future near-patient therapeutic drug monitoring.

Dried blood spots (DBS) are a versatile and stable tool for direct clinical blood analysis. Ambient high-resolution mass spectrometry is emerging as a method of choice for their quantitative analysis, for instance in therapeutic drug monitoring. Here, we coupled liquid microjunction surface sampling technology, a so-called Flowprobe, with an Orbitrap mass spectrometer and demonstrated the utility of this set-up for direct quantification of multiple drugs in DBS on filter paper. A three-layer set-up that we had introduced earlier enabled introduction of internal standards into DBS. We furthermore took an established point-of-care test system a step further and analyzed disposable test fields for blood glucose monitoring also for Flowprobe-based acetaminophen screening without additional sample preparation. Using as little as 2 μL blood, the method had an LOD of 1 μg mL(-1) (coefficient of variation of ≤15%) and acetaminophen recoveries of 82 to 119% for blinded samples, as assessed by LC-MS/MS. Half an hour after ingestions of a single 1000 mg acetaminophen dose, indistinguishable drug levels were measured in three healthy volunteers by LC-MS/MS and Flowprobe-Orbitrap MS analysis of DBS. Flowprobe analysis of DBS was 6- to 100-times more sensitive than corresponding desorption electrospray ionization MS analysis for four drugs. For instance, the LOD for salicylic acid analysis was 0.07 ng mL(-1) with Flowprobe measurement. Furthermore, we showed that multi-component analysis of five different substances, which may mimic polypharmacy in diabetes patients, in one blood sample for screening purposes was feasible. Taken together, our study suggests that microjunction surface sampling of DBS on filter paper and disposable point-of-care test fields may be developed into routine methods for near-patient multi-compound therapeutic drug monitoring that may advance blood screening analysis for patients with polypharmacy.