We report on the state-of-the art synthesis and improved luminescence properties of thiol-capped CdTe nanocrystals (NCs) synthesized in water. The optimized pH (12) and molar ratio of thiol to Cd ions (1.3:1) increases the room-temperature photoluminescence quantum efficiency of as-synthesized CdTe NCs capped by thioglycolic acid (TGA) to values of 40−60%. By employing mercaptopropionic acid (MPA) as a stabilizer, we have synthesized large (up to 6.0 nm in diameter) NCs so that the spectral range of the NCs' emission currently available within this synthetic route extends from 500 to 800 nm. Sizing curve for thiol-capped CdTe NCs is provided. In contrast to CdTe NCs capped by TGA, MPA-capped CdTe NCs show up to 1 order of magnitude longer (up to 145 ns) emission decay times, which become monoexponential for larger particles. This phenomenon is explained by considering the energetics of the Te-related traps in respect to the valence-band position of CdTe NCs. The correlation between luminescence quantum efficiencies, luminescence lifetimes, and Stokes shifts of CdTe NC fractions is demonstrated, being in agreement with a model proposed previously that connects the emission properties of NCs with their surface quality determined by the Oswald ripening conditions during growth. imaging, and plasmonics.

Despite the increasing use of semiconductor nanocrystals (quantum dots, QDs) with unique size-controlled optical and chemical properties in (bio)analytical detection, biosensing and fluorescence imaging and the obvious relevance of reliable values of fluorescence quantum yields for these applications, evaluated procedures for the determination of the fluorescence quantum yields (Φf) of these materials are still missing. This limits the value of literature data of QDs in comparison to common organic dyes and hampers the comparability of the performance of QDs from different sources or manufacturers. This encouraged us to investigate achievable uncertainties for the determination of Φf values of these chromophores and to illustrate common pitfalls exemplarily for differently sized water-soluble CdTe QDs. Special attention is dedicated to the colloidal nature and complicated surface chemistry of QDs thereby deriving procedures to minimize uncertainties related to these features.

We have investigated cation exchange reactions in copper selenide nanocrystals using two different divalent ions as guest cations (Zn2+ and Cd2+) and comparing the reactivity of close to stoichiometric (that is, Cu2Se) nanocrystals with that of nonstoichiometric (Cu2–xSe) nanocrystals, to gain insights into the mechanism of cation exchange at the nanoscale. We have found that the presence of a large density of copper vacancies significantly accelerated the exchange process at room temperature and corroborated vacancy diffusion as one of the main drivers in these reactions. Partially exchanged samples exhibited Janus-like heterostructures made of immiscible domains sharing epitaxial interfaces. No alloy or core–shell structures were observed. The role of phosphines, like tri-n-octylphosphine, in these reactions, is multifaceted: besides acting as selective solvating ligands for Cu+ ions exiting the nanoparticles during exchange, they also enable anion diffusion, by extracting an appreciable amount of selenium to the solution phase, which may further promote the exchange process. In reactions run at a higher temperature (150 °C), copper vacancies were quickly eliminated from the nanocrystals and major differences in Cu stoichiometries, as well as in reactivities, between the initial Cu2Se and Cu2–xSe samples were rapidly smoothed out. These experiments indicate that cation exchange, under the specific conditions of this work, is more efficient at room temperature than at higher temperature.

A size-selected series of water-soluble luminescent Ag–In–S (AIS) and core/shell AIS/ZnS quantum dots (QDs) were produced by a precipitation technique. Up to 10–11 fractions of size-selected AIS (AIS/ZnS) QDs emitting in a broad color range from deep-red to bluish-green were isolated with the photoluminescence (PL) quantum yield reaching 47% for intermediate fractions. The size of the isolated AIS (AIS/ZnS) QDs varied from ∼2 to ∼3.5 nm at a roughly constant chemical composition of the particles throughout the fractions as shown by the X-ray photoelectron spectroscopy. The decrease of the mean AIS QD size in consecutive fractions was accompanied by an increase of the structural QD imperfection/disorder as deduced from a notable Urbach absorption “tail” below the fundamental absorption edge. The Urbach energy increased from 90–100 meV for the largest QDs up to 350 meV for the smallest QDs, indicating a broadening of the distribution of sub-bandgap states. Both the Urbach energy and the PL bandwidth of the size-selected AIS QDs increased with QD size reduction from 3–4 to ∼2 nm, and a distinct correlation was observed between these parameters. A study of size-selected AIS and AIS/ZnS QDs by UV photoelectron spectroscopy on Au and FTO substrates revealed their valence band level E VB at ∼6.6 eV (on Au) and ∼7 eV (on FTO) pinned to the Fermi level of conductive substrates resulting in a masking of any possible size-dependence of the valence band edge position.

We present an approach for the synthesis of ternary copper indium sulfide (CIS) and quaternary copper indium zinc sulfide (CIZS) nanocrystals (NCs) by means of partial cation exchange with In(3+) and Zn(2+). The approach consists of a sequential three-step synthesis: first, binary Cu2S NCs were synthesized, followed by the homogeneous incorporation of In(3+) by an in situ partial cation-exchange reaction, leading to CIS NCs. In the last step, a second partial exchange was performed where Zn(2+) partially replaced the Cu(+) and In(3+) cations at the surface, creating a ZnS-rich shell with the preservation of the size and shape. By careful tuning reaction parameters (growth and exchange times as well as the initial Cu(+):In(3+):Zn(2+) ratios), control over both the size and composition was achieved. This led to a broad tuning of photoluminescence of the final CIZS NCs, ranging from 880 to 1030 nm without altering the NCs size. Cytotoxicity tests confirmed the biocompatibility of the synthesized CIZS NCs, which opens up opportunities for their application as near-infrared fluorescent markers in the biomedical field.

Surface plasmon enhanced Förster resonant energy transfer (FRET) between CdTe nanocrystal quantum dots (QDs) has been observed in a multilayer acceptor QD-gold nanoparticle-donor QD sandwich structure. Compared to a donor-acceptor QD bilayer structure without gold nanoparticles, the FRET rate is enhanced by a factor of 80 and the Förster radius increases by 103%. Furthermore, a strong impact of the donor QD properties on the surface plasmon mediated FRET is reported.

This article summarizes the main achievements and challenges in the field of the aqueous synthesis of semiconductor quantum dots in colloidal solutions. Developments in the last two decades demonstrate the great potential of this approach to synthesize nanocrystalline materials with superior properties such as strong photoluminescence, long time stability and compatibility with biological media, and the variability in assembling and self-assembling into larger structures or on surfaces. Being relatively straightforward, the aqueous approach provides some advantages such as versatility, scalability, environmental friendliness and cost effectiveness, leading in summary to very attractive application perspectives.

No abstract