PVDF nanofibers are prepared using electrospinning. The effect of addition of a hydrated salt, nickel chloride hexahydrate (NiCl(2)·6H(2)O), on the phase formation is examined. Addition of the hydrated salt (NC) is found to enhance the polar β phase by about 30%. The peak to peak piezo-voltage generated for PVDF NC is almost 0.762 V, a factor of 3 higher than that for PVDF. The fiber mats exhibit a significantly enhanced dynamic strain sensor response. The voltage generated per unit micro-strain developed during the free vibration test for PVDF was 0.119 mV whereas it was 0.548 mV for PVDF NC, exhibiting a non-linearly enhanced performance vis a vis the increase in the β phase component.
We report here enhanced ferroelectric crystal formation and energy generation properties of polyvinylidene fluoride (PVDF) in the presence of surface-modified crystalline nanocellulose. Incorporation of only 2−5 wt % fluorinated nanocellulose (FNC) in PVDF has been found to significantly induce polar β/γ-phase crystallization as compared to the addition of unmodified nanocellulose (carboxylated nanocellulose). A device made up of electrically poled PVDF/FNC composite films yielded 2 orders of magnitude higher voltage output than neat PVDF in vibrational energy harvesting. This remarkable increase in energy generation properties of PVDF at such a low loading of an organic natural biopolymer could be attributed to the tailored surface chemistry of nanocellulose, facilitating strong interfacial interactions between PVDF and FNC. Interestingly, energy harvesting devices fabricated from PVDF/FNC nanocomposites charged a 4.7 μF capacitor at significantly faster rate and the accumulated voltage on capacitor was 3.8 times greater than neat PVDF. The fact that PVDF/FNC nanocomposites still retain a strain at break of 10− 15% and can charge a capacitor in few seconds suggests potential use of these nanocomposites as flexible energy harvesting materials at large strain conditions.
We report here enhanced vibration and pressure sensing properties of nanocellulose reinforced flexible composite piezoelectric nanogenerators (PENGs). Surface fluorinated nanocellulose crystals (FNC) were incorporated into poly(vinylidene fluoride) (PVDF) and electrospun into composite nanofibers. Incorporation of only 2 wt % FNC in PVDF resulted in a significant enhancement in pressure sensitivity with a very low detectable pressure limit of 10 Pa and a sensitivity of up to 18 mV/kPa. The composite PENGs also demonstrated very high sensitivity for forced continuous vibrations. 2FNC/PVDF composites resulted in an order of magnitude higher voltage response over neat PVDF for a given strain. When PENGs were mounted on a vacuum pump for transduction of mechanical vibrations into electrical energy, 2FNC/PVDF composite devices manifested ∼3.8 times enhanced voltage output over neat PVDF and faster charging of a capacitor. The enhanced piezoelectric properties of PVDF/FNC nanocomposites could be attributed to the tailored interface between PVDF and nanocellulose and enhanced polarizability.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.