The emissions characteristics of two combustion platforms, a T63 turboshaft engine and an atmospheric swirl-stabilized research combustor, fueled with conventional military jet fuel (JP-8), a natural-gas-derived Fischer−Tropsch synthetic jet fuel (also referred herein as synjet or FT), and blends of the two were investigated. Nonvolatile particulate matter (PM) and gaseous emissions were analyzed to assess the impacts of the aromatic- and sulfur-free synjet fuel on the combustion products of the two platforms. The engine was operated at two power settings, and the combustor at several equivalence ratios, to evaluate the emission production over a wide range of combustion temperatures. Conventional aerosol instrumentation was used to quantify particle number (PN), size, and PM mass emissions, while a Fourier Transform Infrared analyzer was used to quantify the gaseous species. Planar laser-induced fluorescence and laser-induced incandescence techniques were employed on the research combustor to study the effects of the FT fuel on the formation and oxidation of particles in the combustor primary zone. Test results show dramatic reductions in particle concentrations and mean size on both combustion platforms with the neat FT and synjet fuel blends relative to operation with JP-8. Reductions of over 90% in PN were observed on both platforms for several operating conditions with neat FT fuel. For the engine, over an 80% reduction in smoke number was observed with neat synjet relative to operation on JP-8. As expected, reductions in sulfur oxide emissions and slight increases in water vapor (measured only in the atmospheric combustor) resulted due to the sulfur-free nature and higher hydrogen-to-carbon ratio of the synthetic fuel. Minor impacts were observed for other gaseous emissions. American Society for Testing and Materials fuel specification tests showed that JP-8/synjet blends up to 50/50% by volume satisfied the JP-8 military fuel requirements and that only the minimum specific gravity requirement was not satisfied at higher synjet concentrations. Impacts of the synjet fuel on the emissions of the atmospheric combustor and the T63 engine, a comparison of emissions between the two platforms, and results of in situ laser-based measurements in the combustor reaction zone are discussed.

No abstract

Simultaneous planar laser-induced incandescence, hydroxyl radical planar laser-induced fluorescence, and droplet Mie scattering are used to study the instantaneous flame structure and soot formation process in an atmospheric pressure, swirl-stabilized, liquid-fueled, model gas-turbine combustor. Optimal excitation and detection schemes to maximize single-shot signals and avoid interferences from soot-laden flame emission are discussed. The data indicate that rich pockets of premixed fuel and air along the interface between the spray flame and the recirculation zone serve as primary sites for soot inception. Intermittent large-scale structures and local equivalence ratio are also found to play an important role in soot formation.

No abstract

has been reproduced from the microfilm master. UMI films the text directly from the original or copy submitted. Thus, some thesis and dissertation copies are in typewriter face, while others may be from any type of computer printer.The quality of this reproduction is dependent upon the quality of the copy subm itted. Broken or indistinct print, colored or poor quality illustrations and photographs, print bleedthrough, substandard margins, and improper alignment can adversely affect reproduction.

No abstract

No abstract

No abstract