No abstract

Detection of microbial pathogens in food is the solution to the prevention and recognition of problems related to health and safety. New biomolecular approaches for foodborne pathogen detection are being developed to improve the biosensor characteristics such as sensitivity and selectivity, also which is rapid, reliable, cost-effective, and suitable for in situ analysis. Recently, conducting polymers have drawn attention in the development of biosensors. The electrically conducting polymers have numerous features, which allow them to act as excellent materials for immobilization of biomolecules. Also, their unique properties make them appealing alternatives for specific materials currently employed for the fabrication of biosensors. Therefore, this paper presents a comprehensive literature review detailing the salient features of conducting polymers and their application to biosensors with an emphasis on foodborne pathogen detection.

Mercury (Hg(II)) is considered as one of the most toxic element that directly affects the human health and the environment. Therefore, in this study, we propose a sensitive and disposable electrochemical sensor for the detection of Hg(II) in various water samples using polypyrrole (PPy) decorated graphene/β-cyclodextrin (GR-CD) composite modified screen-printed carbon electrode (SPCE). The GR-CD/PPy composite was synthesized by chemical oxidation of PPy monomer in GR-CD solution using FeCl3. Differential pulse voltammetry (DPV) is used for the detection of Hg(II) and the DPV results reveal that GR-CD/PPy composite modified SPCE has high sensitivity towards Hg(II) than bare, GR, GR-CD and PPy modified SPCEs. The optimization studies such as effect of pH, accumulating time and effect of scanning potential towards the detection of Hg(II) were investigated. The GR-CD/PPy composite modified SPCE could detect the Hg(II) up to 51.56 µM L-1 with the limit of detection (LOD) of 0.47 nM L-1. The LOD obtained was well below the guideline level of Hg(II) set by the World's Health Organization (WHO) and U.S. Environmental Protection Agency (EPA). In addition, the fabricated GR-CD/PPy composite modified SPCE selectively detected the Hg(II) in the presence of potentially interfering metal cations.

Excess nitrite (NO2 -) concentrations in water supplies is considered detrimental to the environment and human health, and is associated with incidence of stomach cancer. In this work, the authors describe a nitrite detection system based on the synthesis of gold nanoparticles (AuNPs) on reduced graphene oxide (rGO) using an aqueous solution of chitosan and succinic acid. The AuNPs-rGO nanocomposite was confirmed by different physicochemical characterization methods including transmission electron microscopy, elemental analysis, X-ray diffraction, UV-visible (UV-vis) and Fourier transform infrared spectroscopy. The AuNPs-rGO nanocomposite was applicable to the sensitive and selective detection of NO2 − with increasing concentrations quantifiable by UV–vis spectroscopy and obvious to the naked eye. The color of the AuNPs-rGO nanocomposite changes from wine red to purple with the addition of different concertation of NO2 −. Therefore, nitrite ion concentrations can be quantitatively detected using AuNPs-rGO sensor with UV-vis spectroscopy and estimated with the naked eye. The sensor is able to detect NO2 − in a linear response ranging from 1 to 20 μM with a detection limit of 0.1 μM by spectrophotometric method. The as-prepared AuNPs-rGO nanocomposite shows appropriate selectivity towards NO2 − in the presence of potentially interfering metal anions.

In the present work, we demonstrate the fabrication of laccase biosensor to detect the catechol (CC) using laccase immobilized on graphene-cellulose microfibers (GR-CMF) composite modified screen printed carbon electrode (SPCE). The direct electrochemical behavior of laccase was investigated using laccase immobilized different modified SPCEs, such as GR/SPCE, CMF/SPCE and GR-CMF/SPCE. Compared with laccase immobilized GR and CMF modified SPCEs, a well-defined redox couple of CuI/CuII for laccase was observed at laccase immobilized GR-CMF composite modified SPCE. Cyclic voltammetry results show that the as-prepared biosensor has 7 folds higher catalytic activity with lower oxidation potential towards CC than SPCE modified with GR-CMF composite. Under optimized conditions, amperometric i-t method was used for the quantification of CC, and the amperometric response of the biosensor was linear over the concertation of CC ranging from 0.2 to 209.7 μM. The sensitivity, response time and the detection limit of the biosensor for CC is 0.932 μMμA−1 cm−2, 2 s and 0.085 μM, respectively. The biosensor has high selectivity towards CC in the presence of potentially active biomolecules and phenolic compounds. The biosensor also accessed for the detection of CC in different water samples and shows good practicality with an appropriate repea.

No abstract

We report a novel and sensitive amperometric sensor for chlorpromazine (CPZ) based on reduced graphene oxide (RGO) and polydopamine (PDA) composite modified glassy carbon electrode. The RGO@PDA composite was prepared by electrochemical reduction of graphene oxide (GO) with PDA. The RGO@PDA composite modified electrode shows an excellent electro-oxidation behavior to CPZ when compared with other modified electrodes such as GO, RGO and GO@PDA. Amperometric i-t method was used for the determination of CPZ. Amperometry result shows that the RGO@PDA composite detects CPZ in a linear range from 0.03 to 967.6 μM. The sensor exhibits a low detection limit of 0.0018 μM with the analytical sensitivity of 3.63 ± 0.3 μAμM–1 cm–2. The RGO@PDA composite shows its high selectivity towards CPZ in the presence of potentially interfering drugs such as metronidazole, phenobarbital, chlorpheniramine maleate, pyridoxine and riboflavin. In addition, the fabricated RGO@PDA modified electrode showed an appropriate recovery towards CPZ in the pharmaceutical tablets.

A simple and facile green process was used for the synthesis of iron nanoparticles (FeNPs) decorated reduced graphene oxide (rGO) nanocomposite by using Ipomoea pes-tigridis leaf extract as a reducing and stabilizing agent. The as-prepared rGO/FeNPs nanocomposite was characterized by transmission electron microscopy, X-ray spectroscopy and Fourier transform infrared spectroscopy. The nanocomposite was further modified on the glassy carbon electrode and used for non-enzymatic sensing of hydrogen peroxide (HO). Cyclic voltammetry results reveal that rGO/FeNPs nanocomposite has excellent electro-reduction behavior to HO when compared to the response of FeNPs and rGO modified electrodes. Furthermore, the nanocomposite modified electrode shows 9 and 6 folds enhanced reduction current response to HO than that of rGO and FeNPs modified electrodes. Amperometric method was further used to quantify the HO using rGO/FeNPs nanocomposite, and the response was linear over the concentration ranging from 0.1μM to 2.15mM. The detection limit and sensitivity of the sensor were estimated as 0.056μM and 0.2085μAμMcm, respectively. The fabricated sensor also utilized for detection of HO in the presence of potentially active interfering species, and found high selectivity towards HO.