We found for the first time a new origin of selection of perovskite crystallization pathways from DMF solutions containing MAI and PbI 2 to present here a comprehensive study of a full set of essential intermediate phases determining the perovskite's morphology. For all three discovered structurally different intermediate phases forming at a given precursor ratio, we refined their crystal structures by synchrotron X-ray radiation and investigated dynamics and phase assemblage in the course of decomposition. As a result, we revealed a clear correlation between the composition of the intermediate phases, peculiarities of their crystal structure, and the morphology of the final perovskite films. Using the DFT method we calculated formation enthalpies of these intermediate phases and explained the preferential precipitation of DMSO-adduct rather than DMF-adduct in an antisolvent approach. This finding opens up a possibility of design-on-demand of perovskite materials using simple soft chemistry approaches.

The use of chiral (salen)TiCl2 complexes to induce the asymmetric addition of trimethylsilyl cyanide to aldehydes has been investigated. The complexes are catalytically active at substrate-to-catalyst ratios as high as 1000:1, and the optimal catalyst (2e) which is derived from (R,R)-1,2-diaminocyclohexane and 3,5-di-tert-butyl-2-hydroxybenzaldehyde produces trimethylsilyl ethers of cyanohydrins with up to 90% enantiomeric excess at ambient temperature. Water plays a key role in these reactions since under strictly anhydrous conditions much lower enantiomeric excesses are produced. The role of water has been shown to be to generate dimeric complexes of the form [(salen)Ti(μ-O)]2 (4) which are the real catalyst precursors. A structure for one of these complexes (4a derived from (R,R)-1,2-diaminocyclohexane and 2-hydroxybenzaldehyde) has been determined by X-ray crystallography. The dimeric complexes are more active than the dichloride precursors, and at substrate-to-catalyst ratios between 100 and 1000:1 give cyanohydrin trimethylsilyl ethers with up to 92% enantiomeric excess in less than 1 h at ambient temperature.

Metal complexes bearing N-heterocyclic carbene (NHC) ligands are typically considered the system of choice for homogeneous catalysis with well-defined molecular active species due to their stable metal−ligand framework. A detailed study involving 19 different Pd-NHC complexes with imidazolium, benzimidazolium, and triazolium ligands has been carried out in the present work and revealed a new mode of operation of metal-NHC systems. The catalytic activity of the studied Pd-NHC systems is predominantly determined by the cleavage of the metal−NHC bond, while the catalyst performance is strongly affected by the stabilization of in situ formed metal clusters. In the present study, the formation of Pd nanoparticles was observed from a broad range of metal complexes with NHC ligands under standard Mizoroki−Heck reaction conditions. A mechanistic analysis revealed two different pathways to connect Pd-NHC complexes to "cocktail"-type catalysis: (i) reductive elimination from a Pd(II) intermediate and the release of NHC-containing byproducts and (ii) dissociation of NHC ligands from Pd intermediates. Metal-NHC systems are ubiquitously applied in modern organic synthesis and catalysis, while the new mode of operation revealed in the present study guides catalyst design and opens a variety of novel opportunities. As shown by experimental studies and theoretical calculations, metal clusters and nanoparticles can be readily formed from M-NHC complexes after formation of new M−C or M−H bonds followed by C− NHC or H−NHC coupling. Thus, a combination of a classical molecular mode of operation and a novel cocktail-type mode of operation, described in the present study, may be anticipated as an intrinsic feature of M-NHC catalytic systems.

The E-4,4'-bis[di(p-anisyl)amino]stilbene cation is a class-III mixed-valence species with electronic coupling comparable to that in its biphenyl-bridged analogue, whereas its tolane-bridged analogue belongs to class II.

The chemical origin of solvents typically used for preparation of hybrid lead halide perovskitesdimethyl sulfoxide (DMSO), dimethylformamide (DMF), and γ-butyrolactone (GBL)strongly influences the process of perovskite crystallization because of the formation of intermediate adducts with different structures and morphology. The composition and crystal structures of the adducts depend on the coordination and binding ability of the solvents and the ratio of the precursors. New adducts of perovskite and GBL with either an unusual cluster structure, (MA) 8 (GBL) x [Pb 18 I 44 ], or an adduct, (MA) 2 (GBL) 2 Pb 3 I 8 , similar to those observed for DMF and DMSO are described for the first time. Complex equilibriums between chemical species existing in perovskite solutions are revealed by Raman spectroscopy. As a result, new features of the perovskite crystallization through intermediate adduct phases are discussed, and effective perovskite deposition pathways are suggested. ■ EXPERIMENTAL SECTIONMaterials and Methods. Methylammonium iodide (CH 3 NH 3 I = MAI, Dyesol), formamidinium iodide (CH 5 N 2 I = FAI, ≥98%, Dyesol), lead iodide (PbI 2 , 99%, Sigma-Aldrich), dimethyl sulfoxide

Dedicated to Professor Dieter Seebach on the occasion of his 65th birthdayThe utility of the chiral [Ti(m-O)(salen)] 2 complexes (R)-and (S)-1 (H 2 salen was prepared from (R,R)-or (S,S)-cyclohexane-1,2-diamine and 3,5-di(tert-butyl)-2-hydroxybenzaldehyde) as catalysts for the asymmetric addition of KCN and Ac 2 O to aldehydes to produce O-acetylcyanohydrins was investigated. It was shown that the complexes were active at a substrate/catalyst ratio of 100 : 1 and produced the O-protected cyanohydrins with ee in the range of 60 ± 92% at À 408. Other complexes, [Ti 2 (AcO) 2 (m-O)(salen) 2 ] ((R)-4) and [Ti(CF 3 COO) 2 (salen)] ((R)-5), were prepared from (R)-1 by treatment with different amounts of Ac 2 O and (CF 3 CO) 2 O, and their catalytic activities were tested under the same conditions. The efficiency of (R)-4 was found to be even greater than that of (R)-1, whereas (R)-5 was inactive. The synthesis of the corresponding salen complexes of V IV and V V ,, was elaborated, and their X-ray crystal structures were determined. The efficiency of (R)-3 was sufficient to produce O-acetyl derivatives of aromatic cyanohydrins with ee in the range of 80 ± 91% at À 408.Introduction. ± As enantiomerically pure cyanohydrins are versatile intermediates in organic synthesis, many synthetic approaches to their syntheses are being vigorously pursued [1]. The catalytic ways of making this class of compounds rely upon the asymmetric addition of a cyanide source to the carbonyl group of aldehydes, as catalyzed by enzymes [2] or purely chemical chiral catalysts [3]. Enantiomerically enriched O-protected cyanohydrins are customarily made by the reaction of aldehydes with Me 3 SiCN usually catalyzed by chiral Lewis acids [1]. We recently reported an efficient catalysis of this reaction by the chiral binuclear [Ti IV (salen)] complex 1 (Fig. 1), active at a ratio of substrate/catalyst as high as 1000 : 1 and promoting the addition at room temperature with ee in the range of 80 ± 92% [4]. Very efficient catalysts based on bifunctional complexes of Al III and Ti IV have also been developed by Shibasaki and co-workers, giving O-(trimethylsilyl) derivatives of cyanohydrins with ee as high as 90 ± 99% at À 428 [5].Unfortunately, Me 3 SiCN is an expensive material, and HCN is extremely toxic. Evidently, there is a need to find cheaper and safer initial materials for the synthesis of enantiomerically pure O-protected cyanohydrins. This paper reports the asymmetric synthesis of O-acetylcyanohydrins by the reaction of KCN, acetic anhydride (Ac 2 O),

We have developed two new catalytic systems based on Ni and Pd complexes to solve the challenging problem of dialkyldichalcogenide (Alk2E2; E=S, Se) addition to alkynes. A comparative study of two catalytic systems-Ni/PMe2Ph and Pd/PCy2Ph-has revealed that the Ni catalyst is superior with respect to high catalytic activity and more general scope relative to the Pd system. A novel synthetic methodology was developed for the preparation of (Z)-bis(alkylthio)alkenes and (Z)-bis(alkylseleno)alkenes from terminal alkynes with excellent stereoselectivity and high yields.

New stable monomeric germanium(II) and tin(II) compounds M(OCH 2 CH 2 NMe 2 ) 2 (M ) Ge (1); M ) Sn (2)), stabilized by two intramolecular coordination MrN bonds and containing no bulky groups on the metal atoms, were synthesized. The molecular and crystal structures of these compounds, and that of the previously synthesized compound (ArO) 2 Sn (3; Ar ) 2,4,6-(Me 2 NCH 2 ) 3 C 6 H 2 ), were determined by X-ray diffraction analysis. The electronic structures of 1 and 2 were studied by the DFT method.