The voltammetric oxidation of all deoxyribonucleic acid (DNA) monophosphate nucleotides is investigated for the first time over a wide pH range by differential pulse voltammetry with a glassy carbon electrode. Experimental conditions such as the electrode size, supporting electrolyte composition, and pH were optimized to obtain the best peak potential separation and higher currents. This enabled the simultaneous voltammetric determination of all four DNA bases in equimolar mixtures and detection limits in the nanomolar range at physiological pH. It was also possible to detect for the first time the oxidation of each of the purine and pyrimidine nucleotides free in solution or as monomers in single-stranded DNA.

No abstract

The electrochemical oxidation mechanism of guanine and adenine was investigated using a glassy carbon microelectrode and cyclic and differential pulse voltammetry. It is pH-dependent and the electron transfer process occurs in consecutive steps with the formation of strongly adsorbed dimers on the electrode surface for both compounds. D

Electrochemical devices have received particular attention due to their rapid detection and great sensitivity for the evaluation of DNA-hazard compounds interaction mechanisms. Several types of bioanalytical method use nucleic acids probes to detect DNA damage. This article reviews current directions and strategies in the development and applications of electrochemical DNA sensors for the detection of DNA damage.

Palladium nanoparticles and nanowires electrochemically deposited onto a carbon surface were studied using cyclic voltammetry, impedance spectroscopy and atomic force microscopy. The ex situ and in situ atomic force microscopy (AFM) topographic images showed that nanoparticles and nanowires of palladium were preferentially electrodeposited to surface defects on the highly oriented pyrolytic graphite surface and enabled the determination of the Pd nanostructure dimensions on the order of 50-150 nm. The palladium nanoparticles and nanowires electrochemically deposited onto a glassy carbon surface behave differently with respect to the pH of the electrolyte buffer solution. In acid or mild acid solutions under applied negative potential, hydrogen can be adsorbed/absorbed onto/into the palladium lattice. By controlling the applied negative potential, different quantities of hydrogen can be incorporated, and this process was followed, analysing the oxidation peak of hydrogen. It is also shown that the growth of the Pd oxide layer begins at negative potentials with the formation of a pre-monolayer oxide film, at a potential well before the hydrogen evolution region. At positive potentials, Pd(0) nanoparticles undergo oxidation, and the formation of a mixed oxide layer was observed, which can act as nucleation points for Pd metal growth, increasing the metal electrode surface coverage. Depending on thickness and composition, this oxide layer can be reversibly reduced. AFM images confirmed that the PdO and PdO 2 oxides formed on the surface may act as nucleation points for Pd metal growth, increasing the metal electrode surface coverage.

The electrochemical behavior of isatin -a molecule with a broad range of applications in synthetic, biological and clinical activity -has been investigated over a wide pH range at a glassy carbon electrode (GCE) using cyclic, square wave and differential pulse voltammetry. The oxidation of isatin is an irreversible process, pH dependent and occurs with the formation of a main oxidation product that strongly adsorbs on the electrode surface. The reduction of isatin is also a pH dependent irreversible process. Cyclic voltammograms show two consecutive charge transfer reactions. The diffusion coefficient of isatin was calculated in pH 7.0 phosphate buffer to be D 0 = 4.9 × 10 −7 cm 2 s −1 . The limit of detection obtained in a solution of pH 7.0 phosphate buffer was LOD = 0.194 M, based on three times the noise level.

The electrochemical behaviour of 2,8-dihydroxyadenine (2,8-DHA)- the main adenine oxidation product- has been investigated over a wide pH range at a glassy carbon electrode (GCE) using cyclic, differential pulse and square wave voltammetry. The oxidation of 2,8-DHA is a quasi-reversible process, pH dependent and occurs with the formation of a main oxidation product, P(2,8-DHA), that strongly adsorbs on the electrode surface. The reduction of 2,8-DHA also occurs and is a reversible process in the absence of molecular oxygen. In electrolytes with pH between 4 and 9 two consecutive reversible charge transfer reactions were identified. However, it was observed that O(2) interfered with the reductive electron transfer process of 2,8-DHA and that, in the presence of oxygen, the reduction of 2,8-DHA occurs at less negative potentials than in the absence of oxygen.

Glassy carbon electrodes (GCE) were modified with poly(glutamic acid) acid films prepared using three different procedures: glutamic acid monomer electropolymerization (MONO), evaporation of poly(glutamic acid) (PAG) and evaporation of a mixture of poly(glutamic acid)/glutaraldehyde (PAG/GLU). All three films showed good adherence to the electrode surface. The performance of the modified GCE was investigated by cyclic voltammetry and differential pulse voltammetry, and the films were characterized by atomic force microscopy (AFM) and electrochemical impedance spectroscopy (EIS). The three poly(glutamic acid) modified GCEs were tested using the electrochemical oxidation of ascorbic acid and a decrease of the overpotential and the improvement of the oxidation peak current was observed. The PAG modified electrode surfaces gave the best results. AFM morphological images showed a polymeric network film formed by well-defined nanofibres that may undergo extensive swelling in solution, allowing an easier electron transfer and higher oxidation peaks.