We report the first successful encapsulation of pristine fullerene C 70 in polymer nanoparticles with very low size polydispersity. We obtained water-dispersed polystyrene (PS) nanoparticles with diameters from 60 nm to 190 nm using a miniemulsion polymerization technique. Contrarily to pristine fullerenes, which are insoluble in most solvents and materials, the nanoparticles containing fullerene C 70 (PS-C 70 ) are stable in water and can be easily incorporated in different materials. When blended with polyacrylonitrile (PAN), a virtually oxygen-impermeable polymer, the PS-C 70 nanoparticles show a strong temperature dependence of the thermally activated delayed fluorescence (TADF) intensity and lifetimes, even when exposed to air. This is the first fluorescence temperature sensor based on TADF that can operate in the presence of oxygen. Unlike other fluorescence temperature sensors, our sensor material is insensitive to oxygen, has emission lifetimes in the millisecond range, and shows a strong emission intensity increase when the temperature increases. This sensor exhibits a very broad sensitivity in a working range from À75 C to at least 105 C (based on fluorescence intensity), surpassing the performance of other temperature fluorescence sensors at high temperatures.

The properties of the light flexible device, ion jelly, which combines gelatin with an ionic liquid (IL) were recently reported being promising to develop safe and highly conductive electrolytes. This article aims for the understanding of the ion jelly conductive mechanism using dielectric relaxation spectroscopy (DRS) in the frequency range 10(-1)-10(6) Hz; the study was complemented with differential scanning calorimetry (DSC) and pulsed field gradient nuclear magnetic resonance (PFG NMR) spectroscopy. The room temperature ionic liquid 1-butyl-3-methylimmidazolium dicyanamide (BMIMDCA) used as received (1.9% w/w water content) and with 6.6% (w/w) of water content and two ion jellies with two different ratios BMIMDCA/gelatin/water % (w/w), IJ1 (41.1/46.7/12.2) and IJ3 (67.8/25.6/6.6), have been characterized. A glass transition was detected by DSC for all materials allowing for classifying them as glass formers. For the ionic liquid, it was observed that the glass transition temperature decreases with the increase of water content. While in subsequent calorimetric runs crystallization was observed for BMIMDCA with negligible water content, no crystallization was detected for any of the ion jelly materials upon themal cycling. To the dielectric spectra of all tested materials, both dipolar relaxation and conductivity contribute; at the lowest frequencies, electrode and interfacial polarization highly dominate. Conductivity, which manifests much more intensity relative to dipolar reorientations, strongly evidences subdiffusive ion dynamics at high frequencies. From dielectric measures, transport properties as mobility and diffusion coefficients were extracted. Data treatment was carried out in order to deconvolute the average diffusion coefficients estimated from dielectric data in its individual contributions of cations (D(+)) and anions (D(-)). The D(+) values thus obtained for IJ3, the ion jelly with the highest IL/gelatin ratio, cover a large temperature range up to room temperature and revealed excellent agreement with direct measurements from PFG NMR, obeying to the same VFT equation. For BMIMDCA(6.6%water), which has the same water amount as IJ3, the diffusion coefficients were only estimated from DRS measurements over a limited temperature range; however, a single VFT equation describes both DRS and PFG NMR data. Moreover, it was found that the diffusion coefficients and mobility are similar for the ionic liquid and IJ3, which points to a role of both water and gelatin weakening the contact ion pair, facilitating the translational motion of ions and promoting its dissociation; nevertheless, it is conceivable the existence of a critical composition of gelatin that leads to those properties. The VFT temperature dependence observed for the conductivity was found to be determined by a similar dependence of the mobility. Both conductivity and segmental motion revealed to be correlated as inferred by the relatively low values of the decoupling indexes. The obtained results show that ion jelly could be in fact a ...

No abstract

The thermal behavior and transport properties of several ion jellys (IJs), a composite that results from the combination of gelatin with an ionic liquid (IL), were investigated by dielectric relaxation spectroscopy (DRS), differential scanning calorimetry (DSC), and pulsed field gradient nuclear magnetic resonance spectroscopy (PFG NMR). Four different ILs containing the dicyanamide anion were used: 1-butyl-3-methylimidazolium dicyanamide (BMIMDCA), 1-ethyl-3-methylimidazolium dicyanamide (EMIMDCA), 1-butyl-1-methylpyrrolidinium dicyanamide (BMPyrDCA), and 1-butylpyridinium dicyanamide (BPyDCA); the bulk ILs were also investigated for comparison. A glass transition was detected by DSC for all materials, ILs and IJs, allowing them to be classified as glass formers. Additionally, an increase in the glass transition temperature upon dehydration was observed with a greater extent for IJs, attributed to a greater hindrance imposed by the gelatin matrix after water removal, rendering the IL less mobile. While crystallization is observed for some ILs with negligible water content, it was never detected for any IJ upon thermal cycling, which persist always as fully amorphous materials. From DRS measurements, conductivity and diffusion coefficients for both cations (D+) and anions (D-) were extracted. D+ values obtained by DRS reveal excellent agreement with those obtained from PFG NMR direct measurements, obeying the same VFTH equation over a large temperature range (ΔT ≈ 150 K) within which D+ varies around 10 decades. At temperatures close to room temperature, the IJs exhibit D values comparable to the most hydrated (9%) ILs. The IJ derived from EMIMDCA possesses the highest conductivity and diffusion coefficient, respectively, ∼10(-2) S·cm(-1) and ∼10(-10) m(2)·s(-1). For BMPyrDCA the relaxational behavior was analyzed through the complex permittivity and modulus formalism allowing the assignment of the detected secondary relaxation to a Johari-Goldstein process. Besides the relevant information on the more fundamental nature providing physicochemical details on ILs behavior, new doorways are opened for practical applications by using IJ as a strategy to produce novel and stable electrolytes for different electrochemical devices.

No abstract