Understanding the Ion Jelly Conductivity Mechanism

Abstract

The properties of the light flexible device, ion jelly, which combines gelatin with an ionic liquid (IL) were recently reported being promising to develop safe and highly conductive electrolytes. This article aims for the understanding of the ion jelly conductive mechanism using dielectric relaxation spectroscopy (DRS) in the frequency range 10(-1)-10(6) Hz; the study was complemented with differential scanning calorimetry (DSC) and pulsed field gradient nuclear magnetic resonance (PFG NMR) spectroscopy. The room temperature ionic liquid 1-butyl-3-methylimmidazolium dicyanamide (BMIMDCA) used as received (1.9% w/w water content) and with 6.6% (w/w) of water content and two ion jellies with two different ratios BMIMDCA/gelatin/water % (w/w), IJ1 (41.1/46.7/12.2) and IJ3 (67.8/25.6/6.6), have been characterized. A glass transition was detected by DSC for all materials allowing for classifying them as glass formers. For the ionic liquid, it was observed that the glass transition temperature decreases with the increase of water content. While in subsequent calorimetric runs crystallization was observed for BMIMDCA with negligible water content, no crystallization was detected for any of the ion jelly materials upon themal cycling. To the dielectric spectra of all tested materials, both dipolar relaxation and conductivity contribute; at the lowest frequencies, electrode and interfacial polarization highly dominate. Conductivity, which manifests much more intensity relative to dipolar reorientations, strongly evidences subdiffusive ion dynamics at high frequencies. From dielectric measures, transport properties as mobility and diffusion coefficients were extracted. Data treatment was carried out in order to deconvolute the average diffusion coefficients estimated from dielectric data in its individual contributions of cations (D(+)) and anions (D(-)). The D(+) values thus obtained for IJ3, the ion jelly with the highest IL/gelatin ratio, cover a large temperature range up to room temperature and revealed excellent agreement with direct measurements from PFG NMR, obeying to the same VFT equation. For BMIMDCA(6.6%water), which has the same water amount as IJ3, the diffusion coefficients were only estimated from DRS measurements over a limited temperature range; however, a single VFT equation describes both DRS and PFG NMR data. Moreover, it was found that the diffusion coefficients and mobility are similar for the ionic liquid and IJ3, which points to a role of both water and gelatin weakening the contact ion pair, facilitating the translational motion of ions and promoting its dissociation; nevertheless, it is conceivable the existence of a critical composition of gelatin that leads to those properties. The VFT temperature dependence observed for the conductivity was found to be determined by a similar dependence of the mobility. Both conductivity and segmental motion revealed to be correlated as inferred by the relatively low values of the decoupling indexes. The obtained results show that ion jelly could be in fact a ...

Dipolar motions and ionic conduction in an ibuprofen derived ionic liquid

“…This represents an increase of around 50 o C relative to the glass transition temperature of samples with water contents above 14.4% (T g-on = -70.3 o C; see Figure 5). This strong deviation of the temperature location of the glass transition is of the same order as observed for water mixtures of the ionic liquid lidocaine HCl vs anhydrous lidocaine HCl 24 but considerably higher to which is usually found for ILs 32,33,34 and ILs based materials. 21 The significant shift in the glass transition upon hydration may indicate a structural effect due to water incorporation that would lead to breaking of extended anion-cation interactions.…”

Tunable Gas Sensing Gels by Cooperative Assembly

“…The combination of ionic liquid with gelatin yields extremely versatile conductive materials. [45] Dielectric relaxation spectroscopy was used to evaluate the conductivity of the hybrid gels. At 298 K, the conductivity of C2 (gelatin and LC) is rather low, increasing by almost six orders of magnitude to ≈10 −4 S cm −1 , at frequencies close to 1 kHz, when the ionic liquid [BMIM][DCA] is incorporated (C1).…”

Synthesis and 7Li Ion Dynamics in Polyarylene‐Ethersulfone‐Phenylene‐Oxide‐Based Polymer Electrolytes

“…The observable total ionic conductivity in salt‐in polymer electrolytes results from long‐range transport of ions including contributions of both cations and anions, respectively, as indicated by their corresponding ion transport numbers . Considering a simplified model, the temperature‐dependent total ionic conductivity σ DC is proportional to the effective number of charge carriers within a unit volume and the ion mobility, which according to the Nernst–Einstein equation is inverse proportional to the temperature, but linear proportional to the diffusion coefficient of the migrating charges . Since ion diffusion typically is regarded as a thermally activated process originating, e.g., from a series of ion “jumps,” an Arrhenius‐type behavior of the total ionic conductivity can be assumed as long as the relevant transport process is not related to cooperative motions of molecular (chain) segments, which in view of the design concept of the considered copolymer ( 7 ) in a first approximation should be valid.…”