No abstract

No abstract

No abstract

SUMMARY To investigate the onshore/offshore structural framework of the northern shelf of the Sea of Marmara, a multidisciplinary study was carried out including multichannel and single‐channel seismic reflection profiling, multibeam bathymetry sounding, side‐scan sonar imaging on offshore as well as land studies for S‐wave velocity estimation by passive and active array measurements and monitoring of block deformations by Global Positioning System (GPS). Based on the multidisciplinary data, possible interactions between landslides and active faulting have been reviewed and their possible relation to the North Anatolian Fault Zone (NAFZ) has been discussed. It is observed that structurally the most deformed subsurface zone offshore coincides with the most undulated landform due to landslides in the area. This observation leads to idea that the structural complexities of the area may also contribute to land sliding as much as other contributing mechanisms such as slope instability, shallow groundwater level, lithology and liquefaction. The Çatalca Fault Zone, a branch of the inactive Western Black Sea (WBS) Fault, may constitute weakness surfaces that contribute to land sliding in the deformed Miocene layers in the study area. Based on the multidisciplinary and new data sets, we show that ongoing land sliding in the study area should be related not only to common causes of landslides but also the structural framework of the area.

No abstract

No abstract

Thermal maturity modelling is widely used in basin modelling to help assess the exploration risk. Of the calibration algorithms available, the Easy%Ro model has gained wide acceptance. In this study, thermal gradients at 70 wells in the Thrace Basin, NW Turkey, were calibrated against vitrinite reflectance (%Ro) using the Easy%Ro model combined with an inverse scheme. The mean squared residual (MSR) was used as a quantitative measure of mismatch between the modelled and measured %Ro. A 90% confidence interval was constructed on the mean of squared residuals to assess uncertainty. The best thermal gradient (i.e. minimum MSR) was obtained from the MSR curve for each well, and an average palaeo-thermal gradient map of the Thrace Basin was therefore created. Calculated thermal gradients were compared to the results of previous studies. A comparison of modelled palaeo-thermal gradients with those measured at the present day showed that the thermal regime of the Thrace Basin has not changed significantly during the basin's history.The geological and thermal characteristics of the Thrace Basin were compared and the thermal anomalies were evaluated as a function of basin evolution processes. The basin's thermal regime was controlled by: (1) basement edge effects; (2) crustal thickness and basement heat flows; (3) thermal conductivity variations within the stratigraphic column; (4) transient heat flow effects; and (5) the influence of tectonic features. The impact of these factors on variations in the thermal gradients is discussed in detail.Basement edge effects are most marked on the steep northern margin of the basin where heat is preferentially retained in highly conductive basement rocks rather than being transferred into less conductive sedimentary rocks. Thus, heat is significantly focused onto the northern edge of the basement, resulting in a thermal anomaly along the northern basin margin.The margins of the basin, with relatively thick upper crust, have relatively higher thermal gradients compared to the central areas. This is due to radiogenic heat production in the upper crust. Thus, thermal gradients increase above highs and at the margins where thicker upper crust is present. A heat flow map of the Thrace Basin, constructed using a basin-scale crustal thickness map and a basement heat-flow algorithm, is presented and demonstrates the heat generation potential of the upper crust.The Eocene Ceylan Formation, which has relatively low thermal conductivity, significantly reduces the thermal gradients by blocking heat transferred from the basement. Areas of high sedimentation rate are associated with low thermal gradients due to the transient heat flow effects of young, thick and "thermally immature" sediments as a function of the heat capacities of these deposits.A direct relationship between thermal gradients and major structural trends could not be established because of a number of factors including the inactivity of the subsurface Miocene fault systems, which did not allow the flow of high temperature fluids t...

No abstract