Abstract-The operation of groups of heavy-duty vehicles (HDVs) at a small inter-vehicular distance (known as platoon) allows to lower the overall aerodynamic drag and, therefore, to reduce fuel consumption and greenhouse gas emissions. However, due to the large mass and limited engine power of HDVs, slopes have a significant impact on the feasible and optimal speed profiles that each vehicle can and should follow. Therefore maintaining a short inter-vehicular distance as required by platooning without coordination between vehicles can often result in inefficient or even unfeasible trajectories. In this paper we propose a two-layer control architecture for HDV platooning aimed to safely and fuel-efficiently coordinate the vehicles in the platoon. Here, the layers are responsible for the inclusion of preview information on road topography and the real-time control of the vehicles, respectively. Within this architecture, dynamic programming is used to compute the fuel-optimal speed profile for the entire platoon and a distributed model predictive control framework is developed for the real-time control of the vehicles. The effectiveness of the proposed controller is analyzed by means of simulations of several realistic scenarios that suggest a possible fuel saving of up to 12% for the follower vehicles compared to the use of standard platoon controllers.

Abstract-Freight transportation is of outmost importance for our society and is continuously increasing. At the same time, transporting goods on roads accounts for about 26% of all energy consumption and 18% of all greenhouse gas emissions in the European Union. Despite the influence the transportation system has on our energy consumption and the environment, road transportation is mainly done by individual long-haulage trucks with no real-time coordination or global optimization. In this paper, we review how modern information and communication technology supports a cyber-physical transportation system architecture with an integrated logistic system coordinating fleets of trucks traveling together in vehicle platoons. From the reduced air drag, platooning trucks traveling close together can save about 10% of their fuel consumption. Utilizing road grade information and vehicle-to-vehicle communication, a safe and fuel-optimized cooperative look-ahead control strategy is implemented on top of the existing cruise controller. By optimizing the interaction between vehicles and platoons of vehicles, it is shown that significant improvements can be achieved. An integrated transport planning and vehicle routing in the fleet management system allows both small and large fleet owners to benefit from the collaboration. A realistic case study with 200 heavy-duty vehicles performing transportation tasks in Sweden is described. Simulations show overall fuel savings at more than 5% thanks to coordinated platoon planning. It is also illustrated how well the proposed cooperative look-ahead controller for heavy-duty vehicle platoons manages to optimize the velocity profiles of the vehicles over a hilly segment of the considered road network.

Abstract-This paper presents a control architecture based on a linear MPC formulation that addresses the lane keeping and obstacle avoidance problems for a passenger car driving on low curvature roads. The proposed control design decouples the longitudinal and lateral dynamics in two successive stages. First, plausible braking or throttle profiles are defined over the prediction horizon. Then, based on these profiles, linear timevarying models of the vehicle lateral dynamics are derived and used to formulate the associated linear MPC problems. The solutions of the optimization problems are used to determine for every time step, the optimal braking or throttle command and the corresponding steering angle command. Simulations show the ability of the controller to overcome multiple obstacles and keep the lane. Experimental results on an autonomous passenger vehicle driving on slippery roads show the effectiveness of the approach.

Abstract-The operation of groups of heavy-duty vehicles at close intervehicular distances (known as platoons) has been shown to be an effective way of reducing fuel consumption. For single vehicles, it is also known that the availability of preview information on the road topography can be exploited to obtain fuel savings. The current paper aims at the inclusion of preview information in platooning by introducing a two-layer control system architecture for so-called look-ahead platooning. Here, the layers are responsible for the inclusion of preview information and real-time vehicle control for platooning, respectively. Within this framework, a control strategy is presented, where dynamic programming is used for the calculation of fuel-optimal speed profiles, while a model predictive control approach is exploited for the real-time vehicle control. The feasibility of this approach is illustrated by means of the simulation of relevant scenarios.

No abstract