Hybrid adsorbent, based on the cross-linked copolymer impregnated with hydrous iron oxide, was applied for the first time for Se(VI) adsorption from water. The influence of the initial solution pH, selenate concentration and contact time to adsorption capacity was investigated. Adsorbent regeneration was explored using a full factorial experimental design in order to optimize the volume, initial pH value and concentration of the applied NaCl solution as a reagent. Equilibrium state was described using the Langmuir model, while kinetics fitted the pseudo-first order. The maximum adsorption capacity was found to be 28.8 mg/g. Desorption efficiency increased up to 70%, and became statistically significant with the reagent concentration and pH increase, while the applied solution volume was found to be insignificant in the investigated range. Based on the results obtained, pH influence to the adsorption capacity, desorption efficiency, Fourier transform infrared (FTIR) and X-ray diffraction (XRD) analysis of loaded adsorbent, it was concluded that the outer- and inner-sphere complexation are mechanisms responsible for Se(VI) separation from water. In addition to the experiments with synthetic solutions, the adsorbent performances in drinking water samples were explored, showing the purification efficiency up to 25%, depending on the initial Se(VI) concentration and water pH. Determined sorption capacity of the cross-linked copolymer impregnated with hydrous iron oxide and its ability for regeneration, candidate this material for further research, as a promising anionic species sorbent.
Highly porous lignin-based microspheres, modified by magnetite nanoparticles, were used for the first time for the removal of selenate anions, Se(VI), from spiked and real water samples. The influence of experimental conditions: selenate concentration, adsorbent dosage and contact time on the adsorption capacity was investigated in a batch experimental mode. The FTIR, XRD, SEM techniques were used to analyze the structural and morphological properties of the native and exhausted adsorbent. The maximum adsorption capacity was found to be 69.9 mg/g for Se(VI) anions at pH 6.46 from the simulated water samples. The modified natural polymer was efficient in Se(VI) removal from the real (potable) water samples, originated from six cities in the Republic of Serbia, with an overage efficacy of 20%. The regeneration capacity of 61% in one cycle of desorption (0.5 M NaOH as desorption solution) of bio-based adsorbent was gained in this investigation. The examined material demonstrated a significant affinity for Se(VI) oxyanion, but a low potential for multi-cycle material application; consequently, the loaded sorbent could be proposed to be used as a Se fertilizer.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.