High-energy particle accelerators have been crucial in providing a deeper understanding of fundamental particles and the forces that govern their interactions. To increase the energy of the particles or to reduce the size of the accelerator, new acceleration schemes need to be developed. Plasma wakefield acceleration, in which the electrons in a plasma are excited, leading to strong electric fields (so called 'wakefields'), is one such promising acceleration technique. Experiments have shown that an intense laser pulse or electron bunch traversing a plasma can drive electric fields of tens of gigavolts per metre and above-well beyond those achieved in conventional radio-frequency accelerators (about 0.1 gigavolt per metre). However, the low stored energy of laser pulses and electron bunches means that multiple acceleration stages are needed to reach very high particle energies. The use of proton bunches is compelling because they have the potential to drive wakefields and to accelerate electrons to high energy in a single acceleration stage. Long, thin proton bunches can be used because they undergo a process called self-modulation, a particle-plasma interaction that splits the bunch longitudinally into a series of high-density microbunches, which then act resonantly to create large wakefields. The Advanced Wakefield (AWAKE) experiment at CERN uses high-intensity proton bunches-in which each proton has an energy of 400 gigaelectronvolts, resulting in a total bunch energy of 19 kilojoules-to drive a wakefield in a ten-metre-long plasma. Electron bunches are then injected into this wakefield. Here we present measurements of electrons accelerated up to two gigaelectronvolts at the AWAKE experiment, in a demonstration of proton-driven plasma wakefield acceleration. Measurements were conducted under various plasma conditions and the acceleration was found to be consistent and reliable. The potential for this scheme to produce very high-energy electron bunches in a single accelerating stage means that our results are an important step towards the development of future high-energy particle accelerators.

This report describes the conceptual steps in reaching the design of the AWAKE experiment currently under construction at CERN. We start with an introduction to plasma wakefield acceleration and the motivation for using proton drivers. We then describe the self-modulation instability -a key to an early realization of the concept. This is then followed by the historical development of the experimental design, where the critical issues that arose and their solutions are described. We conclude with the design of the experiment as it is being realized at CERN and some words on the future outlook. A summary of the AWAKE design and construction status as presented in this conference is given in [1].

The Advanced Proton Driven Plasma Wakefield Acceleration Experiment (AWAKE) aims at studying plasma wakefield generation and electron acceleration driven by proton bunches. It is a proof-of-principle R&D experiment at CERN and the world's first proton driven plasma wakefield acceleration experiment. The AWAKE experiment will be installed in the former CNGS facility and uses the 400 GeV/c proton beam bunches from the SPS. The first experiments will focus on the self-modulation instability of the long (rms ∼ 12 cm) proton bunch in the plasma. These experiments are planned for the end of 2016. Later, in 2017/2018, low energy (∼ 15 MeV) electrons will be externally injected to sample the wakefields and be accelerated beyond 1 GeV. The main goals of the experiment will be summarized. A summary of the AWAKE design and construction status will be presented.

We give direct experimental evidence for the observation of the full transverse self-modulation of a long, relativistic proton bunch propagating through a dense plasma. The bunch exits the plasma with a periodic density modulation resulting from radial wakefield effects. We show that the modulation is seeded by a relativistic ionization front created using an intense laser pulse copropagating with the proton

AWAKE is a proton-driven plasma wakefield acceleration experiment. We show that the experimental setup briefly described here is ready for systematic study of the seeded self-modulation of the 400 GeV proton bunch in the 10 m-long rubidium plasma with density adjustable from 1 to 10×10 14 cm −3 . We show that the short laser pulse used for ionization of the rubidium vapor propagates all the way along the column, suggesting full ionization of the vapor. We show that ionization occurs along the proton bunch, at the laser time and that the plasma that follows affects the proton bunch.

We observe for the first time an effect on the driver caused by the motion of ions in a plasma wakefield accelerator. The effect manifests itself as a beam tail, which only occurs when sufficient motion of ions suppresses wakefields. By changing the plasma ions (helium, argon, xenon) in the experiment, we show that the effect depends inversely on the ion mass, as predicted from theory and simulations. Wakefields are driven resonantly by multiple bunches, and simulation results indicate that the ponderomotive force causes the motion of ions. In this case, the effect is also expected to depend on the amplitude of the wakefields, as also observed by varying the bunch charge.

We investigate beam loading and emittance preservation for a high-charge electron beam being accelerated in quasi-linear plasma wakefields driven by a short proton beam. The structure of the studied wakefields are similar to those of a long, modulated proton beam, such as the AWAKE proton driver. We show that by properly choosing the electron beam parameters and exploiting two well known effects, beam loading of the wakefield and full blow out of plasma electrons by the accelerated beam, the electron beam can gain large amounts of energy with a narrow final energy spread (%-level) and without significant emittance growth.

SixTrack is a single-particle tracking code for high-energy circular accelerators routinely used at CERN for the Large Hadron Collider (LHC), its luminosity upgrade (HL-LHC), the Future Circular Collider (FCC) and the Super Proton Synchrotron (SPS) simulations. The code is based on a 6D symplectic tracking engine, which is optimized for long-term tracking simulations and delivers fully reproducible results on several platforms. It also includes multiple scattering engines for beam–matter interaction studies, as well as facilities to run the integrated simulations with external particle matter interaction codes. These features differentiate SixTrack from general-purpose, optics-design software. The code recently underwent a major restructuring to merge the advanced features into a single branch, such as multiple ion species, interface with external codes and high-performance input/output. This restructuring also removed a large number of compilation flags, instead enabling/disabling the functionality with runtime options. In the process, the code was moved from Fortran 77 to Fortran 2018 standard, also allowing and achieving a better modularization. Physics models (beam–beam effects, Radio-Frequency (RF) multipoles, current carrying wires, solenoid and electron lenses) and methods (symplecticity check) have also been reviewed and refined to offer more accurate results. The SixDesk runtime environment allows the user to manage the large batches of simulations required for accurate predictions of the dynamic aperture. SixDesk supports several cluster environments available at CERN as well as submitting jobs to the LHC@Home volunteering computing project, which enables volunteers contributing with their hardware to CERN simulation. SixTrackLib is a new library aimed at providing a portable and flexible tracking engine for single- and multi-particle problems using the models and formalism of SixTrack. The library is able to run in CPUs as well as graphical processing units (GPUs). This contribution presents the status of the code, summarizes the main existing features and provides details about the main development lines SixTrack, SixDesk and SixTrackLib.