The properties of an electron beam~e-beam! formed in air under atmospheric pressure are reported. The nanosecond generators RADAN-303~two devices! and RADAN-220, producing nanosecond voltage pulses with amplitude of up to 400 kV and subnanosecond rise time were used in the experiments. It was shown for the first time that the duration of e-beam current of gas diode behind the foil does not exceed 0.1 ns. The maximum amplitude of current of a supershort avalanche electron beam~SAEB! behind the foil was ;400 A. The data on the influence of various parameters on e-beam current amplitude measured behind the foil were obtained. An electron beam with energy less than 60 keV and powerful X-ray radiation were formed in discharge gap simultaneously with SAEB.

No abstract

We present and analyze characteristics of the runaway electron flow in a high-voltage (the voltage rise rate of up to 1.5 MV/ns) air-filled electrode gap with a strongly nonuniform electric field. It is demonstrated that such a flow contains a high-energy electron component of duration not more than 10 ps. According to numerical simulations, runaway electron generation/termination is governed by impact ionization of the gas near the cathode and switching on/off a critical (sufficient for electrons to run away) electric field at the boundary of the expanding cathode plasma. The corresponding characteristic time estimated to be 2–3 ps is defined by the ionization rate at a critical field.

No abstract

Theoretical investigation of a short electron beam (extended bunch) interaction with a backward wave propagating in a slow wave structure demonstrates the possibility of producing ultrashort superradiance pulses with a peak power which exceeds the power of the driving beam (conversion factor K>1). It is shown that a nonuniform slow wave structure with optimized profile is beneficial in order to increase the conversion factor. The results of theoretical analysis are confirmed by the experiments. At X band using the SINUS-150 accelerator (4 ns, 330 kV, 2.6 kA) 0.6-0.8 ns superradiance pulses with a peak power of 1.2 GW and a conversion factor of 1.5 were obtained. Similar experiments at Ka-band based on the RADAN-303 accelerator (1 ns, 290 kV, 2.5 kA) demonstrated production of the superradiance (SR) pulse with duration 200 ps and peak power about 1 GW (conversion factor of 1.4).

No abstract

This article presents results of theoretical and experimental studies on the production of ultrashort~a few RF cycles duration! microwave pulses of gigawatt peak powers based on superradiance from high-current electron beams. With the Cherenkov backward-wave-electron-beam interaction in a low-dispersion slow-wave structure, microwave pulses with a peak power greater than the peak power of the driving electron beam have been produced for the first time. In an experiment using the SINUS-150 compact high-current electron accelerator, with a 2.6-kA injected beam current and a 330-kV electron energy, microwave pulses of 1.2 GW peak power and ;0.5 ns duration~FWHM! were generated in the X-band. Production of superradiance pulses in a repetitive regime~3500 Hz! in the Ka-band has been demonstrated using a compact hybrid SOS-modulator. The effect of spatial accumulation of microwave energy in extended slow-wave structures with substantially nonuniform coupling has been demonstrated. In an experiment using the SINUS-200 compact accelerator, X-band pulses of ;3 GW peak power and 0.6-0.7 ns width~FWHM! were produced with a power conversion efficiency of 150-180% and an energy efficiency of ;15%.Calculations performed with various D J values have shown the following: With any value of j k . . 1, the optimum value of D J must be such~D J opt ; exp~Ϫj k !! that the region where the amplitude of the RF current saturates due to the non-188 A. A. Eltchaninov et al.

No abstract