It is actual now to work out new radiation protecting sheeting on the basis of non-curing polymeric composition which possess self-adhesion properties, are easily mounted and dismantled and provide high tightness and low permeability. Mechanical properties of non-curing composites consisting of ethylene propylene diene monomer (EPDM), industrial oil (IO), alkyl phenol-formaldehyde resin (PF) with addition of barite (52 %) to the total material volume were investigated in this article. The aim of investigation is to find optimal content of the above mentioned components at which it would be possible to get the following properties: composite would be sticky enough (peel strength not less than 4 N/cm); character of a separation would be cohesive (on a material) and thus there would be no migration of softener and satisfactory resistance of fluidity. The results showed that PF addition till 20 % in the system EPDM/PF leads to the increasing of adhesive strength, in this case optimal oil concentration in the system EPDM/PF/IO is in the interval from 45 till 55 %. New self-adhesion lead-free material, exhibited higher X-ray-shielding properties, is also received in the result of investigation.
Аннотация. В статье представлены результаты исследований по подбору состава битумнокаучукового вяжущего вибропоглощающего покрытия. Применение вибропоглощающих покрытий тонкостенных строительных конструкций позволяет значительно снизить негативные вибрации. Существующие битумные и битумно-каучуковые материалы обладают недостаточным вибропоглощением в диапазоне отрицательных температур, что недопустимо в климатических условиях России. Подбор состава битумно-каучукового вяжущего и установление зависимости его свойств позволят получить материал с широким температурным диапазоном применения. В качестве объекта исследования была выбрана полимерная матрица, представляющая собой смесь двух материалов-бутилкаучука и битума, пластифицированную маслом индустриальным И-20А; наполнитель-мел марки МТД-2. Представлена зависимость физикомеханических свойств материала от содержания битум:бутилкаучук в смеси. Установлено, что материал на основе полученного вяжущего обладает эффективным вибродемпфированием в диапазоне температур от −40 до +40 °С. Ключевые слова: вибропоглощающее покрытие; битум; каучук; физико-механические свойства; температура Уже более 20 лет в авто-, машиностроении и строительстве широко применяются вибропоглощающие материалы листового типа на основе битума [1, 2]. В настоящее время широко распространены покрытия на битумно-каучуковом вяжущем [3, 4].
Данная работа посвящена проблеме разработки вибропоглощающих полимерных материалов, эффективных в широком температурно-частотном диапазоне. В связи с тем, что эффективность демпфирования колебаний в композите главным образом определяется свойствами полимерной матрицы, изучение ее свойств в зависимости от типа и количества структурообразующих параметров является актуальной задачей. Цель статьи заключается в определении изменений динамических свойств этиленвинилацетата при добавлении в него пластификаторов различной полярности и концентрации. Ведущим методом к исследованию данной проблемы является метод динамического механического анализа, позволяющий получить информацию об изменении механических характеристик под действием динамической нагрузки и контролируемой температуры и частоты. С помощью выявленных закономерностей удалось определить тип пластификатора, существенно снижающего температуру стеклования этиленвинилацетата. Установлено процентное соотношение системы этиленвинилацетат/пластификатор и, соответственно выявлен тип пластификатора, при котором максимум механических потерь принимает наибольшие значения. Определена степень полярности пластификатора, при которой эффективность пластификатора на этиленвинилацетат наибольшая. Полученные зависимости могут быть использованы в качестве исходных данных для аналитического прогнозирования динамических механических свойств композитов. Ключевые слова: этиленвинилацетат, диоктилфталат, хлорпарафин, индустриальное масло, модуль упругости, тангенс угла механических потерь, температура. Информация об авторах Волоцкой Алексей Николаевич, аспирант кафедры строительных конструкций и машин.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.