Design, parameters, and application areas of a superconducting fault current limiter (FCL) are analyzed on the basis of the requirements of power systems. The comparison of resistive and inductive designs is carried out. An example of the effective application of FCLs in distribution substations is considered and the gain from the FCL installation is discussed. It is shown that an FCL not only limits a fault current but also increases the dynamic stability of the synchronous operation of electric machines. The calculation procedure of the parameters of an inductive FCL for a specific application case is described.Index Terms-Fault current limiter (FCL), high-temperature superconductor (HTS), power system.

No abstract

No abstract

Critical current density, ac susceptibility (real part ) and magneto-optical (MO) imaging were used to characterize round wire and tapes made from pre-reacted MgB2 powder by the powder-in-tube method. Magnetic susceptibility measurements indicated the existence of large-scale weak-link networks in the cores of as-deformed Ni/MgB2 and Cu/MgB2 wires and tapes. As-deformed samples showed a two-step transition in versus T traces as evidence of weak links in the tape core. The first heat treatment (HT) of as-deformed tapes led to a sharp susceptibility transition, very strong connection in the tape core as seen in MO images, and high critical current. A second rolling of an as-sintered tape induced a network of defects in the brittle core and gave rise to curve broadening, but did not result in a two-step transition. These data show that deformation-induced cracks are not the primary source of weak-link behaviour. A large decrease in transport current was also registered in this sample. The second HT, for 30 min, restored the sharp magnetic transition and high transport current. Alternating areas of strong and weak connection in the tape core have been observed on MO images. Fast heating and cooling of the as-deformed tape with no dwell time at the maximum temperature resulted in a strongly linked core with a sharp transition and increased transport current. After fast HT, no mechanical defects were observed in MO images. Such fast transformation could be explained by rapid sintering due to highly strained MgB2 grains.

No abstract