Tuning the electroreduction of NO3−vis-à-vis Bi3+ results in nano-/micro-hexagons. Nanohexagons are highly sensitive to trace detection of lead.

The simulation of fluidized catalytic cracking (FCC) process was performed using Aspen HYSYS. The effect of crude flow rate on naphtha flow, coke yield, and catalyst to oil ratio in FCC were simulated. The interaction effects of riser height, inlet crude flow rate and operating temperature on naphtha mass flow, catalyst to oil ratio, and coke yield were studied by Box-Behnken design. The maximum yield of naphtha (100000 kg/h) was obtained for FCC operating temperature within 520-600 • C and riser height greater than 30 m. The catalyst to oil ratio of above 12 was obtained for operating temperature beyond 590 • C for the entire riser height variation of 10 to 60 m in FCC. The increase in riser height resulted in increase production of naphtha, but beyond 60 m of riser height secondary cracking occurs resulting in reduction in yield of naphtha.

No abstract

No abstract

The effect of the Pt–Sn/α-Al2O3 catalyst reduction method on dehydrogenation of mixed-light paraffins to olefins has been studied in this work. Pt–Sn/α-Al2O3 catalysts were prepared by two different methods: (a) liquid phase reduction with NaBH4 and (b) gas phase reduction with hydrogen. The catalytic performance of these two catalysts for dehydrogenation of paraffins was compared. Also, the synergy between the catalyst reduction method and mixed-paraffin feed (against individual paraffin feed) was studied. The catalysts were examined using X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS), X-ray photoelectron spectroscopy (XPS), thermogravimetric analysis (TGA), and Brunauer–Emmett–Teller (BET) analysis. The individual and mixed-paraffin feed dehydrogenation experiments were carried out in a packed bed reactor fabricated from Inconel 600, operating at 600 °C and 10 psi pressure. The dehydrogenation products were analyzed using an online gas chromatograph (GC) with flame ionization detector (FID). The total paraffin conversion and olefin selectivity for individual paraffin feed (propane only and butane only) and mixed-paraffin feed were compared. The conversion of propane only feed was found to be 10.7% and 9.9%, with olefin selectivity of 499% and 490% for NaBH4 and hydrogen reduced catalysts, respectively. The conversion of butane only feed was found to be 24.4% and 23.3%, with olefin selectivity of 405% and 418% for NaBH4 and hydrogen reduced catalysts, respectively. The conversion of propane and butane during mixed-feed dehydrogenation was measured to be 21.4% and 30.6% for the NaBH4 reduced catalyst, and 17.2%, 22.4% for the hydrogen reduced catalyst, respectively. The olefin selectivity was 422% and 415% for NaBH4 and hydrogen reduced catalysts, respectively. The conversions of propane and butane for mixed-paraffin feed were found to be higher when compared with individual paraffin dehydrogenation. The thermogravimetric studies of used catalysts under oxygen atmosphere showed that the amount of coke deposited during mixed-paraffin feed is less compared with individual paraffin feed for both catalysts. The study showed NaBH4 as a simple and promising alternative reduction method for the synthesis of Pt–Sn/Al2O3 catalyst for paraffin dehydrogenation. Further, the studies revealed that mixed-paraffin feed dehydrogenation gave higher conversions without significantly affecting olefin selectivity.