Nanocomposite ZnO-TiO 2 powders of varying ZnO/TiO 2 molar ratios have been prepared from their salt/compound by heating at 600°C and 900°C and characterized using scanning electron microscope and X-ray diffraction techniques. The nanosized powders can decolorize/degrade brilliant golden yellow (BGY), an azo dye extensively used in textile industries, in water under solar irradiation. The effects of various parameters such as photocatalyst loading, molar ratio of ZnO/TiO 2 , pH of the solution, initial dye concentration, and irradiation time on the photodecolorization have been investigated. ZnO-TiO 2 nanocomposite (6 g/L) in the molar ratio of 1:1 or 3:1, prepared at 900°C, can efficiently decolorize about 98% of 20 mg/L BGY at pH of about 7 by 2-h illumination in sunlight. The initial dye decolorization follows pseudo-first-order kinetics. Finally, trial experiments were done using real textile wastewater to find out the effectiveness of the photocatalysts to a more complex system.
This article presents a method for the electrochemical preparation of a coating of nickel-silica nanocomposites on a carbon steel substrate. The incorporation of hydrophilic silica particles into the Ni composite coating during co-electrodeposition is so difficult due to the small size and the hydrophilicity of SiO 2 particle, generally less than 2 v% of silica is incorporated into the composite at different current densities, agitation speeds and silica concentrations. The effect of the presence of four surfactants, namely cocamidopropyl betaine (CAPB), decylglycoside (DG), cetyltrimethyl ammonium chloride (CTAC) and ammonium lauryl ether sulfate (ALES), on overcoming this problem was investigated in this research, and the surfactants were found to greatly influence the surface charge of silica, silica incorporation percentage and the microstructure of the composite. In fact, upon increasing the internal stresses, the products prepared in the presence of CAPB and DG were found to crack to some degree. CTAC was found to lead to entrapment mode silica co-deposition in the Ni coating. Furthermore, the addition of ALES into an electrolyte bath negatively supercharged silica surfaces and increased silica dispersion, which led to a dramatic increase in the silica incorporation percentages to around 14 v%. The results showed that Ni-SiO 2 composites prepared in the presence of ALES had better corrosion resistance, hardness and wear properties.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.