This study investigated the torrefaction of de-oiled Jatropha seed residue after a two-stage sequential process consisting of mechanical screw pressing and solvent extraction using n-hexane (denoted as JMS). The optimal torrefaction temperature (Tr) and torrefaction time (tr) were determined in the ranges of 260–300 °C and 10–60 min, respectively, so to achieve a better heating value and satisfactory energy densification (ED) with acceptable mass loss. Thermogravimetric analysis was employed to elucidate the thermal decomposition behaviors of JMS. By comparison with the torrefaction of Jatropha seed residue after mechanical oil extraction by screw pressing only (namely, JMET), the results indicated that the ED of the torrefaction of JMS yielding the torrefied product JMST (two-stage product) was higher than that of the torrefaction of JME giving the torrefied product JMET (single-stage product). Further, it was found that JMET contained some tar, which was attributed to a thermal reaction in the residual oil in JME during torrefaction. The tar/oil content of JMET was about 1.0–1.8 wt.% in the determined optimal conditions. Thus, the enhanced recovery of the residual oil is advantageous not only because it allows obtaining more oil from Jatropha seed residue with a positive net energy gain but also because it prevents the formation of tar in torrefied biomass products.
Abstract:Although the main purpose of the torrefaction of biomass is to produce high quality solid bio-fuel, the by-products, including liquid and gas products, are worth investigating to know their effects on the environment and the reusable possibility. Consequently, after torrefying waste bamboo chopsticks (WBCs) for producing solid bio-fuel, the liquid and gas products were examined in this study. The torrefaction target was set to produce torrefied waste bamboo chopsticks (WBC T ) retaining about 70 wt %. A proper torrefaction temperature (T r ) and torrefaction time (t r ) were found at 563 K and 40 min, respectively, for carrying out the torrefaction in a tubular furnace with carrier nitrogen. These conditions gave a solid yield (Y S ) of 69 wt % of WBC T relative to the original WBC, and 31 wt % of by-products were produced. The liquid products were composed of water as high as 62 wt %, along with some organic acids. Some medicine components were also found in the liquid products, representing potential medicine applications. During torrefaction, CO, NO x , SO 2 , and CO 2 emissions were largely discharged from 10 to 20 min of torrefaction time. O 2 , CO 2 , and H 2 O are the major compounds in the total gas products collected. Some combustible gases of C1 to C6 hydrocarbons were also produced. Moreover, the gas volume balances were computed and evaluated. The information obtained in this study is useful for the proper design, operation, pollution control, and utilization of the products.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.