No abstract

When a Josephson junction is exposed to radio frequency radiation it undergoes the inverse AC Josephson effect -the phase of the junction locks to the drive frequency. As a result, the I − V curves of the junction acquire "Shapiro steps" of quantized voltage. If the junction has three or more superconducting terminals, coupling between different pairs of contacts must be taken into account and the state of the junction evolves in a phase space of higher dimensionality. Here, we study the multi-terminal inverse AC Josephson effect in a graphene sample with four superconducting terminals. We observe correlated switching events caused by the interplay of the connected junctions on the device. Additionally, we find a competition between trivial voltage steps, which are created by the device's resistor network, and nonlinear integer and fractional steps, which are created by the device's Josephson network. We successfully simulate the observed behaviors using a modified 3-dimensional RCSJ model.

The AC Josephson effect manifests itself in the form of "Shapiro steps" of quantized voltage in Josephson junctions subject to radiofrequency (RF) radiation. This effect presents an early example of a driven−dissipative quantum phenomenon and is presently utilized in primary voltage standards. Shapiro steps have also become one of the standard tools to probe junctions made in a variety of novel materials. Here we study Shapiro steps in a widely tunable graphene-based Josephson junction in which the highfrequency dynamics is determined by the on-chip environment. We investigate the variety of patterns that can be obtained in this well-understood system depending on the carrier density, temperature, RF frequency, and magnetic field. Although the patterns of Shapiro steps can change drastically when just one parameter is varied, the overall trends can be understood and the behaviors straightforwardly simulated, showing some key differences from the conventional RCSJ model. The resulting understanding may help interpret similar measurements in more complex materials.

The dynamical properties of multiterminal Josephson junctions (MT-JJs) have attracted interest, driven by the promise of new insights into synthetic topological phases of matter and Floquet states. This effort has culminated in the discovery of Cooper multiplets in which the splitting of a Cooper pair is enabled via a series of Andreev reflections that entangle four (or more) electrons. Here, we show that multiplet resonances can also emerge as a consequence of the three-terminal circuit model. The supercurrent appears due to correlated phase dynamics at values that correspond to the multiplet condition nV 1 = −mV 2 of applied bias. Multiplet resonances are seen in nanofabricated three-terminal graphene JJs, analog three-terminal JJ circuits, and circuit simulations. The stabilization of the supercurrent is purely dynamical, and a close analog to Kapitza’s inverted pendulum problem. We describe parameter considerations that optimize the detection of the multiplet lines both for design of future devices.

The vanishing band gap of graphene has long presented challenges for making high-quality quantum point contacts (QPCs)the partially transparent p–n interfaces introduced by conventional split gates tend to short circuit the QPCs. This complication has hindered the fabrication of graphene quantum Hall Fabry–Pérot interferometers, until recent advances have allowed split-gate QPCs to operate utilizing the highly resistive ν = 0 state. Here, we present a simple recipe to fabricate QPCs by etching a narrow trench in the graphene sheet to separate the conducting channel from self-aligned graphene side gates. We demonstrate operation of the individual QPCs in the quantum Hall regime and further utilize these QPCs to create and study a quantum Hall interferometer.