The paper presents an analysis of the possible location of geological formations suitable for CO2 storage in the Upper Silesia Coal Basin, Poland. The range of the reservoir has been determined on the basis of an analysis of basic geological parameters, which determine the selection criteria for sites suitable for CO2 storage. A dynamic modelling of the CO2 distribution in the aquifer is presented. Based on the constructed model of migration, reactivity, and geochemical transport of CO2 in geological structures, it is possible to identify potential migration routes and escape sites of CO2 on the surface. The analysis of the technical and geological possibilities of CO2 storage was carried out according to the regulations of the complex Polish geological law, specifically in terms of sequestration possibilities in geological formations.
In this study, dynamic simulation models of CO2 injection into saline aquifers of the Choszczno-Suliszewo structure located in north-western Poland were constructed for two scenarios with different injection rates. The injection rates of 1 Mt CO2/year and 2 Mt CO2/year were analysed for each of the injection wells. Changes in pressures, characteristic for the sequestration process, were analysed; in addition, the spatial distribution of free CO2 saturation in the structure and carbon dioxide dissolved in brine were presented in a graphical form. The observation time of changes occurring in the rock mass in the interval of up to 1,000 years after the completion of injection was assumed. During the modelling of CO2 sequestration in Lower Jurassic aquifers in the Suliszewo model, the previously assumed CO2 injection rates were achieved for both injection scenarios. The observed pressure increase does not pose any threat to the Suliszewo structure tightness. The sequestration process was found to be highly effective due to the phenomenon of the dissolution of CO2 in brine and the resulting convection motion of brine enriched with carbon dioxide. Consequently, there is an increase in CO2 storage capacity and permanent long-term trapping of the injected carbon dioxide. The process of the displacement of injected CO2 from the collector layers to the layers constituting the reservoir sealing was observed. This phenomenon takes place in the upper parts of the Choszczno structure and is caused mainly by the locally occurring worse technical parameters of seal layers in this area.
Determining the characteristics of the dynamic behavior of carbon dioxide in a rock mass is a stage in the process of assessing a potential CO2 storage reservoir. The aim of this study was to analyze the process of CO2 storage in saline aquifers of the selected regions of the Upper Silesian Coal Basin in Poland. The construction of dynamic simulation models was based on static models of real deposit structures developed on a regional scale. Different simulation variants of the CO2 storage process were adopted, varying in terms of injection efficiency and duration of individual simulation phases. The analysis examined the influence of the degree of hydrodynamic openness of the structure on the CO2 storage process, in each of the variants. The results of numerical simulations showed that among the three analyzed geological formations, the Dębowiec formation is the most prospective for potential CO2 storage and is characterized by the most favorable geological and hydrogeological parameters. In the best variant of the simulation, in which the safety of CO2 storage in the rock mass was taken into account, the total amount of CO2 injected in a single directional well was approximately 8.54 million Mg of CO2 during 25 years of injection.
The paper presents a research study on modeling and computer simulation of injecting CO2 into the coal seams of the Upper Silesian Coal Basin, Poland connected with enhanced coal bed methane (ECBM) recovery. In the initial stage of the research activities, a structural parameter model was developed specifically with reference to the coal-bearing formations of the Upper Carboniferous for which basic parameters of coal quality and the distribution of methane content were estimated. In addition, a lithological model of the overall reservoir structure was developed and the reservoir parameters of the storage site were analyzed. In the next stage of the research, the static model was supplemented with detailed reservoir parameters as well as the thermodynamic properties of fluids and complex gases. The paper discusses a series of simulations of an enhanced coalbed methane recovery process with a simultaneous injection of carbon dioxide. The analyses were performed using the ECLIPSE software designed for simulating coal seam processes. The results of the simulations demonstrated that the total volume of CO2 injected to a designated seam in a coal mine during the period of one year equaled 1,954,213 sm3. The total amount of water obtained from the production wells during the whole period of the simulations (6.5 years) was 9867 sm3. At the same time, 15,558,906 sm3 of gas was recovered, out of which 14,445,424 sm3 was methane. The remaining 7% of the extracted gas was carbon dioxide as a result of reverse production of the previously injected CO2. However, taking into consideration the phenomena of coal matrix shrinking and swelling, the total amount of injected CO2 decreased to approximately 625,000 sm3.
The paper presents the assessment of the resources of methane considered as the main mineral in the most prospective selected areas of the Upper Silesian Coal Basin, Poland in the region of undeveloped deposits. The methane resources were estimated by means of a volumetric method at three depth levels, 1000, 1250, and 1500 m. A part of the Studzienice deposit comprising three coal seams, 333, 336, and 337, located in a methane zone was chosen for the numerical modeling of simulated methane production. The presented static 3D model has been developed using Petrel Schlumberger software. The total resources of methane in the area amount to approximately 446.5 million of Nm3. Numerical simulations of methane production from the selected coal seams with hydraulic fracturing were conducted by means of Schlumberger ECLIPSE reservoir simulator. Based on the simulations, it was concluded that, in the first six months of the simulations, water is produced from the seams, which is connected with the decrease in the rock mass pressure. The process prompts methane desorption from the coal matrix, which in turn results in a total methane production of 76.2 million of Nm3 within the five-year period of the simulations, which constitutes about 17% of total methane resources (GIP). The paper also presents a detailed analysis of Polish legislation concerning the activities aimed at prospecting, exploring, and extracting the deposits of hydrocarbons.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.