The solution behavior originating from molecular characteristics of synthetic macromolecules plays a pivotal role in many areas, in particular the life sciences. This situation necessitates the use of complementary hydrodynamic analytical methods as the only means for a complete structural understanding of any macromolecule in solution. To this end, we present a combined hydrodynamic approach for studying in-house prepared, low dispersity poly(ethylene glycols)s (PEGs), also known as poly(ethylene oxide)s (PEOs) depending on the classification used, synthesized from varying initiation sites by the living anionic ring opening polymerization. The series of linear PEGs in the molar mass range of only a few thousand to 50 000 g mol have been studied in detail via viscometry and sedimentation-diffusion analysis by analytical ultracentrifugation. The obtained estimations for intrinsic viscosity, diffusion coefficients, and sedimentation coefficients of the macromolecules in the solution-based analysis clearly showed self-consistency of the followed hydrodynamic approach. This self-consistency is underpinned by appropriate and physically sound values of hydrodynamic invariants, indicating adequate values of derived absolute molar masses. The classical scaling relations of Kuhn-Mark-Houwink-Sakurada of all molar-mass dependent hydrodynamic estimates show linear trends, allowing for interrelation of all parametric macromolecular characteristics. Differences among these are ascribed to the observation of α-end and chain-length dependent solvation of the macromolecules, identified from viscometric studies. This important information allows for analytical tracing of variations of scaling relationships and a physically sound estimation of hydrodynamic characteristics. The demonstrated self-sufficient methodology paves an important way for a complete structural understanding and potential replacement of pharmaceutically relevant PEGs by alternative macromolecules offering a suite of similar or tractably distinct physicochemical properties.
Polymer conjugated biologics form a multibillion dollar market, dominated by poly(ethylene glycol) (PEG). Recent reports linked PEGs to immunological concerns, fueling the need for alternative polymers. Therefore, we are presenting a strategy replacing PEG by poly(2-oxazoline) (POx) polymers using genetically engineered interleukin-4 (IL-4) featuring an unnatural amino acid for site-specific conjugation through bioorthogonal copper-catalyzed azide alkyne cycloaddition (CuAAC). Conjugation yields of IL-4-PEG were poor and did not respond to an increase in the copper catalyst. In contrast, POxylated IL-4 conjugates resulted in homogeneous conjugate outcome, as demonstrated electrophoretically by size exclusion chromatography and analytical ultracentrifugation. Furthermore, POxylation did not impair thermal and chemical stability, and preserved wild-type IL-4 activity for the conjugates as demonstrated by TF-1 cell proliferation and STAT-6 phosphorylation in HEK293T cells, respectively. In conclusion, POxylation provides an interesting alternative to PEGylation with superior outcome for the synthesis yield by CuAAC and resulting in conjugates with excellent thermal and chemical stress profiles as well as biological performances.
The determination of diol impurities in methoxy poly(ethylene glycol)s (mPEG)s is of high importance, e.g., in the area of pharmaceutical applications, since mPEGs are considered the gold standard—based on properties of biocompatibility, stealth effect against the immune system, and well-established procedures used in PEGylation reactions. Herein, we communicate a straightforward and fast approach for the resolution of the PEGdiol impurities in mPEG products by liquid chromatography on reversed-phase monolithic silica-rods. Thus, we utilize fine, in-house prepared and narrow dispersity mPEGs (Ð ≤ 1.1) and commercial PEGdiol standards as a reference. Most efficient analysis of diol impurities becomes possible with reversed-phase liquid chromatography that results in selective elution of the PEGdiol from mPEG macromolecule populations in partition/adsorption mode. We do this by a minimum selectivity of the population of macromolecules characterizing the narrow molar mass distributions of mPEG. Control experiments with intentionally added water at the start of the well-controlled mPEG synthesis via the living anionic ring opening polymerization of ethylene oxide clearly reconciled the existence of PEGdiol impurity in chromatographed samples. The here-demonstrated methodology allows for the resolution of diol impurities of less than one percent in elution times of only a few minutes, confirmed by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF-MS) of the collected elution fractions. The unique combination of the open flow-through pore structure of the monolithic silica rods and resultant varying accessibility of C18-derivatized pore surfaces indicates beneficial properties for robust and end-group-specific adsorption/partition liquid chromatography of synthetic macromolecules.
The synthesis of polymers with controlled molecular and structural parameters is challenging due to the required purity of the chemicals and the exclusion of protic impurities and oxygen in particular in the case of an anionic process as shown here.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.