General Methods Experimental Procedures, Reagents and Glassware All commercially available chemicals were used as purchased for the synthesis of substrates. All reactions were carried out under an atmosphere of nitrogen in oven-dried glassware with magnetic stirring, unless otherwise indicated. Acetonitrile (MeCN) was dried over CaH2, distilled and stored inside the N2-filled glovebox. Toluene, THF and dichloromethane were purified by the Innovative Technology Solvent Delivery System. Chemicals were used as obtained from the suppliers unless otherwise stated. Solvent compositions are given in (v/v). Chromatography Flash chromatography was performed with Silicycle silica gel 60 (0.040-0.063 μm grade). Analytical thin-layer chromatography was performed with commercial glass plates coated with 0.25 mm silica gel (E. Merck, Kieselgel 60 F254). Compounds were visualized under UV-light at 254 nm and oxidized in standard KMnO4 dye followed by heating if necessary. NMR Spectroscopy Proton nuclear magnetic resonance (1 H NMR) data were acquired at 400 MHz on a Bruker AVANCEIII-400 spectrometer or at 600 MHz on a Bruker DRX-600 spectrometer. Chemical shifts (δ) are reported in parts per million (ppm) relative to residual chloroform (s, 7.26 ppm) or residual acetone (2.05 ppm). Proton decoupled Carbon-13 nuclear magnetic resonance (13 C NMR) data were acquired at 101 MHz or 126 MHz on a Bruker AVANCEIII-400. Chemical shifts are reported in ppm relative to residual chloroform (77.16 ppm) or residual acetone (29.84 ppm, 206.26 ppm). Proton decoupled Fluorine-19 nuclear magnetic resonance (19 F{ 1 H} NMR) were acquired at 377 MHz on a Bruker AV400 spectrometer. Proton decoupled Phosphorus-31 nuclear magnetic resonance (31P{1H} NMR) were acquired at 162 MHz on a Bruker AV400 spectrometer. The assignment of proton and carbon signals was assisted by COSY, HSQC, HMBC and DEPT-135 experiments where necessary. Splitting patterns are designated as s, singlet; d, doublet; t, triplet; q, quartet; p, pentet; hept, heptet; dd, doublet of doublets; dt, doublet of triplets; ddd, doublet of doublets of doublets; tt, triplet of triplets; tq, triplet of quartets; qt, quartet of triplets; m, multiplet. All NMR data were recorded at 298 K. Infrared Spectroscopy Infrared (IR) data were recorded on an Alpha-P Bruker FT-IR Spectrometer. Absorbance frequencies are reported in reciprocal centimeters (cm-1). Mass Spectrometry HRMS measurements were performed on an Agilent LC-MS TOF (Multimode: ESI + APCI + APPI). High resolution mass are given in m/z. Melting Points Melting points were measured on a Büchi B-540 and are uncorrected. Enantiomeric excesses Enantiomeric excesses were measured on an Agilent HPLC and Shimadzu HPLC. Optical rotations were measured on a Polartronic M polarimeter using a 0.5 cm cell with a Na 589 nm filter.

A general and highly enantioselective arylation of carbamates derived from primary alcohols was developed by combining Hoppe's sparteine-mediated asymmetric lithiation with Negishi cross-coupling. Coupled with Aggarwal's lithiation-borylation sequence, the current method provides a short and divergent access to a variety of enantioenriched secondary and tertiary benzylic alcohols.

An efficient synthetic entry to enantioenriched 3-aminopiperidine derivatives using rhodium-catalyzed asymmetric hydrogenation of N-(1-benzylpiperidin-3-yl)enamides is described. This method provides an atom-economical and attractive route to both enantiomers of the valuable 3-aminopiperidine moiety, which is an important structural unit that can be found in many natural products and pharmaceutical drugs encompassing a broad range of biological activities. Under optimized reaction conditions, the targeted 3-aminopiperidine derivatives were obtained in high yields up to 92% and with enantiomeric excesses up to 96% after a single crystallization.

An unusual γ-selectivity was observed in the arylation of α-zincated γ,δ-unsaturated O-carbamates, which arose from the haptotropic rearrangement of the palladium–diene intermediate.

No abstract

No abstract