The growing demand for wood-based panels for buildings and furniture and the increasing worldwide concern for reducing the pressure on forest resources require alternatives to wood raw materials. The agricultural industry not only can provide raw materials from non-wood plants but also numerous residues and side streams. This review supplies an overview of the availability, chemical composition, and fiber characteristics of non-wood lignocellulosic materials and agricultural residues, i.e., grow care residues, harvest residues, and process residues, and their relevance for use in wood panel manufacturing. During the crop harvest, there are millions of tons of residues in the form of stalks, among other things. Usually, these are only available seasonally without using storage capacity. Process residues, on the other hand, can be taken from ongoing production and processed further. Fiber characteristics and chemical composition affect the panel properties. Alternatives to wood with long fibers and high cellulose content offer sufficient mechanical strength in different panel types. In general, the addition of wood substitutes up to approximately 30% provides panels with the required strength properties. However, other parameters must be considered, such as pressing temperature, adhesive type, press levels, and pretreatments of the raw material. The search for new raw materials for wood panels should focus on availability throughout the year, the corresponding chemical requirements and market competition. Panel type and production process can be adapted to different raw materials to fit niche products.
Partial liquefaction of residual biomass shows good potential for developing new materials suitable for making bio-based composites. Three-layer particleboards were produced by replacing virgin wood particles with partially liquefied bark (PLB) in the core or surface layers. PLB was prepared by the acid-catalyzed liquefaction of industrial bark residues in polyhydric alcohol. The chemical and microscopic structure of bark and residues after liquefaction were evaluated by means of Fourier Transform Infrared Spectroscopy (FTIR) and Scanning Electron Microscopy (SEM), while the particleboards were tested for their mechanical and water-related properties, as well as their emission profiles. Through a partial liquefaction process, some FTIR absorption peaks of the bark residues were lower than those of raw bark, indicating hydrolysis of chemical compounds. The surface morphology of bark did not change considerably after partial liquefaction. Particleboards with PLB in the core layers showed overall lower densities and mechanical properties (modulus of elasticity, modulus of rupture, and internal bond strength), and were less water-resistant as compared to the ones with PLB used in the surface layers. Formaldehyde emissions from the particleboards were 0.284–0.382 mg/m2·h, and thus, below the E1 class limit required by European Standard EN 13986:2004. The major emissions of volatile organic compounds (VOCs) were carboxylic acids as oxidization and degradation products from hemicelluloses and lignin. The application of PLB in three-layer particleboards is more challenging than in single-layer boards as PLB has different effects on the core and surface layers.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.