The hydrographical and dynamical properties of the upwelling filaments forming off Cap Blanc (Mauritania) are investigated using remotely sensed and in situ data collected in April/May 2009 during the strongest upwelling season. The area is situated at the southern edge of the NW African upwelling system, where the Cape Verde Frontal Zone (CVFZ) separates warmer, saltier North Atlantic Central Water (NACW) and cooler, fresher South Atlantic Central Water (SACW). Sea surface temperature images indicated the presence of an upwelling filament extending >280 km offshore, rooted over the Cap Blanc promontory and entrained around a warm‐core anticyclonic eddy. After this filament started to decay, a new cold filament developed at the approximate same location. High resolution Moving Vessel Profiler (MVP) and Acoustic Doppler Current Profiler (ADCP) surveys of these mesoscale structures revealed that both filaments were carrying South Atlantic Central Water (SACW) offshore through an intense jet‐like flow. Similarity of the relative vorticity structure across the filament with that of the tangent eddy suggested that the latter was responsible for the offshore current. Tracking of this eddy in altimetric data demonstrated that it originated from the CVFZ, as implied by its hydrographic structure. Altimetric data also revealed that another anticyclonic structure centered over the Cap Blanc promontory was responsible for the northwestward advection of SACW into the base of the filament. The results support the idea that some upwelling filaments can be produced by the interaction of an external eddy field, including topographic eddies, with the upwelled water.

The vertical structure of a recently detached Loop Current Eddy (LCE) is studied using in situ data collected with an underwater glider from August to November 2016. Altimetry and Argo data are analyzed to discuss the context of the eddy shedding and evolution as well as the origin and transformation of its thermohaline properties. The LCE appeared as a large body of nearly homogeneous water between 50 and 250 m confined between the seasonal and main thermoclines. A temperature anomaly relative to surrounding Gulf's water of up to 9.7 ∘ C was observed within the eddy core. The salinity structure had a double core pattern. The subsurface fresh core had a negative anomaly of 0.27 practical salinity unit, while the deeper saline core's positive anomaly reached 1.22 practical salinity unit. Both temperature and salinity maxima were stronger than previously reported. The saline core, of Caribbean origin, was well conserved during its journey from the Yucatan Basin to the Loop Current and at least 7 months after eddy detachment. The fresher homogeneous core resulted from surface diabatic transformations including surface heat fluxes and mixing within the top 200 m during the winter preceding eddy detachment. Heat and salt excess carried by the LCE were large and require important negative heat fluxes and positive fresh water input to be balanced. The geostrophic velocity structure had the form of a subsurface intensified vortex ring.

The OceanGliders program started in 2016 to support active coordination and enhancement of global glider activity. OceanGliders contributes to the international efforts of the Global Ocean Observation System (GOOS) for Climate, Ocean Health, and Operational Services. It brings together marine scientists and engineers operating gliders around the world: (1) to observe the long-term physical, biogeochemical, and biological ocean processes and phenomena that are relevant for societal applications; and, (2) to contribute to the GOOS through real-time and delayed mode data dissemination. The OceanGliders program is distributed across national and regional observing systems and significantly contributes to integrated, multi-scale and multi-platform sampling strategies. OceanGliders shares best practices, requirements, and scientific knowledge needed for glider operations, data collection and analysis. It also monitors global glider activity and supports the dissemination of glider data through regional and global databases, in realtime and delayed modes, facilitating data access to the wider community. OceanGliders currently supports national, regional and global initiatives to maintain and expand the capabilities and application of gliders to meet key global challenges such as improved measurement of ocean boundary currents, water transformation and storm forecast.

This study describes in detail the water masses of the Gulf of Mexico (GoM) west of 88°W based on their thermohaline properties and dissolved oxygen concentration. The existent historical information is complemented with new data from 14 cruises, Argo floats, and over one year of continuous glider monitoring. The results describe the general hydrography of the central and western GoM with focus on the difference between the water properties inside and outside Loop Current Eddies (LCEs). Caribbean Surface Water, Subtropical Underwater, and 18 °C Sargasso Sea Water (18SSW) are exclusive of the LCEs, and they are found along the LCEs preferred path between 23°N and 27°N. Outside the LCEs, the prominent characteristics of these water masses erode, and the Gulf Common Water is ubiquitous in the subsurface. It is shown that the water masses in the GoM need to be described in the frame of the dominant mesoscale features that take place there and that the dissolved oxygen is a key variable to identify some water masses of Caribbean origin as the Tropical Atlantic Central Water and the 18SSW. The previous potential temperature and salinity limits of the water masses within the GoM were revised and redefined in terms of absolute salinity and conservative temperature in the frame of the Thermodynamic Equation of Seawater, 2010 (TEOS‐10). While temperature values after conversion have little variation compared to the previous ones, the absolute salinity is in average 0.2 units greater than the former practical salinity.

High‐resolution hydrographic measurements reveal the presence of three intrathermocline eddies (ITEs) embedded within a loop current eddy. ITEs are lenticular bodies of nearly homogeneous water, which contrasts with the well‐stratified surrounding water. Their radii and thickness ranged between 19–32 km and 150–250 m. Negative relative vorticity within their cores (down to −0.85 times the Coriolis frequency), along with a large negative stratification anomaly, results in low Ertel potential vorticity and intense negative Ertel potential vorticity anomalies. Vortex stretching and relative vorticity have comparable contributions to potential vorticity anomaly, resulting in Burger numbers of order unity. The similarity of thermohaline properties within the ITE's cores and the surrounding loop current eddy water suggests that these ITEs likely form by intense mixing events followed by Rossby adjustment.

International audienceThe dynamics of the formation of layering surrounding meddy-like vortex lenses is investigated using primitive equation (PE), quasigeostrophic (QG), and tracer advection models. Recent in situ data inside a meddy confirmed the formation of highly density-compensated layers in temperature and salinity at the periphery of the vortex core. Very high-resolution PE modeling of an idealized meddy showed the formation of realistic layers even in the absence of double-diffusive processes. The strong density compensation observed in the PE model, in good agreement with in situ data, suggests that stirring might be a leading process in the generation of layering. Passive tracer experiments confirmed that the vertical variance cascade in the periphery of the vortex core is triggered by the vertical shear of the azimuthal velocity, resulting in the generation of thin layers. The time evolution of this process down to scales of O(10) m is quantified, and a simple scaling is proposed and shown to describe precisely the thinning down of the layers as a function of the initial tracer column’s horizontal width and the vertical shear of the azimuthal velocity. Nonlinear QG simulations were performed and analyzed for comparison with the work of Hua et al. A step-by-step interpretation of these results on the evolution of layering is proposed in the context of tracer stirring

In this study, we harness the 25‐year satellite‐altimeter record, in concert with a vast array of in situ measurements, to estimate the heat content anomaly of 32 warm‐core rings in the Gulf of Mexico (GoM). The decay rate of these mesoscale eddies is studied in detail, and it is shown that they release the majority of their heat as they drift in the central GoM (away from topographic obstacles). The surface heat fluxes from the eddies are shown to be small in comparison to the total rate of heat loss from the eddies, suggesting that heat is primarily released toward the surrounding water masses. Integrating the total heat evolution equation over the warm‐core rings yields an estimate of their effective lateral diffusivity coefficient. The long‐term impact of warm‐core rings on heat and salt balance in the GoM is also discussed.

We investigate the influence of bottom topography on the formation and trapping of long upwelling filaments. They use a 2-layer shallow water model on the f-plane. A wind forced alongshore current, associated with coastal upwelling along a vertical wall, encounters a promontory of finite width and length, perpendicular to the coast. In the lower layer, topographic eddies form, which are shown to drive the formation of a filament on the front. Indeed, as the upwelling current and front develop along the coast, the along shore flow crosses the promontory, rearranging the potential vorticity structure and generating intense vortical structures : water columns with high potential vorticity initially localized upon the promontory are advected into the deep ocean, forming cyclonic eddies, while water columns from the deep ocean with low potential vorticity climb on the topography forming a trapped anticyclonic circulation. These topographic eddies interact with the upper layer upwelling front and form an elongated, trapped and narrow filament. Sensitivity tests are then carried out and it is shown that : • the influence of capes is also modest in our simulations, showing that topography plays the major role in the formation of long and trapped upwelling filaments.