The effect of ultrasonication parameters, such as time and power applied, to exfoliate graphite in o-dichlorobenzene (o-DCB) and N-methyl-1,2-pyrrolidone (NMP) was examined. It was found that the concentration of graphene was higher in o-DCB, while its dispersibility was increased when sonication was applied for a longer period and/or at higher power. However, spectroscopic examination by X-ray photoelectron spectroscopy (XPS) revealed that ultrasonication causes defects and induces oxygen functional groups in the form of carboxylic acids and ethers/epoxides onto the graphene lattice. Additional proof for the latter arose from Raman, IR, and thermogravimetry studies. The carboxylic acids and ethers/epoxides onto exfoliated graphene were derived from air during ultrasonication and found independent of the solvent used for the exfoliation and the power and/or time ultrasonication applied. Quantitative evaluation of the amount of oxygenated species present on exfoliated graphene as performed by high-resolution XPS revealed that the relative oxygen percentage was higher when exfoliation was performed in NMP. Finally, the sonication time and/or power affected the oxygen content on exfoliated graphene, since extended ultrasonication resulted in a decrease in the oxygen content on exfoliated graphene, with a simultaneous increase of defected sp3 carbon atoms.

No abstract

The successful exfoliation of graphite to graphene sheets in liquid phase via tip sonication was achieved. A number of solvents were examined for several time periods and it was found that o-dichlorobenzene (o-DCB) and N-methyl-1,2-pyrolidone (NMP) are ideal solvents to exfoliate graphite and produce stable dispersions of graphene. The exfoliated graphene dispersions were characterized by complementary techniques including AFM, DLS, TGA and Raman. Furthermore, treatment of stable dispersions of exfoliated graphene sheets in NMP with poly[styrene-b-(2-vinylpyridine)] block copolymer, under acidic conditions, resulted on aqueous solubilization of graphene. Similar results were obtained, i.e. transfer of graphene from the organic to the aqueous phase, when poly(isoprene-b-acrylic acid) block copolymer was added on exfoliated graphene in NMP.

Dye-sensitized photocatalytic hydrogen generation is emerging as a promising process to produce fuels using a clean and abundant energy source such as sunlight. In the first part of this work, three organic dyes featuring a dithieno[3,2-b:2′,3′-d]silole heterocyclic unit (OB1−OB3), bearing different substituents on various parts of the molecular scaffold, were synthesized, characterized, and used as sensitizers for the commercially available benchmark TiO 2 (P25), first in dye-sensitized solar cells and then for the photocatalyzed production of hydrogen with triethanolamine as a sacrificial electron donor. In the second part of the study, aiming to improve the efficiency of the photocatalytic system, P25 was replaced with the less investigated brookite TiO 2 polymorph. The photocatalyst obtained upon sensitization with the best performing dye, OB2, still in the presence of Pt as co-catalyst, displayed an enhanced performance in hydrogen production compared to that based on P25 at a lower dye loading. Extended time experiments confirmed that the catalyst was still significantly active after 1 week under continuous illumination, providing a maximum TON of 4201. The higher efficiency of the brookite-based catalytic system and its prolonged stability are especially significant in the perspective of the practical application of the dye-sensitized photocatalytic H 2 production technology.

No abstract