When designing semiconductor heterostructures, it is expected that epitaxial alignment will facilitate low-defect interfaces and efficient vertical transport. Here, we report lattice-matched epitaxial growth of molybdenum disulfide (MoS2) directly on gallium nitride (GaN), resulting in high-quality, unstrained, single-layer MoS2 with strict registry to the GaN lattice. These results present a promising path toward the implementation of high-performance electronic devices based on 2D/3D vertical heterostructures, where each of the 3D and 2D semiconductors is both a template for subsequent epitaxial growth and an active component of the device. The MoS2 monolayer triangles average 1 μm along each side, with monolayer blankets (merged triangles) exhibiting properties similar to that of single-crystal MoS2 sheets. Photoluminescence, Raman, atomic force microscopy, and X-ray photoelectron spectroscopy analyses identified monolayer MoS2 with a prominent 20-fold enhancement of photoluminescence in the center regions of larger triangles. The MoS2/GaN structures are shown to electrically conduct in the out-of-plane direction, confirming the potential of directly synthesized 2D/3D semiconductor heterostructures for vertical current flow. Finally, we estimate a MoS2/GaN contact resistivity to be less than 4 Ω·cm(2) and current spreading in the MoS2 monolayer of approximately 1 μm in diameter.

We present a combined experimental and computational study of two-dimensional molybdenum disulfide (MoS 2 ) and the effect of temperature on the frequency shifts of the Raman-active E 2g and A 1g modes in the monolayer. While both peaks show an expected red-shift with increasing temperature, the frequency shift is larger for the A 1g more than for the E 2g mode. This is in contrast to previously reported bulk behavior, in which the E 2g mode shows a larger frequency shift with temperature. The temperature dependence of these phonon shifts is attributed to the anharmonic contributions to the ionic interaction potential in the two-dimensional system.

Molybdenum disulfide (MoS2) field effect transistors (FET) were fabricated on atomically smooth large-area single layers grown by chemical vapor deposition. The layer qualities and physical properties were characterized using high-resolution Raman and photoluminescence spectroscopy, scanning electron microscopy, and atomic force microscopy. Electronic performance of the FET devices was measured using field effect mobility measurements as a function of temperature. The back-gated devices had mobilities of 6.0 cm2/V s at 300 K without a high-κ dielectric overcoat and increased to 16.1 cm2/V s with a high-κ dielectric overcoat. In addition the devices show on/off ratios ranging from 105 to 109.

Semiconducting MoS2 monolayers have shown many promising electrical properties, and the inevitable polycrystallinity in synthetic, large-area films renders understanding the effect of structural defects, such as grain boundaries (GBs, or line-defects in two-dimensional materials), essential. In this work, we first examine the role of GBs in the electrical-transport properties of MoS2 monolayers with varying line-defect densities. We reveal a systematic degradation of electrical characteristics as the line-defect density increases. The two common MoS2 GB types and their specific roles are further examined, and we find that only tilt GBs have a considerable effect on the MoS2 electrical properties. By examining the electronic states and sources of disorder using temperature-dependent transport studies, we adopt the Anderson model for disordered systems to explain the observed transport behaviors in different temperature regimes. Our results elucidate the roles played by GBs in different scenarios and give insights into their underlying scattering mechanisms.

No abstract