Currently, concentrated electrolyte solutions are attracting special attention because of their unique characteristics such as unusually improved oxidative stability on both the cathode and anode sides, the absence of free solvent, the presence of more anion content, and the improved availability of Li + ions. Most of the concentrated electrolytes reported are lithium bis(fluorosulfonyl)imide (LiFSI) salt with ether-based solvents because of the high solubility of salts in ether-based solvents. However, their poor anti-oxidation capability hindered their application especially with high potential cathode materials (>4.0 V). In addition, the salt is very costly, so it is not feasible from the cost analysis point of view. Therefore, here we report a locally concentrated electrolyte, 2 M LiPF 6 , in ethylene carbonate/diethyl carbonate (1:1 v/v ratio) diluted with fluoroethylene carbonate (FEC), which is stable within a wide potential range (2.5−4.5 V). It shows significant improvement in cycling stability of lithium with an average Coulombic efficiency (ACE) of ∼98% and small voltage hysteresis (∼30 mV) with a current density of 0.2 mA/cm 2 for over 1066 h in Li||Cu cells. Furthermore, we ascertained the compatibility of the electrolyte for anode-free Li−metal batteries (AFLMBs) using Cu||LiNi 1/3 Mn 1/3 Co 1/3 O 2 (NMC, ∼2 mA h/ cm 2 ) with a current density of 0.2 mA/cm 2 . It shows stable cyclic performance with ACE of 97.8 and 40% retention capacity at the 50th cycle, which is the best result reported for carbonate-based solvents with AFLMBs. However, the commercial carbonate-based electrolyte has <90% ACE and even cannot proceed more than 15 cycles with retention capacity >40%. The enhanced cycle life and well retained in capacity of the locally concentrated electrolyte is mainly because of the synergetic effect of FEC as the diluent to increase the ionic conductivity and form stable anion-derived solid electrolyte interphase. The locally concentrated electrolyte also shows high robustness to the effect of upper limit cutoff voltage.
Anode-free batteries (AFBs) are impressive and recent phenomena in the era of energy storage devices due to their high energy density and relative ease of production compared to the traditional Lithium metal batteries (LMBs). However, dendrite formation during plating and stripping and low coulombic efficiency (CE) are the main challenges that impede practical implementation of these batteries. Here we report an extremely stable dual-salt electrolyte, 2M LiFSI+1M LiTFSI (2FSI+1TFSI)) in DME/DOL (1:1, v/v), system in comparison to the single salt 3M LiTFSI (3TFSI) in DME/DOL (1:1, v/v), to effectively stabilize AFB composed of LiFePO 4 cathode and bare Cu-foil anode for the first time. The electrolyte stabilized anode-free cell with the configuration Cu||LiFePO 4 via reductive decomposition of its anions and enabled the cell to be cycled with CE of 98.9% for 100 cycles. This results from the formation of stable, ion conductive and electrically insulating inorganic components rich Solid Electrolyte Interface (SEI) layer on the surface of in-situ deposited Li-metal that blocks the undesirable parasitic reaction between the deposited Li and the electrolyte. Thus, aforesaid SEI mitigates formation of dead lithium and dissolution of the in-situ deposited Li surface during repeated cycling and prolongs cycle life of the battery.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.