The interconversion between formic acid and H(2)/CO(2) using half-sandwich rhodium and ruthenium catalysts with 4,4'-dihydroxy-2,2'-bipyridine (DHBP) was investigated. The influence of substituents of the bipyridine ligand was studied. Chemical shifts of protons in bipyridine linearly correlated with Hammett substituent constants. In the hydrogenation of CO(2) /bicarbonate to formate under basic conditions, significant activations of the catalysts were caused by the electronic effect of oxyanions generated by deprotonation of the hydroxyl group. Initial turnover frequencies of the ruthenium- and rhodium-DHBP complexes increased 65- and 8-fold, respectively, compared to the corresponding unsubstituted bipyridine complexes. In the decomposition of formic acid under acidic conditions, activity enhancement by the electronic effect of the hydroxyl group was observed for the ruthenium catalyst. The rhodium-DHBP catalyst showed high activity without CO contamination in a relatively wide pH range. Pressurized H(2) can be obtained using an autoclave reactor. The highest turnover frequency and number were obtained at 80 °C. The catalytic system provides valuable insight into the use of CO(2) as a H(2) storage material by combining CO(2) hydrogenation with formic acid decomposition.

An efficient organocatalytic system was developed for the synthesis of cyclic carbonates from epoxides and CO2 (25–45 °C, 1 atm) in high-to-excellent yields (85–97%). Moreover, the 2,6-pyridinedimethanol system could be recycled several times without significant loss of activity.

Transfer hydrogenation catalyzed by an iridium catalyst with 4,4'-dihydroxy-2,2'-bipyridine (DHBP) in an aqueous formate solution exhibits highly pH-dependent catalytic activity and chemoselectivity. The substantial change in the activity is due to the electronic effect based on the acid-base equilibrium of the phenolic hydroxyl group of DHBP. Under basic conditions, high turnover frequency values of the DHBP complex, which can be more than 1000 times the value of the unsubstituted analogue, are obtained (up to 81 000 h(-1) at 80 degrees C). In addition, the DHBP catalyst exhibits pH-dependent chemoselectivity for alpha,beta-unsaturated carbonyl compounds. Selective reduction of the C=C bond of enone with high activity are observed under basic conditions. The ketone moieties can be reduced with satisfactory activity under acidic conditions. In particular, pH-selective chemoselectivity of the C=O versus C=C bond reduction was observed in the transfer hydrogenation of cinnamaldehyde.

No abstract

Sorption and dilation in the system poly(ethyl methacrylate) (PEMA) and carbon dioxide are reported for pressures up to 50 atm over the temperature range 15–85°C. The sorption isotherms were obtained gravimetrically. The dilation accompanying sorption was measured directly with a cathetometer. At low temperatures the sorption and dilation isotherms were concave toward the pressure axis in the low‐pressure region and turned to convex with increasing pressure. As the experimental temperature approached and exceeded the glass transition temperature of 61°C, both isotherms became convex or linear over the whole range of pressure. Partial molar volumes of CO2 in PEMA were obtained from sorption and dilation data, which were described well by the extended dual‐mode sorption and dilation models developed recently. The temperature dependence of the dual‐mode parameters and the isothermal glass transition are discussed.

Deuterated compounds have received increasing attention in both academia and industrial fields. However, preparations of these compounds are limited for both economic and practical reasons. Herein, convenient generation of deuterium gas (D(2)) and the preparation of deuterated compounds on a laboratory scale are demonstrated by using a half-sandwich iridium complex with 4,4'-dihydroxy-2,2'-bipyridine. The "umpolung" (i.e., reversal of polarity) of a hydrogen atom of water was achieved in consecutive reactions, that is, a cationic H(+)/D(+) exchange reaction and anionic hydride or deuteride transfer, under mild conditions. Selective D(2) evolution (purity up to 89 %) was achieved by using HCO(2)H as an electron source and D(2)O as a deuterium source; a rhodium analogue provided HD gas (98 %) under similar conditions. Furthermore, pressurized D(2) (98 %) without CO gas was generated by using DCO(2)D in D(2)O in a glass autoclave. Transfer deuterogenation of ketones gave α-deuterated alcohols with almost quantitative yields and high deuterium content by using HCO(2)H in D(2)O. Mechanistic studies show that the H(+)/D(+) exchange reaction in the iridium hydride complex was much faster than β-elimination and hydride (deuteride) transfer.

A gravimetric method for determining precisely the solubility of gases in polymers at high pressure is described. The solubilities of N2 and CO2 in low‐density polyethylene (LDPE); CO2 in polycarbonate (PC); and N2, CH4, C2H6, and CO2 in polysulfone (PSUL) have been measured as a function of pressure up to 50 atm. Most of the measured sorption isotherms agreed closely with published data, but reproducible and time‐dependent hysteresis in the sorption of CO2, C2H6, and CH4 in glassy polymers, PC, and PSUL, was observed in this study for the first time. Like the well known conditioning effect of high‐pressure CO2 on the sorption capacity of glassy polymers, these hysteresis phenomena are believed to be due to the plasticizing effect of sorbed gases. On the basis of the current data, the dual‐mode sorption model including the plasticization by sorbed gas is discussed and a primitive equation for the concentration of sorbed gases in a quasiequilibrium state of sorption or desorption is proposed.

High‐pressure sorption (up to 50 atm) for CO2, N2, and Ar in poly(vinyl benzoate) (PVB) was studied at temperatures from 25 to 70°C by a gravimetric method utilizing an electromicrobalance. The results are described by Henry's law above the glass transition temperature Tg for all gases. The dual‐mode sorption model, Henry's law plus a Langmuir isotherm, applies to the sorption isotherms of N2 and Ar in the glassy state, and the dual‐mode parameters are given. For CO2, a new type of sorption isotherm is observed below Tg. The isotherm is concave to the pressure axis in the low‐pressure region and turns into a straight line with increasing CO2 pressure which can be extrapolated back to the coordinate origin. The linear part of the isotherm is characteristic of the rubbery state, while the nonlinear part stems from glassystate behavior. The “glass transition solubility” of CO2, at which PVB film changes from the glassy to the rubbery state, decrease as the temperature increases. The disappearance of microvoids, that is, the decrease of the Langmuir capacity, may be due to a large plasticizing effect of sorbed CO2. The difference between the N2 and Ar isotherms and the CO2 isotherm is discussed from this standpoint.