No abstract

No abstract

It was revealed from the crystal structure analysis of S-ovalbumin (S-OVA) formed by alkaline treatment that Ser164, Ser236, and Ser320 take the D-amino acid residue configuration (Yamasaki et al., J Biol Chem 2003; 278:35524-35530). To address the implications of a D-configuration for these Ser residues in S-OVA formation, three mutant OVAs (S164A, S236A, and S320A) were generated to compare their thermostabilities before and after alkaline treatment. Following alkaline treatment, S236A showed a marked increase in melting temperature similar to the wild type (DT m , 19°C) which corresponded to the formation of S-OVA, whereas the increment in T m for both S164A and S320A was only 4.5°C. Furthermore, the T m value of the double mutant S164/320A remained unchanged after alkaline treatment, supporting the relevance of Ser164 and Ser320 for thermostabilization of OVA. As Arg142 was predicted to interact with D-Ser164 upon S-OVA formation, it was substituted to Ala to generate R142A. The resulting increment in T m of mutant R142A after alkaline treatment was 5.8°C. The double mutant R142/S320A was therefore prepared to eliminate the participation of Ser320 in thermostabilization, and its T m value was compared before and after alkaline treatment. As expected, the increase in T m for the double mutant was only 1.2°C. Taken together, the data suggest that D-configuration of Ser164 caused by alkaline treatment favors interaction with Arg142 through conformational changes of the side chain. These results strongly supported the participation of the configurational inversion of both Ser164 and Ser320 residues in the formation of S-OVA.

No abstract

The electrical conductivity of the matrix crystal might be a new factor to enhance matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS) sensitivity. In MALDI-MS, several compounds are used as a standard matrix. Utilization of such compounds is based on an a posteriori approach, but there is no theoretical guidance for selecting a matrix. In an attempt to further understand performance in MALDI-MS, we utilized peptide detection for random screening of a chemical library (12,383 compounds) for compounds with matrix functions in MALDI-MS. A lot of thiophene compounds were found to be a matrix, in which 2-[5-(2,4-dichlorobenzoyl)-2-thienyl] acetic acid (DCBTA) provided an important clue to measure the electrical conductivity of the matrix crystal, because the structure of DCBTA is analogous to conductive polymers and organic solar cells. Most of the crystals of standard matrices, such as alpha-cyano-4-hydroxycinnamic acid (CHCA), 3,5-dimethoxy-4-hydroxycinnamic acid [sinapinic acid, (SA)], and DCBTA showed electrical conductivity, whereas the conductivity of crystal was not observed in 2,5-dihydroxybenzoic acid (2,5-DHB). On the other hand, super-DHB using 2-hydroxy-5-methoxybenzoic acid [5-methoxysalicylic acid, (MSA)] as an additive to 2,5-DHB, improved the electrical conductivity of the crystal, that followed the enhancement of peak intensity in MS spectrum. These observations might indicate that the electrical conductivity of matrix crystals is a key consideration in obtaining efficient MALDI performance.