Rapid heating of a compressed fusion fuel by a short-duration laser pulse is a promising route to generating energy by nuclear fusion, and has been demonstrated on an experimental scale using a novel fast-ignitor geometry. Here we describe a refinement of this system in which a much more powerful, pulsed petawatt (10(15) watts) laser creates a fast-heated core plasma that is scalable to full-scale ignition, significantly increasing the number of fusion events while still maintaining high heating efficiency at these substantially higher laser energies. Our findings bring us a step closer to realizing the production of relatively inexpensive, full-scale fast-ignition laser facilities.
Direct-drive implosion experiments on the GEKKO XII laser (9 kJ, 0.5 /xm, 2 ns) with deuterium and tritium (DT) exchanged plastic hollow shell targets demonstrated fuel areal densities (pR) of -0.1 g/cm 2 and fuel densities of -600 times liquid density at fuel temperatures of -0.3 keV. (The density and pR values refer only to DT and do not include carbons in the plastic targets.) These values are to be compared with thermonuclear ignition conditions, i.e., fuel densities of 500-1000 times liquid density, fuel areal densities greater than 0.3 g/cm 2 , and fuel temperatures greater than 5 keV. The irradiation nonuniformity in these experiments was significantly reduced to a level of <5°/o in root mean square by introducing random-phase plates. The target irregularity was controlled to a 1% level. The fuel pR was directly measured with the neutron activation of Si, which was originally compounded in the plastic targets. The fuel densities were estimated from the pR values using the mass conservation relation, where the ablated mass was separately measured using the time-dependent X-ray emission from multilayer targets. Although the observed densities were in agreement with one-dimensional calculation results with convergence ratios of 25-30, the observed neutron yields were significantly lower than those of the calculations. This suggests the implosion uniformity is not sufficient to create a hot spark in which most neutrons should be generated.
A series of experiments focused on high neutron yield has been performed with the Gekko-XII green laser system [Nucl. Fusion 27, 19 (1987)]. Deuterium–tritium (DT) neutron yield of 1013 and pellet gain of 0.2% have been achieved. Based on the experimental data from more than 70 irradiations, the scaling laws of the neutron yield and the related physical quantities have been studied. Comparison of the experimental neutron yield with that obtained by using a one-dimensional fluid code has led to the conclusion that most of the neutrons produced in the stagnation phase of the computation are not observed in the experiment because of fuel–pusher mixing, possibly induced by the Rayleigh–Taylor instability. The coupling efficiency and ablation pressure have been calculated using the ion temperature measured experimentally. A coupling efficiency of 5.5% and an ablation pressure of 50 Mbar have been obtained.
A lO-kJ PW laser (LFEX) is under construction for the FlREX-I program. This paper reports a desigri overview of LFEX, the technological development of a large-aperture arrayed amplifier with modified four-pass architecture, wavefront correction, a large-aperture Faraday rotator with a superconducting magnet, a new pulse compressor arrangement,. and focus control.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.