A superconducting field-effect transistor (FET) with a 0.1pm-length gate electrode was fabricated and tested at liquid-helium temperature. Two superconducting electrodes (source and drain) were formed on the same Si substrate surface with an oxide-insulated gate electrode by a self-aligned fabrication process. Superconducting current flowing through the semiconductor (Si) between the two superconducting electrodes (Nb) was controlled by a gate-bias voltage.superconducting device with three terminals using dc A power is desired for development of superconducting integrated circuits. Several types of three-terminal superconducting devices have been proposed and experimentally tested [ 11-[5]. Superconducting field-effect transistors (FET's) have excellent input/output isolation compared with others. The first experimental superconducting FET was realized by the authors [6]. The gate electrode was formed on the opposite side of the Si single-crystal film from the two superconducting electrodes, so these devices were not suitable for integrated circuits. Takayanagi and Kawakami [7] and Ivanov et al. [8],[9] reported on superconducting FET's using compound semiconductors. The gate lengths of their devices were about 0.5 and 0.4 pm, respectively, much larger than that of shortchannel Si MOSFET's. A smaller gate length is necessary to improve the switching speed of the superconducting FET's and to realize highly integrated circuits, because a small gatelength superconducting FET has a larger superconducting current to drive the next stage. However, planar devices with a short gate length have been difficult to fabricate on one side of a Si single crystal because the two superconducting electrodes are less than 0.2 pm apart in a Si semiconductor substrate and the gate electrodes must lie between the two.In this paper we describe the fabrication and operation of a superconducting FET with a gate length as short as 0.1 pm. This FET has a planar structure with a gate electrode between the two superconducting electrodes on the same side of a Si single crystal. The electric characteristics are measured at 4.2 K and the static characteristics are discussed.A cross-sectional view is shown in Fig. 1. The device has a single-crystal Si substrate, two As+ ion-implanted areas, a gate oxide, a poly-Si gate electrode, and a superconducting source and drain. The original aspect of this structure is the 0.1 -pm-length gate electrode with an overhang and insulating sidewalls of very thin Si3N4 film. A top view of the device and a scanning-electron micrograph of the gate structure are shown in Fig. 2(a) and (b), respectively. Fig. 1. Cross-sectional view of the superconducting FET with 0.1-pm gate \ , / Sdurce electrode(Nb1 Drain electrode(Nb) (a) -150nm (b) scanning electron micrograph of the gate structure (cross-sectional view).Fig. 2. (a) Micrograph of the superconducting FET (top view) and (b)A multilayer of gate oxide, doped poly-Si, and Si3N4 was formed on a surface of the p-Si single-crystal substrate. The gate oxide was a therma...
Current-voltage measurements for Au/Nb-doped-SrTiO3 contacts have been performed over a temperature range from 4.2 to 277 K. The forward characteristics above 46 K are well described by the Schottky diode model. The temperature dependence of the parameter E{=[∂log I/∂(qV)]−1} and the saturation current IS show that a thermionic-field emission is dominant in the carrier transport mechanism across contacts above 101 K. It is found that the parameter E is too large compared with an estimated value from the Schottky diode model using a permittivity obtained from the inverse characteristics of capacitance-voltage measurements. We discuss the barrier properties and suggest the possibility of imperfect ionization of the impurity Nb at the surface of the SrTiO3:Nb substrate.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.