Amphiphilic bilayers with a pore were simulated using a coarse grained model. By stretching the bilayer to 70% beyond its equilibrium surface area, we established the phase diagram of pores, identifying regions where pores are stable, metastable, or unstable. A simple theoretical model is proposed to explain the phase diagram, and to calculate the critical and equilibrium relative stretches. Interestingly, these are found to scale with the inverse cubic root of the number of amphiphiles in the bilayer, thus explaining the order of magnitude difference between the simulated and the measured values. Three different methods are used to calculate a line tension coefficient of (3.5-4.0) x 10(-11) J/m, in good agreement with experimental data.

The formation of a pore in a membrane requires a considerable rearrangement of the amphiphilic molecules about to form the bilayer edge surrounding the pore, and hence is accompanied by a steep increase of the free energy. Recent rupture and conductance experiments suggest that this reshuffling process is also responsible for a small energy barrier that stabilizes "prepores" with diameters of less than 1 nm, rendering both the opening and closing of pores an activated process. We use the potential of mean constraint force method to study this free energy profile, as a function of pore radius, in a coarse grained bilayer model. The calculations show that the free energy rises by (15-20) kT during pore opening, making it an extremely rare nucleation event. Although we do not observe a barrier to pore closure, the results do make the existence of such a barrier plausible. For larger pores we find a smooth transition to Litster's model, from which a line tension coefficient of about 3.7 x 10(-11) J m(-1) is deduced.

The influence of solvation on the conformational isomerism of calix[4]arene and p-tert-butylcalix[4]arene has been investigated by using the continuum model reported by Miertus, Scrocco, and Tomasi (MST). The quantum mechanical (QM) and semiclassical (SC) formalisms of the MST model have been considered for two different solvents (chloroform and water). The suitability of the QM-MST and SC-MST methods has been examined by comparison with previous results derived from classical molecular dynamics (MD) simulations with explicit solvent molecules. The application of the continuum model to the solute configurations generated by using in vacuo classical MD simulations provides a fast strategy to evaluate the effects of the solvent on the conformational preferences of calixarenes. These encouraging results allow us to propose the use of continuum models to solutes with complex molecular structures, which are traditionally studied by MD simulations.

We study the adhesion and friction for three tire tread rubber compounds. The adhesion study is for a smooth silica glass ball in contact with smooth sheets of the rubber in dry condition and in water. The friction studies are for rubber sliding on smooth glass, concrete, and asphalt road surfaces. We have performed the Leonardo da Vinci-type friction experiments and experiments using a linear friction tester. On the asphalt road, we also performed vehicle breaking distance measurements. The linear and non-linear viscoelastic properties of the rubber compounds were measured in shear and tension modes using two different Dynamic Mechanical Analysis (DMA) instruments. The surface topography of all surfaces was determined using stylus measurements and scanned-in silicon rubber replicas. The experimental data were analyzed using the Persson contact mechanics and rubber friction theory.