Abstract. The potential of a number of tetraaza-macrocyclic complexes of cobalt and nickel to mediate the photoreduction of carbon dioxide has been studied. Carbon monoxide and hydrogen are the main products, which result from illumination of an aqueous solution containing Ru(2,2'-bipyridine):+ as sensitizer, ascorbic acid as sacrificial eletron donor and a tetraaza-macrocyclic complex as relay. Their ratio strongly depends upon the relay compound used. The complexes can be used as electrocatalysts for CO, reduction at a mercury electrode since they lower the overpotential for CO, reduction showing turnover numbers/hour of approximately 3. A minimum potential is required to induce reaction of electrocatalysts and CO, (and H,O). Finally, the redox properties of the macrocyclic metal complexes at p-GaP and p-GaAs photocathodes in acetonitrile are compared with those observed at Pt.
Composites consisting of polymer matrix materials and natural or synthetic layered minerals e.g. clays were prepared by using special compatibilizing agents between these two intrinsically non‐miscible components. Block or graft copolymers combining one part of the polymer that is identically and/or completely miscible with the organic polymer and another part that is compatible with the natural mineral are applied to act as compatibilizer. The interaction between the first part of the compatibilizer is preferentially an ionic interaction or an interaction via hydrogen bonds. This interaction leads to a separation of the mineral into single sheets and/or small clusters containing approximately 2–10 sheets and a subsequent homogeneous incorporation of these clusters into the polymer matrix material.
Biosensors based on Pt or Pt/Ir based needle-type microelectrodes have been successfully employed for continuous in vivo real-time brain biomonitoring of biomarkers such as glutamate and glucose. However, when implanted, these biosensors often bend, thereby damaging its surface and degrading its bioanalytical properties. In addition, downscaling of Pt and Pt/Ir needle-type biosensors, to improve the spatial resolution and decrease tissue damage, is technically challenging. In that sense, we investigated whether the use of a material with low malleability, tungsten (W), coated with a highly conductive material, gold (Au) could be as an alternative for conventional needle-type based biosensors.Therefore, we developed implantable needle-type (50 m Ø) gold coated tungsten (W-Au) amperometric microbiosensors. First, we evaluated electrochemically, the ability of W-Au microelectrodes (50 m Ø) to continuously monitor changes in H 2 O 2 . After, we functionalized, using a layer-by-layer assembly, the surface of W-Au microelectrodes. First with permselective membrane(s) (Nafion and Nafion-PPD) and after with an enzymatic hydrogel, containing an enzyme selective for glucose (glucose oxidase). Both the enzyme loading and the applied potential were optimized and the performance of functionalized W-Au microelectrodes and fully assembled biosensors was evaluated electrochemically. Additionally, the surface of bare and functionalized microelectrodes was also characterized by imaging techniques (scanning electron microscopy).In vivo experiments revealed that, W-Au based glucose biosensors, were able to accurately monitor, in real-time, changes in brain glucose in response to relevant pharmacological challenges.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.