Recently, very exciting optoelectronic properties of Topological insulators (TIs) such as strong light absorption, photocurrent sensitivity to the polarization of light, layer thickness and size dependent band gap tuning have been demonstrated experimentally. Strong interaction of light with TIs has been shown theoretically along with a proposal for a TIs based broad spectral photodetector having potential to perform at the same level as that of a graphene based photodetector. Here we demonstrate that focused ion beam (FIB) fabricated nanowires of TIs could be used as ultrasensitive visible-NIR nanowire photodetector based on TIs. We have observed efficient electron hole pair generation in the studied Bi2Se3 nanowire under the illumination of visible (532 nm) and IR light (1064 nm). The observed photo-responsivity of ~300 A/W is four orders of magnitude larger than the earlier reported results on this material. Even though the role of 2D surface states responsible for high reponsivity is unclear, the novel and simple micromechanical cleavage (exfoliation) technique for the deposition of Bi2Se3 flakes followed by nanowire fabrication using FIB milling enables the construction and designing of ultrasensitive broad spectral TIs based nanowire photodetector which can be exploited further as a promising material for optoelectronic devices.

Graphene-based nanocomposites have proven to be very promising materials for gas sensing applications. In this paper, we present a general approach for the preparation of graphene-WO(3) nanocomposites. Graphene-WO(3) nanocomposite thin-layer sensors were prepared by drop coating the dispersed solution onto the alumina substrate. These nanocomposites were used for the detection of NO(2) for the first time. TEM micrographs revealed that WO(3) nanoparticles were well distributed on graphene nanosheets. Three different compositions (0.2, 0.5 and 0.1 wt%) of graphene with WO(3) were used for the gas sensing measurements. It was observed that the sensor response to NO(2) increased nearly three times in the case of graphene-WO(3) nanocomposite layer as compared to a pure WO(3) layer at room temperature. The best response of the graphene-WO(3) nanocomposite was obtained at 250 °C.

A boron-doped few-layer LPCVD graphene sensor is successfully designed and demonstrated for enhanced NH3 gas sensing applications.

Since last few years, research based on topological insulators (TI) is in great interests due to intrinsic exotic fundamental properties and future potential applications such as quantum computers or spintronics. The fabrication of TI nanodevices and study on their transport properties mostly focused on high quality crystalline nanowires or nanoribbons. Here we report robust approach of Bi 2 Se 3 nanowire formation from deposited flakes using ion beam milling method. The fabricated Bi 2 Se 3 nanowire devices have been employed to investigate the robustness of topological surface state (TSS) to gallium ion doping and any deformation in the material due to fabrication tools. We report the quantum oscillations in magnetoresistance curves under the parallel magnetic field. The resistance versus magnetic field curves have been studied and compared with Aharonov-Bohm (AB) interference effects which further demonstrate the transport through TSS. The fabrication route and observed electronic transport properties indicate clear quantum oscillations and can be exploited further in studying the exotic electronic properties associated with TI based nanodevices.

Since the discovery of topological insulators (TIs), there are considerable interests in demonstrating metallic surface states (SS), their shielded robust nature to the backscattering and study their properties at nanoscale dimensions by fabricating nanodevices. Here we address an important scientific issue related to TI whether one can clearly demonstrate the robustness of topological surface states (TSS) to the presence of disorder that does not break any fundamental symmetry. The simple straightforward method of FIB milling was used to synthesize nanowires of BiSe which we believe is an interesting route to test robustness of TSS and the obtained results are new compared to many of the earlier papers on quantum transport in TI demonstrating the robustness of metallic SS to gallium (Ga) doping. In the presence of perpendicular magnetic field, we have observed the co-existence of Shubnikov-de Haas oscillations and linear magnetoresistance (LMR), which was systematically investigated for different channel lengths, indicating the Dirac dispersive surface states. The transport properties and estimated physical parameters shown here demonstrate the robustness of SS to the fabrication tools triggering flexibility to explore new exotic quantum phenomena at nanodevice level.

All scale hierarchical architecturing, matrix/inclusion band alignment and intra-matrix electronic structure engineering, the so called panoscopic approach for thermoelectric materials has been demonstrated to be an effective paradigm for optimizing high ZT. To achieve such hierarchically organized microstructures, composition engineering has been considered to be an efficient strategy. In this work, such a panoscopic concept has been extended to demonstrate for the first time in the case of half-Heusler based thermoelectric materials via a composition engineering route. A series of new off-stoichiometric n-type Zr0.7Hf0.3Ni1+xSn (0 ≤x≤ 0.10) HH compositions have been modified to derive HH(1 -x)/full-Heusler (FH)(x) composite with an all scale hierarchically modified microstructure with FH inclusions within the matrix to study the temperature dependent thermoelectric properties. The structural analysis employing XRD, FE-SEM and HR-TEM of these materials reveal a composite of HH and FH, with hierarchically organized microstructures. In such a submicron/nano-composite, the electronic properties are observed to be well optimized yielding a large power factor; α(2)σ (∼30.7 × 10(-4) W m(-1) K(-2) for Zr0.7Hf0.3Ni1.03Sn) and reduced thermal conductivity (∼2.4 W m(-1) K(-1) for Zr0.7Hf0.3Ni1.03Sn) yielding a high ZT∼ 0.96 at 773 K for composition Zr0.7Hf0.3Ni1.03Sn which is ∼250% larger than the normal HH Zr0.7Hf0.3NiSn (ZT∼ 0.27 at 773 K). The enhancement in ZT of these composites has been discussed in terms of primary electron filtering, electron injection and several phonon scattering mechanisms such as alloy scattering, point defect scattering, and grain boundary scattering. The Bergman and Fel model is used to calculate effective thermoelectric parameters of these composites for comparing the experimental results.

Zintl compounds are potential candidates for efficient thermoelectric materials, because typically they are small band gap semiconductors. In addition, such compounds allow fine tuning of the carrier concentration by chemical doping for the optimization of thermoelectric performance. Herein, such tunability is demonstrated in Mg3Sb2-based Zintl compounds via Zn(2+) doping at the Mg(2+) site of the anionic framework (Mg2Sb2)(2-), in the series Mg3-xZnxSb2 (0 ≤ x ≤ 0.1). The materials have been successfully synthesized using the spark plasma sintering (SPS) technique. X-ray diffraction (XRD) analysis confirms a single solid solution phase of Mg3-xZnxSb2 (0 ≤ x ≤ 0.1). The thermoelectric properties are characterized by the Seebeck coefficient, electrical conductivity, and thermal conductivity measurements from 323 K to 773 K. Isoelectronic Zn substitution at the Mg site presents the controlled variation in the carrier concentration for optimizing the high power factor and reduced thermal conductivity. These results lead to a substantial increase in ZT of 0.37 at 773 K for a composition with x = 0.10 which is ∼42% higher than undoped Mg3Sb2. The electronic transport data for the Mg3-xZnxSb2 (0 ≤ x ≤ 0.1) compound are analyzed using a single parabolic band model predicting that Mg2.9Zn0.1Sb2 exhibits a near-optimal carrier concentration for high ZT. The electronic structure of transport properties of these disordered Mg3-xZnxSb2 (0 ≤ x ≤ 0.1) is also studied using density functional theory and the results obtained are in good agreement with experimental results. The low cost, lightness and non-toxicity of the constituent elements make these materials ideal for mid-temperature thermoelectric applications.

Due to miniaturization of device dimensions, the next generation’s photodetector based devices are expected to be fabricated from robust nanostructured materials. Hence there is an utmost requirement of investigating exotic optoelectronic properties of nanodevices fabricated from new novel materials and testing their performances at harsh conditions. The recent advances on 2D layered materials indicate exciting progress on broad spectral photodetection (BSP) but still there is a great demand for fabricating ultra-high performance photodetectors made from single material sensing broad electromagnetic spectrum since the detection range 325 nm–1550 nm is not covered by the conventional Si or InGaAs photodetectors. Alternatively, Bi2Te3 is a layered material, possesses exciting optoelectronic, thermoelectric, plasmonics properties. Here we report robust photoconductivity measurements on Bi2Te3 nanosheets and nanowires demonstrating BSP from UV to NIR. The nanosheets of Bi2Te3 show the best ultra-high photoresponsivity (~74 A/W at 1550 nm). Further these nanosheets when transform into nanowires using harsh FIB milling conditions exhibit about one order enhancement in the photoresponsivity without affecting the performance of the device even after 4 months of storage at ambient conditions. An ultra-high photoresponsivity and BSP indicate exciting robust nature of topological insulator based nanodevices for optoelectronic applications.