Like bone mass, bone quality is specified in development, actively maintained post-natally, and disrupted by disease. The roles of osteoblasts, osteoclasts, and osteocytes in the regulation of bone mass are increasingly well defined. However, the cellular and molecular mechanisms by which bone quality is regulated remain unclear. Proteins that remodel bone extracellular matrix, such as the collagen-degrading matrix metalloproteinase (MMP)-13, are likely candidates that regulate bone quality. Using MMP-13 deficient mice, we examined the role of MMP-13 in the remodeling and maintenance of bone matrix and subsequent fracture resistance. Throughout the diaphysis of MMP-13-deficient tibiae, we observed elevated nonenzymatic crosslinking and concentric regions of hypermineralization, collagen disorganization, and canalicular malformation. These defects localize to the same mid-cortical bone regions where osteocyte lacunae and canaliculi exhibit MMP-13 and tartrate-resistant acid phosphatase (TRAP) expression, as well as the osteocyte marker Sclerostin. Despite otherwise normal measures of osteoclast and osteoblast function, dynamic histomorphometry revealed that remodeling of osteocyte lacunae is impaired in MMP-13−/− bone. Analysis of MMP-13−/− mice and their wild-type littermates in normal and lactating conditions showed that MMP-13 is not only required for lactation-induced osteocyte perilacunar remodeling, but also for the maintenance of bone quality. The loss of MMP-13, and the resulting defects in perilacunar remodeling and matrix organization, compromise MMP-13−/− bone fracture toughness and post-yield behavior. Taken together, these findings demonstrate that osteocyte perilacunar remodeling of mid-cortical bone matrix requires MMP-13 and is essential for the maintenance of bone quality.

It was hypothesized that applying the polymer-induced liquid-precursor (PILP) system to artificial lesions would result in time-dependent functional remineralization of carious dentin lesions that restores the mechanical properties of demineralized dentin matrix. 140 µm deep artificial caries lesions were remineralized via the PILP process for 7–28 days at 37°C to determine temporal remineralization characteristics. Poly-L-aspartic acid (27 KDa) was used as the polymeric process-directing agent and was added to the remineralization solution at a calcium-to-phosphate ratio of 2.14 (mol/mol). Nanomechanical properties of hydrated artificial lesions had a low reduced elastic modulus (ER = 0.2 GPa) region extending about 70 μm into the lesion, with a sloped region to about 140 μm where values reached normal dentin (18–20 GPa). After 7 days specimens recovered mechanical properties in the sloped region by 51% compared to the artificial lesion. Between 7–14 days, recovery of the outer portion of the lesion continued to a level of about 10 GPa with 74% improvement. 28 days of PILP mineralization resulted in 91% improvement of ER compared to the artificial lesion. These differences were statistically significant as determined from change-point diagrams. Mineral profiles determined by micro x-ray computed tomography were shallower than those determined by nanoindentation, and showed similar changes over time, but full mineral recovery occurred after 14 days in both the outer and sloped portions of the lesion. Scanning electron microscopy and energy dispersive x-ray analysis showed similar morphologies that were distinct from normal dentin with a clear line of demarcation between the outer and sloped portions of the lesion. Transmission electron microscopy and selected area electron diffraction showed that the starting lesions contained some residual mineral in the outer portions, which exhibited poor crystallinity. During remineralization, intrafibrillar mineral increased and crystallinity improved with intrafibrillar mineral exhibiting the orientation found in normal dentin or bone.

The polycomb group gene Bmi1 is required for maintenance of adult stem cells in many organs1, 2. Inactivation of Bmi1 leads to impaired stem cell self-renewal due to deregulated gene expression. One critical target of BMI1 is Ink4a/Arf, which encodes the cell cycle inhibitors p16ink4a and p19Arf3. However, deletion of Ink4a/Arf only partially rescues Bmi1 null phenotypes4, indicating that other important targets of BMI1 exist. Here, using the continuously-growing mouse incisor as a model system, we report that Bmi1 is expressed by incisor stem cells and that deletion of Bmi1 resulted in fewer stem cells, perturbed gene expression, and defective enamel production. Transcriptional profiling revealed that Hox expression is normally repressed by BMI1 in the adult, and functional assays demonstrated that BMI1-mediated repression of Hox genes preserves the undifferentiated state of stem cells. As Hox gene upregulation has also been reported in other systems when Bmi1 is inactivated1, 2, 5–7, our findings point to a general mechanism whereby BMI1-mediated repression of Hox genes is required for the maintenance of adult stem cells and for prevention of inappropriate differentiation.

No abstract

This study tested the hypothesis that bioactive coating glass (SiO(2)-CaO-P(2)O(5)-MgO-K(2)O-Na(2)O system), used for implant coatings, enhanced the induction of collagen type 1 synthesis and in turn enhanced the expression of downstream markers alkaline phosphatase, Runx2 and osteocalcin during osteoblast differentiation. The ions from experimental bioactive glass (6P53-b) and commercial Bioglass(TM) (45S5) were added to osteoblast-like MC3T3-E1 subclone 4 cultures as a supplemented ion extract (glass conditioned medium (GCM)). Ion extracts contained significantly higher concentrations of Si and Ca (Si, 47.9+/-10.4 ppm; Ca, 69.8+/-14.0 for 45S5; Si, 33.4+/-3.8 ppm; Ca, 57.1+/-2.8 ppm for 6P53-b) compared with the control extract (Si<0.1 ppm, Ca 49.0 ppm in alpha-MEM) (ANOVA, p<0.05). Cell proliferation rate was enhanced (1.5x control) within the first 3 days after adding 45S5 and 6P53-b GCM. MC3T3-E1 subclone 4 cultures were then studied for their response to the addition of test media (GCM and control medium along with ascorbic acid (AA; 50 ppm)). Each GCM+AA treatment enhanced collagen type 1 synthesis as observed in both gene expression results (day 1, Col1alpha1, 45S5 GCM+AA: 3x control+AA; 6P53-b GCM+AA: 4x control+AA; day 5, Col1alpha2, 45S5 GCM+AA: 3.15x control+AA; 6P53-b GCM+AA: 2.35x control+AA) and in histological studies (Picrosirius stain) throughout the time course of early differentiation. Continued addition of each GCM and AA treatment led to enhanced expression of alkaline phosphatase (1.4x control+AA after 5 days, 2x control+AA after 10 days), Runx2 (2x control+AA after 7 days) and osteocalcin gene (day 3, 45S5 GCM+AA: 14x control+AA; day 5, 6P53-b GCM+AA: 19x control+AA) and protein expression (40x-70x control+AA after 6 days). These results indicated the enhanced effect of bioactive glass ions on key osteogenic markers important for the bone healing process.

The relative motion between the tooth and alveolar bone is facilitated by the soft-hard tissue interfaces which include periodontal ligament-bone (PDL-bone) and periodontal ligamentcementum (PDL-cementum). The soft-hard tissue interfaces are responsible for attachment and are critical to the overall biomechanical efficiency of the bone-tooth complex. In this study, the PDLbone and PDL-cementum attachment sites in human molars were investigated to identify the structural orientation and integration of the PDL with bone and cementum. These attachment sites were characterized from a combined materials and mechanics perspective and were related to macro-scale function.High resolution complimentary imaging techniques including atomic force microscopy, scanning electron microscopy and micro-scale X-ray computed tomography (Micro XCT™) illustrated two distinct orientations of PDL; circumferential-PDL (cir-PDL) and radial-PDL (rad-PDL). Within the PDL-space, the primary orientation of the ligament was radial (rad-PDL) as is well known. Interestingly, circumferential orientation of PDL continuous with rad-PDL was observed adjacent to alveolar bone and cementum. The integration of the cir-PDL was identified by 1 to 2 μm diameter PDL-inserts or Sharpey's fibers in alveolar bone and cementum. Chemically and biochemically the cir-PDL adjacent to bone and cementum was identified by relatively higher carbon and lower calcium including the localization of small leucine rich proteins responsible for maintaining soft-hard tissue cohesion, stiffness and hygroscopic nature of PDL-bone and PDLcementum attachment sites. The combined structural and chemical properties provided graded stiffness characteristics of PDL-bone (E r range for PDL: 10 -50 MPa; bone: 0.2 -9.6 GPa) and PDL-cementum (E r range for cementum: 1.1 -8.3 GPa), which was related to the macro-scale function of the bone-tooth complex.

This study demonstrates A-PRF alone or augmented with FDBA is a suitable biomaterial for ridge preservation. This study represents the first randomized controlled clinical trial comparing A-PRF with and without FDBA to FDBA alone for ridge preservation.

In this study, a comparison between structure, chemical composition and mechanical properties of collagen fibers at three regions within a human periodontium, has enabled us to define a novel tooth attachment mechanism. The three regions include 1) the enthesis region: insertion site of periodontal ligament fibers (collagen fibers) into cementum at the root surface, 2) bulk cementum and 3) the cementum dentin junction (CDJ). Structurally, continuity in collagen fibers was observed from the enthesis, through bulk cementum and CDJ. At the CDJ the collagen fibers split into individual collagen fibrils and intermingled with the extracellular matrix of mantle dentin. Under wet conditions, the collagen fibers at the three regions exhibited significant swelling suggesting a composition rich in polyanionic molecules such as glycosaminoglycans. Additionally, site-specific indentation illustrated a comparable elastic modulus between collagen fibers at the enthesis (1 -3 GPa) and the CDJ (2 -4 GPa). However, the elastic modulus of collagen fibers within bulk cementum was higher (4 -7 GPa) suggesting presence of extrafibrillar mineral.It is known that the tooth forms a fibrous joint with the alveolar bone which is termed a gomphosis. Although narrower in width than the periodontal ligament space, the hygroscopic CDJ can also be termed as a gomphosis; a fibrous joint between cementum and root dentin capable of accommodating functional loads similar to that between cementum and alveolar bone. From an engineering perspective, it is proposed that a tooth contains two fibrous joints that accommodate the masticatory cyclic loads. These joints are defined by the attachment of dissimilar materials via graded stiffness interfaces, such as; 1) alveolar bone attached to cementum with the PDL and 2) cementum to root dentin with the CDJ. Thus, through variations in concentrations of basic constituents, distinct regions with characteristic structures and graded properties allow for attachment and the load bearing characteristics of a tooth.