Based on previous Computational Fluid Dynamics (CFD) design results, an 11 channel microreactor of dimensions (0.5 mm × 0.5 mm × 100 mm) (width × depth × length) and optimal manifold geometry was fabricated, coated with a newly-developed Au/SBA-15 catalyst and then integrated in an experimental rig specifically built for this research. Propane (as model volatile organic compound) oxidation experiments were conducted at three different flow velocities, 12.5, 15.4 and 17.5 m/min, respectively, at six temperatures, 150, 200, 225, 250, 275, and 300 °C, respectively. The catalyst was prepared by one-pot sol-gel synthesis of SBA-15 with MPTMS (3-mercaptopropyl-trimethoxy-silane) before loading with HAuCl4 gold precursor and then characterized by SEM/EDX, TEM and wide angle XRD. A novel catalyst coating technique was developed, using airbrush (0.3 nozzle) to spray a catalyst slurry into the microchannels that produced a thin, firm and uniform layer of Au/SBA-15 catalyst coating inside the microreactor. The experimental measurements revealed that propane conversion increased as the flow feed rates decreased and increased with increasing temperatures in the reactor. For the built microreactor and for the flows and temperatures set, the combustion of propane was possible with measurable conversions and reasonable reactor stability, the performance of the catalyst appeared to be central to the satisfactory operation of the reactor.
This paper deals with the design of a suitable microreactor for the catalytic oxidation of volatile organic compounds (VOCs). There are a number of ways to release VOCs into the atmosphere, typically during processing of natural gas and handling petroleum products. As VOCs are harmful to our health, there is increased scientific interest in developing technologies for their destruction. Catalytic oxidation is one of them. Microreactors have showed higher efficiency than the conventional ones, mainly due to their large surface area to volume ratio and excellent heat and mass transfer properties. The design of a microreactor can be explored based on simulation results obtained by using computational fluid dynamics (CFD) package of COMSOL Multiphysics. The first design step, based on cold flow simulation, was the selection of the most suitable microreactor geometry and configuration. Four different geometries had been proposed and simulated to evaluate the fluid behaviour in the microchannels. One of them, Type A2, allowed the most uniform flow distribution in all channels, as assessed through relative standard deviation calculations. The second design step involved the investigation of the VOCs catalytic oxidation, using propane as model molecule, occurring in the microreactor with the geometry/configuration previously found. The proposed microreactor consists of eleven parallel channels of square cross-section, with 0.5 × 10 -3 m width, 0.5 × 10 -3 m height and 0.1 m length. The catalytic microreactor was simulated for temperatures between 563 K and 663 K and inlet flow velocities from 0.01 to 1.00 m·s -1 . The exit propane conversion increased rapidly with increasing temperature for a fixed inlet flow velocity. For a fixed temperature, the propane conversion increased as the inlet flow velocity decreased.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.