Photocrosslinkable polymers such as gelatin methacrylate (GelMA) have various 3D bioprinting applications. These polymers crosslink upon exposure to UV irradiation with the existence of an appropriate photoinitiator. Two photoinitiators, Irgacure 2959 and lithium phenyl-2,4,6-trimethylbenzoylphosphinate (LAP) are commonly used. This study systematically investigates the effects of photoinitiator types on the cell viability, physical properties, and microstructure in 3D bioprinting of GelMA-based cellular constructs. The main conclusions are: (1) during the 3D bioprinting, the cell viability generally decreases as the photoinitiator concentration and printing time increase using both Irgacure 2959 and LAP. At the low photoinitiator concentrations (such as 0.3% and 0.5% (w/v)), the overall cell viability is good within the printing time of 60 min using both Irgacure 2959 and LAP. However, at the high photoinitiator concentrations (such as 0.7% and 0.9% (w/v)), the overall cell viability using LAP is much higher than that using Irgacure 2959 within the printing time of 60 min; (2) after the 3D bioprinting, the photoinitiator types, either Irgacure 2959 or LAP, have negligible effects on the post-printing cell viability after crosslinking; (3) after the 3D bioprinting, GelMA samples cured with Irgacure 2959 have slightly larger pore size, faster degradation rate, and greater swelling ratio compared to those cured with LAP; (4) 3D GelMA-based vascular-like constructs have been fabricated using dynamic optical projection stereolithography, and the measured dimensions have been compared with the designed dimensions showing good shape fidelity.

Hydrogels have been widely used as extracellular matrix materials in various three-dimensional bioprinting applications. However, they possess limitations such as insufficient mechanical integrity and strength, especially in the vascular applications requiring suture retention and tolerance of systemic intraluminal pressure. Interpenetrating network hydrogels are unique mixtures of two separate hydrogels with enhanced properties. This paper has demonstrated the fabrication of three-dimensional cellular constructs based on gelatin methacrylate–alginate interpenetrating network hydrogels using a microgel-assisted bioprinting method. Filament formation was investigated in terms of the filament diameter under different nozzle speed and dispensing pressure, and a phase diagram to identify the optimal conditions for continuous and uniform filaments was prepared. Three-dimensional hollow cellular constructs were fabricated and the cell viability was 75% after 24-hour incubation. The post-printing properties were characterized including mechanical properties, degradation and swelling properties, and pore size. The interpenetrating network hydrogels with different concentrations were compared with their individual components. It is found that the interpenetrating network hydrogels exhibit stronger mechanical properties, faster degradation and larger pore sizes than their individual components.

Gelatin methacrylate (GelMA) has been gaining popularity in recent years as a photo-crosslinkable biomaterial widely used in a variety of bioprinting and tissue engineering applications. Several studies have established the effects of process-based and material-based parameters on the physical–mechanical properties and microstructure of GelMA hydrogels. However, the effect of encapsulated cells on the physical–mechanical properties and microstructure of GelMA hydrogels has not been fully understood. In this study, 3T3 fibroblasts were encapsulated at different cell densities within the GelMA hydrogels and incubated over 96 h. The effects of encapsulated cells were investigated in terms of mechanical properties (tensile modulus and strength), physical properties (swelling and degradation), and microstructure (pore size). Cell viability was also evaluated to confirm that most cells were alive during the incubation. It was found that with an increase in cell density, the mechanical properties decreased, while the degradation and the pore size increased.

No abstract

No abstract