Mixed copper nanocomposite, Cu/CuO–rGO is prepared through a novel one-step oxidation-reduction reaction between aqueous graphene oxide (GO) and copper(ii) chloride (CuCl2) solutions at ambient temperature and pressure.

This paper presents a flexible and reliable chemiresistor-type NO 2 gas sensor based on single-walled carbon nanotubes (SWNTs) on polytetrafluoroethylene (PTFE) membrane filter substrates. The sensor is realized by using a cost-effective spray coating in the preparation of SWNTs thin film, followed by the fabrication of metal contacts using a shadow mask and polyethyleneimine (PEI) noncovalent functionalization of the SWNTs. This showed a high sensitivity to NO 2 gas at room temperature in dry air; 21.58% to 167.7% for concentrations of 0.75 ppm to 5 ppm, and was almost nonsensitive to ammonia. Gas sensing characterization results, obtained for various substrate bending/wrapping over different cylinders with diameters of 75 mm, 12.5 mm, and 6 mm showed that bending does not significantly affect sensitivity for NO 2 concentrations of 0.75 ppm to 2 ppm, while in the case of 3 ppm to 5 ppm NO 2 , the bent samples indicate enhanced sensitivity. This is probably because of the porous nature of PTFE substrates; these sensors were 1.5 to 2.7 times more sensitive than those fabricated over silicon substrate for 1 ppm and 5 ppm, respectively. Moreover, the relative humidity of 10% and 30% significantly reduced the sensitivity of the sensors. The presented results could be useful for the future development of flexible electronics/sensors for monitoring outdoor air quality and for the detection of volatile organic compounds.

Metal nanoparticles have been helpful in creatinine sensing technology under point-of-care (POC) settings because of their excellent electrocatalyst properties. However, the behavior of monometallic nanoparticles as electrochemical creatinine sensors showed limitations concerning the current density in the mA/cm2 range and wide detection window, which are essential parameters for the development of a sensor for POC applications. Herein, we report a new sensor, a reduced graphene oxide stabilized binary copper–iron oxide-based nanocomposite on a 3D printed Ag-electrode (Fe–Cu–rGO@Ag) for detecting a wide range of blood creatinine (0.01 to 1000 μM; detection limit 10 nM) in an electrochemical chip with a current density ranging between 0.185 and 1.371 mA/cm2 and sensitivity limit of 1.1 μA μM–1 cm–2 at physiological pH. Interference studies confirmed that the sensor exhibited no interference from analytes like uric acid, urea, dopamine, and glutathione. The sensor response was also evaluated to detect creatinine in human blood samples with high accuracy in less than a minute. The sensing mechanism suggested that the synergistic effects of Cu and iron oxide nanoparticles played an essential role in the efficient sensing where Fe atoms act as active sites for creatinine oxidation through the secondary amine nitrogen, and Cu nanoparticles acted as an excellent electron-transfer mediator through rGO. The rapid sensor fabrication procedure, mA/cm2 peak current density, a wide range of detection limits, low contact resistance including high selectivity, excellent linear response (R 2 = 0.991), and reusability ensured the application of advanced electrochemical sensor toward the POC creatinine detection.