The hot-wall metal-organic chemical vapor deposition (MOCVD), previously shown to enable superior III-nitride material quality and high performance devices, has been explored for Mg doping of GaN. We have investigated the Mg incorporation in a wide doping range ([Formula: see text] cm−3 up to [Formula: see text] cm−3) and demonstrate GaN:Mg with low background impurity concentrations under optimized growth conditions. Dopant and impurity levels are discussed in view of Ga supersaturation, which provides a unified concept to explain the complexity of growth conditions impact on Mg acceptor incorporation and compensation. The results are analyzed in relation to the extended defects, revealed by scanning transmission electron microscopy, x-ray diffraction, and surface morphology, and in correlation with the electrical properties obtained by Hall effect and capacitance–voltage (C–V) measurements. This allows to establish a comprehensive picture of GaN:Mg growth by hot-wall MOCVD providing guidance for growth parameters optimization depending on the targeted application. We show that substantially lower H concentration as compared to Mg acceptors can be achieved in GaN:Mg without any in situ or post-growth annealing resulting in p-type conductivity in as-grown material. State-of-the-art [Formula: see text]-GaN layers with a low resistivity and a high free-hole density (0.77 [Formula: see text] cm and [Formula: see text] cm[Formula: see text], respectively) are obtained after post-growth annealing demonstrating the viability of hot-wall MOCVD for growth of power electronic device structures.

We have investigated insulator-semiconductor interface fixed charges in AlGaN/GaN metal-insulator-semiconductor (MIS) devices with Al2O3 or AlTiO (an alloy of Al2O3 and TiO2) gate dielectrics obtained by atomic layer deposition on AlGaN. Analyzing insulator-thickness dependences of threshold voltages for the MIS devices, we evaluated positive interface fixed charges, whose density at the AlTiO/AlGaN interface is significantly lower than that at the Al2O3/AlGaN interface. This and a higher dielectric constant of AlTiO lead to rather shallower threshold voltages for the AlTiO gate dielectric than for Al2O3. The lower interface fixed charge density also leads to the fact that the two-dimensional electron concentration is a decreasing function of the insulator thickness for AlTiO, whereas being an increasing function for Al2O3. Moreover, we discuss the relationship between the interface fixed charges and interface states. From the conductance method, it is shown that the interface state densities are very similar at the Al2O3/AlGaN and AlTiO/AlGaN interfaces. Therefore, we consider that the lower AlTiO/AlGaN interface fixed charge density is not owing to electrons trapped at deep interface states compensating the positive fixed charges and can be attributed to a lower density of oxygen-related interface donors.

Using aluminum titanium oxide (AlTiO, an alloy of Al2O3 and TiO2) as a high-k gate insulator, we fabricated and investigated AlTiO/AlGaN/GaN metal-insulator-semiconductor heterojunction field-effect transistors. From current low-frequency noise (LFN) characterization, we find Lorentzian spectra near the threshold voltage, in addition to 1/f spectra for the well-above-threshold regime. The Lorentzian spectra are attributed to electron trapping/detrapping with two specific time constants, ∼25 ms and ∼3 ms, which are independent of the gate length and the gate voltage, corresponding to two trap level depths of 0.5–0.7 eV with a 0.06 eV difference in the AlTiO insulator. In addition, gate leakage currents are analyzed and attributed to the Poole-Frenkel mechanism due to traps in the AlTiO insulator, where the extracted trap level depth is consistent with the Lorentzian LFN.

We have systematically investigated low-frequency noise (LFN) in AlN/AlGaN/GaN metal-insulator-semiconductor (MIS) devices, where the AlN gate insulator layer was sputtering-deposited on the AlGaN surface, in comparison with LFN in AlGaN/GaN Schottky devices. By measuring LFN in ungated two-terminal devices and heterojunction field-effect transistors (HFETs), we extracted LFN characteristics in the intrinsic gated region of the HFETs. Although there is a bias regime of the Schottky-HFETs in which LFN is dominated by the gate leakage current, LFN in the MIS-HFETs is always dominated by only the channel current. Analyzing the channel-current-dominated LFN, we obtained Hooge parameters α for the gated region as a function of the sheet electron concentration ns under the gate. In a regime of small ns, both the MIS- and Schottky-HFETs exhibit α∝ns−1. On the other hand, in a middle ns regime of the MIS-HFETs, α decreases rapidly like ns−ξ with ξ ∼ 2-3, which is not observed for the Schottky-HFETs. In addition, we observe strong increase in α∝ns3 in a large ns regime for both the MIS- and Schottky-HFETs.

We have systematically investigated low-frequency noise (LFN) in InAs films with several thicknesses (≃10-100 nm) bonded on low-k flexible substrates (InAs/FS), comparing with that in InAs films epitaxially grown on GaAs(001) substrates (InAs/GaAs). We obtain current LFN spectra exhibiting approximate 1/f characteristics and consequent effective Hooge parameters α depending on the thickness, where we find that α in the InAs/FS is larger than that in the InAs/GaAs. The behavior of α can be attributed to the fluctuation of the electron mobility dominated by surface/interface charge scattering and by thickness fluctuation scattering.