Concentrations of polybrominated diphenyl ethers (PBDEs) and other brominated flame retardants (BFRs) have been rapidly increasing in fish, birds, sediments, indoor environments, and humans, but emission sources and exposure pathways of these pollutants remain poorly understood. The many BFR-containing materials in buildings constitute a large reservoir of these compounds, and in-use releases from this reservoir may be a significant environmental source. To estimate in-use releases from building materials and contents in residences, we monitored 12 houses and garages in two seasons and combined measurements of BFRs in air and settled dust, air exchange rates, and other information in an approach that utilized the building as a "natural" test chamber. Results were scaled to provide a first estimate of aggregate emission rates from U.S. houses. PBDE releases total about 4 microg h(-1) per house or 20 ng m(-2) h(-1), and U.S. houses and garages collectively release about 4100 kg y(-1). Most of these releases are settled floor dust, but about 20% are released directly to the ambient environment via airborne vapor and particulate matter. These screening-level estimates are subject to considerable uncertainty, but they have an advantage in that they reflect real-world conditions based on mass balance calculations.

Brominated flame retardants (BFRs) are now ubiquitous contaminants with large reservoirs and high concentrations in buildings. Most of the information documenting BFR levels has been obtained in residences, and other environments that can lead to exposure have received relatively little attention, including offices that contain numerous BFR sources and where individuals spend considerable time. The aim of this study is to characterize BFR concentrations, potential emission sources, and migration pathways in office environments. We measure BFR levels in floor dust, indoor air, ventilation filter dust, and carpets in ten commercial and institutional buildings in Michigan, U.S.A. The median concentration of total BDEs in settled dust was 8754 ng g−1, at the upper range of levels previously reported. Especially elevated levels were found in offices in buildings that contained known or likely BFR sources, e.g., computer servers. A trends analysis in a newly constructed building showed remarkable increases in concentrations of BFRs in settled dust and indoor air, and apparent steady-state levels were reached 5 to 8 months after building completion, a particularly striking finding given that the building was constructed and furnished several years after the voluntary phase-out of the penta- and octa-mixtures. Airborne particulate matter collected in a building's HVAC system filters contained PBDEs, including BDE-209, at levels exceeding the concentration of floor dust. In conjunction with estimates of building air flow rates, filter efficiency and other parameters, mass balance calculations for this building were used to estimate the emission rates and reservoirs of PBDEs. The widespread distribution of BFRs found in offices in both new and old buildings suggests the significance of workplace exposures, the need for controls to minimize human exposure, intra-building migration, and environmental releases of these chemicals, and the need for monitoring in new buildings to confirm the effectiveness of the PBDE phase-out.

Emissions of particulate matter (PM) and a broad suite of target volatile organic compounds (VOCs) in total, main-stream (MS) and side-stream (SS) smoke emissions are measured for six types of commercial cigarettes. The suitability of 2,5-dimethyl furan (DMF) as a tracer for environmental tobacco smoke (ETS) is investigated using laboratory results and a field study of 47 residences. Over 30 VOCs were characterized in cigarette smoke, including several that have not been reported previously. "regular tar", "low tar", menthol, and nonmenthol cigarettes showed only minor differences in PM and VOC emissions. When total emissions are considered, PM emissions averaged 18 +/- 2 mg cigarette(-1) and VOC emissions averaged 3644 +/- 160 mg cigarette(-1). DMF appears to satisfy all requirements for a tracer, namely, uniqueness, detectability, similar emission factors across tobacco products (211 +/- 16 microg cigarette(-1)), consistent proportions to other ETS compounds, and behavior similar to other ETS components in relevant environments. On the basis of field study results, DMF more reliably indicated smoking status than occupant-completed questionnaires, and cigarette smoking was responsible for significant fractions of benzene (50%), styrene (49%), and other VOCs in the smoker's homes.

Poultry litter is used on agricultural land because of its high nutrient content. The litter contains trace elements. With land application of litter, these elements may accumulate in the soil or plants, may be transported as run-off to surface water, or may be leached into groundwater. The objective of this research was to measure the concentrations of trace elements in soils fertilized with poultry litter. Soil was collected from three agricultural farms in Wicomico County, MD. These farms had a long history of poultry litter application. A nitric acid extraction was performed on soil samples collected to a depth of 60 cm. The concentrations of As, Cd, Cu, Mn, Pb, and Zn were determined using atomic absorption spectrophotometry. Arsenic, Cd, Cu, and Mn concentrations were higher in the manured fields than in the control fields. Lead and Zn concentrations did not significantly change with the application of poultry litter.