Designing a spectrometer without the need for wavelength multiplexing optics can effectively reduce the complexity and physical footprint. On the basis of the computational spectroscopic strategy and combining a broadband-responsive dynamic detector, we successfully demonstrate an optics-free single-detector spectrometer that maps the tunable quantum efficiency of a superconducting nanowire into a matrix to build a solvable mathematical equation. Such a spectrometer can realize a broadband spectral responsivity ranging from 660 to 1900 nm. The spectral resolution at the telecom is sub-10 nm, exceeding the energy resolving capacity of existing infrared single-photon detectors. Meanwhile, benefiting from the optics-free setup, precise time-of-flight measurements can be simultaneously achieved. We have demonstrated a spectral LiDAR with eight spectral channels. This spectrometer scheme paves the way for applying superconducting nanowire detectors in multifunctional spectroscopy and represents a conceptual advancement for on-chip spectroscopy and spectral imaging.
Piezoelectric response of P(VDF-TrFE), which is modulated by the dipole density due to the polarization switching on applying an electric field, allows it act as the fundamental components for electromechanical systems. As proposed since the 1970s, its polar α-phase is supposed to yield an enhanced piezoelectric activity. However, its experimental verification has never been reported, hampered by a substantial challenge for the achievement of a smooth, neat α-phase film. Here, we prepare ultrathin crystalline α-phase P(VDF-TrFE) films on the AlOx/Al-coated SiO2/Si substrates via a solution-based approach at room temperature. Thus, we unveil the piezoelectric nature of the polar α-phase P(VDF-TrFE) at a quasi-two-dimensional limit. The obtained values of the relative morphological deformation, the local effective piezoelectric coefficient, and the electric field-induced strain reach up to 37 pm, −46.4 pm V−1, and 4.1%, respectively. Such a robust piezoelectric response is even higher than that of the β-phase. Besides, the evolution of piezoelectricity, which is related to the piezoelectric properties of two polarization states, is also studied. Our work can enable the exploration of the prospective applications of polar α-phase P(VDF-TrFE) films.
The niobium nitride (NbN) nanowires fabricated with the high-quality ultra-thin NbN film with a thickness of 3 nm-6 nm were widely used for single photon detectors. These nanowires had a low aspect ratio, less than 1:20. However, increasing the thickness and the aspect ratio of highly-uniformed NbN nanowires without reducing the superconductivity is crucial for the device in detecting high-energy photons. In this paper, a high-quality superconducting nanowire with aspect ratio of 1:1 was fabricated with optimized process, which produced a superconducting critical current of 550 μA and a hysteresis of 36 μA at 2.2 K. With the optimization of the electron beam lithography process of AR-P6200.13 and the adjustion of the chamber pressure, the discharge power, as well as the auxiliary gas in the process of reactive ion etching (RIE), the meandered NbN nanowire structure with the minimum width of 80 nm, the duty cycle of 1:1 and the depth of 100 nm were finally obtained on the silicon nitride substrate. Simultaneously, the sidewall of nanowire was vertical and smooth, and the corresponding depth-width ratio was more than 1:1. The fabricated NbN nanowire will be applied to the detection of soft X-ray photon emitted from pulsars with a sub-10 ps time resolution. Niobium nitride (NbN) has been widely studied in superconductor electronics for high superconducting transition temperature (up to 16 K), critical current density and critical magnetic field 1. Moreover, the corresponding physical properties were stable, and it could have large scale with high quality. Also, it was the most common materials to fabricate the superconducting nanowire single-photon detectors (SNSPDs) 2,3 , the mixer of Terahertz wave detection hot-electron-bolometer (HEB) 4 , and the superconducting quantum interference device (SQUID). At present, the preparation of SNSPDs mainly use the epitaxial method to grow the high-quality ultra-thin NbN film with a thickness of 3-6 nm. Then, the film is prepared to the meandered nanowire structure by means of micro-nano processing. The width of NbN nanowire is about 100 nm, and the aspect ratio is generally lower than 1:20. Considering the advantages of SNSPDs, such as the low dark count, the wide response spectrum, the short recovery time and the high time precision, SNSPDs were widely studied and applied to the detection of visible/ infrared single photon 5. However, the application of SNSPDs in the direction of high-energy photon (UV, X-ray, and gamma ray) was rarely studied for low absorption of ultra-thin NbN films with the high-energy photons 6-8. Through Geant4 simulations, we obtained that the X-ray photon absorption of the 10 nm thick NbN film for 1 keV and 6 keV was only 3.69% and 0.23%, respectively 9 , and the SNSPD prepared with the ultra-thin NbN film was unable to effectively detect high-energy single photons. The simulation results show that the absorption of 1 keV and 6 keV by NbN with a 100 nm film thickness are 31.31% and 2.25%, respectively. To improve the absorption of superconducting NbN...
Laser communication using photons should consider not only the transmission environment’s effects, but also the performance of the single-photon detector used and the photon number distribution. Photon communication based on the superconducting nanowire single-photon detector (SNSPD) is a new technology that addresses the current sensitivity limitations at the level of single photons in deep space communication. The communication’s bit error rate (BER) is limited by dark noise in the space environment and the photon number distribution with a traditional single-pixel SNSPD, which is unable to resolve the photon number distribution. In this work, an enhanced photon communication method was proposed based on the photon number resolving function of four-pixel array SNSPDs. A simulated picture transmission was carried out, and the error rate in this counting mode can be reduced by 2 orders of magnitude when compared with classical optical communication. However, in the communication mode using photon-enhanced counting, the four-pixel response amplitude for counting was found to restrain the communication rate, and this counting mode is extremely dependent on the incident light intensity through experiments, which limits the sensitivity and speed of the SNSPD array’s performance advantage. Therefore, a BER theoretical calculation model for laser communication was presented using the Bayesian estimation algorithm in order to analyze the selection of counting methods for information acquisition under different light intensities and to make better use of the SNSPD array’s high sensitivity and speed and thus to obtain a lower BER. The counting method and theoretical model proposed in this work refer to array SNSPDs in the deep space field.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.