Because of the atomic thinness of graphene, its integration into a device will always involve its interaction with at least one supporting substrate, making the surface energy of graphene critical to its real-life applications. In the current paper, the contact angle of graphene synthesized by chemical vapor deposition (CVD) was monitored temporally after synthesis using water, diiodomethane, ethylene glycol, and glycerol. The surface energy was then calculated based on the contact angle data by the Fowkes, Owens-Wendt (extended Fowkes), and Neumann models. The surface energy of fresh CVD graphene grown on a copper substrate (G/Cu) immediately after synthesis was determined to be 62.2 ± 3.1 mJ/m(2) (Fowkes), 53.0 ± 4.3 mJ/m(2) (Owens-Wendt) and 63.8 ± 2.0 mJ/m(2) (Neumann), which decreased to 45.6 ± 3.9, 37.5 ± 2.3, and 57.4 ± 2.1 mJ/m(2), respectively, after 24 h of air exposure. The ellipsometry characterization indicates that the surface energy of G/Cu is affected by airborne hydrocarbon contamination. G/Cu exhibits the highest surface energy immediately after synthesis, and the surface energy decreases after airborne contamination occurs. The root cause of intrinsically mild polarity of G/Cu surface is discussed.

No abstract

Graphene-covered copper surfaces have been exposed to borazine, (BH) 3 (NH) 3 , with the resulting surfaces characterized by low-energy electron microscopy. Although the intent of the experiment was to form hexagonal boron nitride (h-BN) on top of the graphene, such layers were not obtained. Rather, in isolated surface areas, h-BN is found to form m-size islands that substitute for the graphene. Additionally, over nearly the entire surface, the properties of the layer that was originally graphene is observed to change in a manner that is consistent with the formation of a mixed h-BN/graphene alloy, i.e. h-BNC alloy. Furthermore, following the deposition of the borazine, a small fraction of the surface is found to consist of bare copper, indicating etching of the overlying graphene. The inability to form h-BN layers on top of graphene is discussed in terms of the catalytic behavior of the underlying copper surface and the decomposition of the borazine on top of the graphene. FIG 7. (a) LEEM image of graphene sample exposed to borazine at 900C, acquired with sample voltage of 9.0 V. (b) Reflectivity spectra, extracted from the points indicated in the image.

No abstract

No abstract