Purpose This study aims to capture the heat transfer and entropy generation characteristics of temperature-dependent nano-encapsulated phase change material (NEPCM) slurry in a hybrid wavy microchannel. In addition, the effect of substrate material combined with NEPCM slurry on conjugate heat transfer condition is captured for different microchannel heat sinks. Design/methodology/approach A novel “hybrid wavy microchannel” is proposed to enhance the overall heat transfer and reduce the pressure drop by combining wavy and raccoon geometry. NEPCM–water slurry is implied in the hybrid wavy, conventional wavy and raccoon microchannel. A user-defined function (UDF) is used to observe the effect of phase-change of paraffin material in thermophysical properties of NEPCM–water nanofluid. All three (hybrid, wavy, raccoon) microchannels are engraved on a rectangular substrate of 1.8 mm width (ωs) and 30 mm length (L), respectively. For hybrid, wavy and raccoon microchannel, waviness (γ) of 0.067 is selected for the investigation. Findings The result shows that NEPCM particle presence reduces the fluid domain temperature. The thermal performance of proposed Heat sink 2 is found better than the Heat sink 1. The effect of the geometrical modification, wall thermal conductivity, different volumetric concentrations of nanoparticles (ϕ ∼ 1 – 5%) and Reynolds number (Re ∼ 100 – 500) on thermodynamic irreversibility is also observed. Additionally, the effect of thermal and frictional entropy generation is reduced with a combination of NEPCM slurry and higher conductive material for all heat sinks. Practical implications A combination of NEPCM slurry with laminar flow microchannel cooling system emerged as a better alternative over other cooling techniques for higher power density devices such as microprocessors, electronic radar systems, aerospace applications, semiconductors, power electronics in modern electronic vehicles, high power lasers, etc. Originality/value The phase-change process of the NEPCM slurry is tracked under conjugate heat transfer in a hybrid wavy microchannel. Furthermore, the phase-change process of NEPCM slurry is captured with different heat sink materials (SS316, silicon and copper) under conjugate heat transfer situation for different heat sinks and concentrations (ϕ ∼ 1–5) of NEPCM.

No abstract

Less than 3% of 145 million blind people in developing countries at present are literate [1]. At present, in most of the cases, speech output has been the medium for blind people to access materials. For content which require deep understanding such as technical texts etc., it is not an appropriate modality, moreover blind people are more accustomed to braille transcripts and adaptability issues to all audio resources is difficult. And thus, arises the need for a cheap, easily adaptable, less complex solution to the problem. Braille points are varied arrangements of raised dots representing characters which are identified by touch by visually impaired people. Here we discuss in detail, development of a dynamic/refresh-able Braille display which presents Braille points by the up-and-down movement of pins using a completely new, first of its kind, Cam actuated mechanism with just two actuation points instead of a standard 6 used by every single refresh-able braille board in the world at present. Two nested shafts having 8 arrays of precisely calculated and placed cam, each were responsible for keeping the pins in up and down state. The shafts were actuated using two micro-servo motors placed next to each other. X degree rotation of servo after transmission through gear and subsequently shaft resulted in a particular configuration. Henceforth calibration was done so that all braille alphabet could be produced with specific servo rotations.